ZyXEL Communications P-660HWP-D1 Manual de usuario

P-660HWP-Dx

802.11g HomePlug AV ADSL2+ Gateway

Quick Start Guide

Version 3.40

7/2007

Edition 1

P-660HWP-Dx Quick Start Guide

Overview

The P-660HWP-Dx is a gateway which combines high-speed ADSL Internet access, a

built-in switch, a firewall, and HomePlug AV and high-speed wireless networking

capability.

The figure below shows the P-660HWP-Dx connecting devices via a firewalled DSL

connection to the Internet through:

• standard electrical wiring and HomePlug AV adapters (“A”)

• wireless

• direct, wired connections using the P-660HWP-Dx’s built-in switch.

The P-660HWP-Dx is also a firewall, providing greater security for your local network(s).

This Quick Start Guide shows you the most common settings for connecting to the

Internet, configuring your wireless settings and setting up your HomePlug AV network.

For more information on all features see your User’s Guide on the CD that came in the

package.

To read the User’s Guide insert the CD that came in the box into your CD-ROM drive. A

screen should pop up. Navigate to the User’s Guide from this screen. If a screen does not

pop up, open Windows Explorer (click My Computer), click on the CD-ROM drive (usually

drive D:) and navigate to it from there.

P-660HWP-Dx Quick Start Guide

1 Hardware Connections

1DSL: Use the gray telephone wire to connect your P-660HWP-Dx’s DSL port to a

telephone jack (or to the modem port on a splitter if you are using one).

2ETHERNET: Use the yellow Ethernet cable to connect a computer to an ETHERNET

port on the P-660HWP-Dx for initial configuration and/or Internet access.

3POWER: Use only the power cable that came in the package to connect your P-

660HWP-Dx to a power outlet. Make sure the power outlet is switched on. This socket

will also act as your HomePlug AV connection.

4Push in the POWER button.

5Look at the lights on the front panel.

•ThePOWER light (LED) blinks while your P-660HWP-Dx starts up and stays on once it is

ready.

•TheETHERNET, WLAN, DSL, INTERNET and POWERLINE LEDs turn on if the corre-

sponding connections are properly made.

VCheck your connections if an LED does not turn on. Then turn the P-

660HWP-Dx off, wait for a few seconds and turn it back on. See

Troubleshooting. If the problem remains, contact your local vendor.

2 Internet Connection Setup: Automatic

Use this section to have your P-660HWP-Dx automatically detect and set up your Internet

connection.

P-660HWP-Dx Quick Start Guide

1Open a browser such as Internet Explorer and go to your favorite website. Wait while

your P-660HWP-Dx tries to detect your DSL connection to your ISP. This may take a

few minutes.

2After it detects the connection, the DSL light shows green on your device and the

Internet light comes on when the Internet is ready for you to use. If you have a PPPoE

connection, you will have to enter your user name and password.

3Go to section 3 if you wish to configure your wireless settings using the wizard.

4If you do not see the connection test screen, or the connection test is not successful,

follow the instructions in the screen below, or check your connections and restart the P-

660HWP-Dx.

3 Internet and Wireless Setup Wizard

Use this wizard to connect to the Internet and configure your wireless settings

3.1 Log In to the Wizard

Default Login Information

1Open a browser such as Internet Explorer and enter the following URL address: http://

192.168.1.1

2Type the admin password 1234 (default). Click Login.

• If your browser does not display the login screen, see Troubleshooting for details.

3Type (and retype) a new password and click Apply. It is strongly recommended that

you change the P-660HWP-Dx’s password and write it down.

You have to use a new password other than the default password 1234.

IP address http://192.168.1.1

administrator password 1234

P-660HWP-Dx Quick Start Guide

4Enter your new password to log in again.

5Click Apply in the screen below to create a new certificate for your P-660HWP-Dx. This

screen will continue to appear until you apply this option.

6Select Go to Wizard setup in the screen below. Click Apply to access the Wizard.

3.2 Connect to the Internet Using the Wizard

1Click INTERNET/WIRELESS SETUP. The wizard autodetects your Internet connection.

• If the Internet connection test is successful, you are ready to use the Internet. Go to

section 3.3 if you wish to configure your wireless settings using the wizard.

• If no DSL connection is detected, see Troubleshooting.

• If no ISP settings are detected, click Next in the current screen to go to the screen

below.

2Enter your Internet connection information exactly as provided by your ISP in the

screen below and click Next.

P-660HWP-Dx Quick Start Guide

• If you do not see the screen below, or your ISP has given you Internet access set-

tings not available on this screen, see Troubleshooting.

3In the next screen, select either Obtain an IP Address Automatically or Static IP

Address. If you select Static IP Address then fill out the required fields based on the

information provided by your ISP and click Apply.

4If the Internet connection test is successful, either browse to your favorite website

(such as www.zyxel.com) or click Next on your screen to go to section 3.3 to configure

your wireless settings.

3.3 Configure your Wireless Settings Using the Wizard

To create a wireless network the P-660HWP-Dx and your wireless computer(s) must all

use the same SSID (network name), channel and security settings.

If you do not set wireless security then anyone within range could use your P-660HWP-Dx

to access your network and the Internet.

Choose WPA-PSK wireless security if your wireless device supports it as it is stronger than

WEP.

P-660HWP-Dx Quick Start Guide

1Select Active and click Next to continue. It is strongly recommended that Enable

OTIST is NOT selected. See the Users’ Guide for more information on OTIST.

2Configure your wireless settings in the screen displayed. Click Next.

3If you select either WEP or WPA-PSK security (recommended), then follow the directions

to enter the appropriate key. Click Next to continue and Apply to save your wireless LAN

settings.

4Check your configuration in the screen below and write down your wireless LAN settings

for later use.

P-660HWP-Dx Quick Start Guide

5Click Finish to complete and save the wizard setup. Your Internet connection is ready for

you to use. Open a browser such as Internet Explorer and navigate to a website.

4 Setting Up a Wireless Network

To set up a wireless network you need at least one wireless network card/adapter.

• If you have a desktop computer, use either a wireless USB adapter or a wireless PCI

adapter.

• If you have a laptop, use either a wireless USB adapter or a wireless CardBus card. These

are built into many laptops.

To add a computer to your network you need to configure your wireless-enabled computer

with the same SSID, channel and security settings as the P-660HWP-Dx.

Alternatively, use OTIST, ZyXEL's One-Touch Intelligent Security Technology (OTIST)

feature. It allows you to automatically configure the SSID and WPA-PSK on all OTIST-

equipped wireless clients within range of the P-660HWP-Dx. See the Wireless LAN

chapter in the Users’ Guide for more information on OTIST.

5 HomePlug AV Network Setup

Follow these steps to set up your HomePlug AV network on standard electrical wiring with

a new password.

1Plug your P-660HWP-Dx and other HomePlug AV devices into power outlets and turn

them on. Your P-660HWP-Dx will try to detect other HomePlug AV devices on the

same electrical wiring.

2Check the POWERLINE ( ) LED for a HomePlug AV connection.

• If the LED does not display, your device has a problem detecting another HomePlug AV

device. Go to Troubleshooting for more information.

• If the LED light is green, the P-660HWP-Dx detects other HomePlug AV devices and you

are ready to set up your network.

You need to configure the power line settings of the P-660HWP-Dx, as well as the power

line settings of the other devices you wish to add to your network.

3Go to Network > Powerline > Local Setting to configure the P-660HWP-Dx’s power

line settings.

• Select Enable Powerline.

P-660HWP-Dx Quick Start Guide

• Type the Network Password for your network. This will connect you to other Home-

Plug AV devices which have the same password and allow you to configure them.

HomePlugAV is the default password for ZyXEL HomePlug AV devices.

• You do not need to type the Device Access Key (DAK) for the P-660HWP-Dx unless

you want to change it.

• Click Apply.

4Go to Network > Powerline > Remote Setting to make a new network with a new

Network Password and add the other HomePlug AV devices to your new network.

• Select a device listed in Remote Stations In The Same Network and type a new

Network Password.

• Type the Device Access Key (DAK) in the Login Remote Device Access Key field.

The DAK identifies each device. For ZyXEL HomePlug AV products the DAK is on

an attached label. Click Apply. The device disappears from the list of Remote Sta-

tions In The Same Network. With a different password it now is on a different net-

work.

• Repeat for all devices you want to add to your network.

5Go back to Network > Powerline > Local Setting to change your P-660HWP-Dx’s

Network Password to the new one and connect it to your new HomePlug AV network.

Type your new Network Password and click Apply.

6Check the other devices you selected previously are now on the list of Remote

Stations In The Same Network by going to Network > Powerline > Remote Setting. If

all devices are correctly listed, your HomePlug AV network is now ready for use.

P-660HWP-Dx Quick Start Guide

Troubleshooting

VIf you cannot access the web configurator check the following.

1Your computer may be set to use a static IP address in a different subnet from the

ZyXEL device. See the User’s Guide for information on setting up your IP address.

2If you are using Internet Explorer in Windows XP or Windows Server 2003, make sure

you allow pop-up windows, JavaScript and Java permissions or set the Internet security

level lower than High in Internet Explorer (in Internet Explorer, click Tools > Internet

Options > Security > Custom Level...). See the appendix in the User’s Guide for more

information.

VIf the Internet/Wireless Setup Wizard cannot detect a DSL connection

check the following.

1Check your connections and restart the device.

2Contact your ISP to check the status of your account.

VIf you do not see the ISP Parameters for Internet Access screen when you

run the Internet/Wireless Wizard, follow these steps.

1Log in to the P-660HWP-Dx’s web configurator. (See section 3.1.)

2Select Go to Advanced setup and click Apply.

3The Status screen appears. Click Network > WAN in the navigation panel on the left of

the screen.

4Ensure that the settings in this screen are the same as those your ISP gave you. If your

ISP gave you a static IP address to use, select Static IP Address in the IP Address

Otros manuales para P-660HWP-D1

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Puerta de ZyXEL Communications

ZyXEL Communications

ZyXEL Communications P-870HW-51A V2 Manual de usuario

ZyXEL Communications

ZyXEL Communications Broadband Security Gateway P-312 Manual de usuario

ZyXEL Communications

ZyXEL Communications VSG-1200 Manual de usuario

ZyXEL Communications

ZyXEL Communications SBG5500-A Manual de usuario

ZyXEL Communications

ZyXEL Communications ZyXEL ZyWALL 30W Manual de usuario

ZyXEL Communications

ZyXEL Communications SBG3300 series Manual de usuario

ZyXEL Communications

ZyXEL Communications ZyXEL ZyWALL 10W Manual de usuario

ZyXEL Communications

ZyXEL Communications P-870HW-I1 Manual de usuario

ZyXEL Communications

ZyXEL Communications P-662H Series Manual de usuario

ZyXEL Communications

ZyXEL Communications VMG4380-B10A Manual de usuario

ZyXEL Communications

ZyXEL Communications P-660HNU-F1 Manual del operador

ZyXEL Communications

ZyXEL Communications C1000Z Manual de usuario

ZyXEL Communications

ZyXEL Communications XMG3512-B10A Manual de usuario

ZyXEL Communications

ZyXEL Communications UAG Series Manual de usuario

ZyXEL Communications

ZyXEL Communications PMG5317-T20B Instrucciones de funcionamiento y mantenimiento

ZyXEL Communications

ZyXEL Communications AMG1202-T series Manual de usuario

ZyXEL Communications

ZyXEL Communications PX7511-B0 Manual de usuario

ZyXEL Communications

ZyXEL Communications VMG4825-B10A Manual de usuario

ZyXEL Communications

ZyXEL Communications VSG1432 Manual de usuario

ZyXEL Communications

ZyXEL Communications P-660H-61 Manual de usuario

ZyXEL Communications

ZyXEL Communications VMG4380-B10A Manual de usuario

ZyXEL Communications

ZyXEL Communications PPC 10 Manual de usuario

ZyXEL Communications

ZyXEL Communications LTE3301 Series Manual de usuario

ZyXEL Communications

ZyXEL Communications Prestige 314 PLUS Manual de usuario

Manuales populares de Puerta de otras marcas

LST

LST M500RFE-AS Manual de usuario

Kinnex

Kinnex Media Gateway Manual de usuario

2N Telekomunikace

2N Telekomunikace 2N StarGate Manual de usuario

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Manual de usuario

Telsey

Telsey CPVA 500 - SIP Manual de usuario

RTA

RTA 460A-NNA4 Hoja de especificaciones

Shaw

Shaw Gateway HDPVR Manual de usuario

ABB

ABB VSN900 Guía de inicio rápido

Commander

Commander Pulse Manual de usuario

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Manual de usuario

NETGEAR

NETGEAR C6300BD Manual de usuario

Amit

Amit CDW531AM Manual de usuario

HMS

HMS Netbiter EasyConnect EC150 Manual de usuario

Huawei

Huawei EchoLife HG620 Manual de usuario

AT&T

AT&T U-verse 3801 Manual de uso y cuidado

Logic IO

Logic IO RTCU MX2 turbo Manual de usuario

Suttle

Suttle MediaMAX MXM-521 Manual de usuario

RTA

RTA 460MCBC-N2E Hoja de especificaciones