Advantech PCE-3029 Manual de instalación y operación
PCE-3029/PCE-4129 Startup Manual 1
Before you begin installing your card, please make sure that
the following items have been shipped:
1. 1 x PCE-3029 or 4129 PICMG 1.3 System Host Board
2. 1 x CD with utility
3. 1 x PCE-3029/PCE-4129 Startup Manual
4. 1 x Serial ATA HDD data cable
5. 1 x Serial ATA HDD power cable
6. 1 x 2-port COM cable kit
7. 1 x 4-port USB 2.0 cable kit
8. 1 x 2-port USB 3.0 cable kit
9. 1 x Power converter (Connecting from peripheral power
connector on power supply to PWR1 on board)
10. 1 x Keyboard and mouse Y cable
11. 1 x Jumper package
12. 1 x Warranty card
If any of these items are missing or damaged, please con-
tact your distributor or sales representative immediately.
Note 1: For detailed contents of PCE-3029/PCE-4129,
please refer to information on the enclosed CD-
ROM (in PDF format).
PCE-3029/PCE-4129 LGA1151 Intel®Xeon®,
Core™ i7/i5/i3/Celeron®/Pentium®PICMG1.3 Half-size
System Host Board with DDR4/Dual GbE LAN
Startup Manual
General
• CPU: LGA1151-socket Core™ i7/i5/i3, Pentium® and
Xeon® E3-1200v5 series processors
Note: Only PCE-4129 supports Intel® Xeon® processors.
• L2 cache: Please refer to CPU specication for detailed
information.
• BIOS: AMI SPI BIOS (128 Mb SPI)
• System chipset: Intel® C236 (PCE-4129); Intel® H110
(PCE-3029)
• System memory:
- PCE-4129: Up to 32 GB in two 260-pin SODIMM sock-
ets. Supports dual-channel DDR4 1866/2133 SDRAM
with or without ECC function.
- PCE-3029: Up to 32 GB in two 260-pin SODIMM sock-
ets. Supports dual-channel DDR4 1866/2133 SDRAM
without ECC function.
• SATA hard disk drive interface: PCE-3029 sup-
ports three SATA 3.0 ports without RAID function, and
PCE-4129 supports four SATA 3.0 ports with SW RAID
0,1,5,10.
• Serial ports: Two RS-232 serial ports
• Keyboard/mouse connector: Supports one external
6-pin header
• Watchdog timer: Programmable 1~255 sec
• USB: USB 3.0 x 3, USB 2.0 x 7
• GPIO: One programmable 8-bit GPIO pin-header
Display
• Chipset: Intel®HD Graphics embedded in the processor
Ethernet Interface
• Chipset supports:
-
LAN 1: Intel
®
I219V (PCE-3029) and I219LM (PCE-4129).
- LAN 2: Intel
®
I210AT (PCE-3029) and I210AT (PCE-4129).
• Connection: 2 x on-board RJ-45 connectors with LED
indicators
Mechanical and Environmental
• Dimensions: (L x W): 167.64 x 126.39 mm
• Power supply voltage: +3.3 V, +5 V, +12 V, 5 V
SB
• Power requirements:
PCE-3029:
Intel® Core™ i7-6700 (3.4GHz), DDR4 2133 8GB * 2
Voltage 12V 5V 3.3V 5VSB -12V -5V
Current (A) 4.6 0.01 0.32 0.08 0 0
Specications
Packing List
For more information on this and other Advantech
products, please visit our website at:
http://www.advantech.com
http://www.advantech.com/eplatform
For technical support and service, please visit our
support website at:
http://support.advantech.com.tw/support/default.
aspx
This manual is for the PCE-3029/PCE-4129 Series
Rev. B3.
Part No. 2001302911
Printed in China
2nd Edition
October 2022
2 PCE-3029/PCE-4129 Startup Manual
PCE-4129:
E3-1225 v5 (3.30GHz), DDR4 2133 8GB *2
Voltage 12V 5V 3.3V 5VSB -12V -5V
Current (A) 4.6 0.01 0.32 0.08 0 0
• Operating temperature: 0 ~ 60 °C (depending on CPU)
• Weight: 0.33 kg (weight of board)
The board has a number of jumpers that allow you to congure
your system to suit your application. The table below lists the
function of each of the jumpers and connectors.
Connectors
Label Function
LPT1 Parallel port, supports SPP/EPP/ECP
mode
LAN1 PCE-3029: Intel® I219V
PCE-4129: Intel® I219LM
LAN2 PCE-3029: Intel® I210AT
PCE-4129: Intel® I210AT
VGA1 VGA connector
KBMS1 External keyboard/mouse connector
COM12 Box header for RS-232*2
FP1 HDD LED, power LED, SNMP SM_Bus,
reset, power on/o
JCASE1 Case open
CPUFAN1 CPU FAN connector (4-pin)
LANLED1 LAN1/2 LED connector
HDAUD1 HD audio extension module connector
USB1 USB port 1 (USB 3.0 port)
USB23 USB port 2, 3 (USB 3.0 port)
USB45 USB port 4, 5 (USB 2.0)
USB67 USB port 6, 7 (USB 2.0)
USB89 USB port 8, 9 (USB 2.0)
USB11 Type A connector on board (USB 2.0)
SATA0 Serial ATA1 (SATA 3.0)
SATA1 Serial ATA2 (SATA 3.0)
SATA2 Serial ATA3 (SATA 3.0)
SATA3 Serial ATA4 (PCE-4129: 3.0)
CPU1 CPU Socket
DIMMA1 Memory connector channel A
DIMMB1 Memory connector channel B
GPIO1 GPIO pin header
LPC1 Low pin count module expansion pin-
header
PWR1 12 V, 5 V power connector
DVI1
DVI connector
DP1
Display pin header to stack board
(Display type depends on optional stack
board)
EXPCIE1 Mini PCIe pin header to stack board
MINIPCIE MSATA
M-SATA (default) or Mini PCIe connec-
tor (optional for PCE-4129)
Jumpers
Label Function
JCMOS1 CMOS clear
JWDT1+JOBS1 Hardware monitor alarm+watchdog
timer output selection
JME1 Enable ME
JCMOS1: Clear CMOS
Closed Pins Result
1-2 Keep CMOS (Default)
2-3 Clear CMOS
JOBS1+JWDT1: Hardware monitor alarm+watchdog
timer output selection
Function Jumper Setting
2-3 Enable watchdog timer (Default)
4-5 Enable Hardware monitor alarm
(Default)
JME1: Enable ME
Closed Pins Result
1-2 Enable ME
(Default)
2-3 Disable ME
1 2 3 4 5
123
Jumpers and Connectors
Specications
(Cont.)
Jumpers and Connectors (Cont.)
PCE-3029/PCE-4129 Startup Manual 3
The drivers for the PCE-3029 are located on the software
installation CD. Please click through the folder and follow
the on-screen instructions to install them.
Caution! The computer is supplied with a battery-powered
real-time clock circuit. There is a danger of
explosion if the battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer. Discard
used batteries according to the manufacturer’s
instructions.
This device complies with the requirements in Part 15 of
the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference;
2. This device must accept any interference received,
including interference that may cause undesired opera-
tion.
Software Installation
Declaration of Conformity
Board Layout
Board Layout: Jumper and Connector Locations
DIMM B1
DIMM A1
PWR1 FP1 USB45
USB89
USB11
CPU FAN1
USB67
USB1
LAN2
LAN1
BIOS SPI1
VGA1
DVI1
PCH: C236
DP1
JCASE1
LPC1
GPIO1
LGA1151
USB23
SATA0 SATA1
SATA3 SATA2
EXPCIE1
LAN LED1
KBMS1
HDAUD1
COM12
JWDT1 JOBS1
JCOMS1
JME1
4 PCE-3029/PCE-4129 Startup Manual
To power on PCE-3029/PCE-4129 with backplanes, please ensure that the below connectors and jumpers are correctly con-
nected and chosen.
How to Power on PCE-3029/PCE-4129
PWR1
Cable: 1703040100
PSON1
123
123
PSON1: ATX/AT Mode Selection
Jumper Setting Function
1-2 AT mode
2-3 (Default) ATX mode
Otros manuales para PCE-3029
1
Este manual sirve para los siguientes modelos
1
Otros manuales de Hardware de computadora de Advantech
Advantech
Advantech AMAX-5070 Manual de usuario
Advantech
Advantech AIMB-219 Manual de usuario
Advantech
Advantech ECU-150 Series Manual de usuario
Advantech
Advantech PCA-6185 Manual de usuario
Advantech
Advantech MIC-3332 Manual de usuario
Advantech
Advantech AIMB-278 Manual de usuario
Advantech
Advantech PCL-746+ Manual de usuario
Advantech
Advantech PCL-818L Manual de usuario
Advantech
Advantech HPC-7420 Manual de usuario
Advantech
Advantech PCA-6114P7 Manual de instalación y operación
Advantech
Advantech PCA-6148 Manual de usuario
Advantech
Advantech FWA-3033-00A1R Manual de instalación y operación
Advantech
Advantech ECU-P1628D Manual de instalación y operación
Advantech
Advantech UNO-1251G Manual de usuario
Advantech
Advantech PCL-841 Series Manual de usuario
Advantech
Advantech MIC-75M11 Manual de instalación y operación
Advantech
Advantech PCIE-1730H Manual de usuario
Advantech
Advantech ACP-7000 Manual de usuario
Advantech
Advantech MIO-5270 Manual de instalación y operación
Advantech
Advantech PPC-3151 Manual de usuario
Manuales populares de Hardware de computadora de otras marcas
EMC2
EMC2 VNX Series Manual del propietario
Panasonic
Panasonic DV0PM20105 Manual de usuario
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Manual de usuario
Gigabyte
Gigabyte B660M DS3H AX DDR4 Manual de usuario
Raidon
Raidon iT2300 Manual de usuario
National Instruments
National Instruments PXI-8186 Manual de usuario
