Yakima Whispbar K462W Manual de usuario
K462W
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 6 x 6 x 6 x 1
Revision No: 10J 1
Fitting Kit K462W
MAX kgs (lbs)
W/P WHD
Peugeot
Expert, 5dr Van 07-15 AU 75 kgs (165 lbs) 75 kgs (165 lbs)
Expert, 5dr Van 07-15 NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
Expert, 5dr Van 07-15 EU 75 kgs (165 lbs) 75 kgs (165 lbs)
Citroen
Jumpy, 5dr Van 07-15 AU 75 kgs (165 lbs) 75 kgs (165 lbs)
Jumpy, 5dr Van 07-15 EU 75 kgs (165 lbs) 75 kgs (165 lbs)
Jumpy, 5dr Van 07-15 NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
Toyota
ProAce, 5dr Van 07-16 AU 75 kgs (165 lbs) 100 kgs (220 lbs)
ProAce, 5dr Van 07-16 EU 75 kgs (165 lbs) 100 kgs (220 lbs)
ProAce, 5dr Van 07-16 NZ 75 kgs (165 lbs) 100 kgs (220 lbs)
Fiat
Scudo, 5dr Van 07-+ EU 75 kgs (165 lbs) 75 kgs (165 lbs)
Scudo, 5dr Van 07-+ NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
Scudo, 5dr Van 07-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs)
Renault
Trafic, 5dr Van 06-+ NZ 150 kgs (330 lbs) 150 kgs (330 lbs)
Trafic, 5dr Van 06-Mar 15 AU 150 kgs (330 lbs) 150 kgs (330 lbs)
2
Fitting Kit K462W
X
A B C 1 2 3
Expert, 5dr Van 07-15 (AU) 600mm 1380mm 2100mm 1080mm 1055mm 1035mm
23 5/8ths" 54 5/16ths" 82 11/16ths" 42 1/2ths" 41 9/16ths" 40 3/4ths"
Expert, 5dr Van 07-15 (NZ) 600mm 1380mm 2100mm 1080mm 1055mm 1035mm
23 5/8ths" 54 5/16ths" 82 11/16ths" 42 1/2ths" 41 9/16ths" 40 3/4ths"
Expert, 5dr Van 07-15 (EU) 600mm 1380mm 2100mm 1080mm 1055mm 1035mm
23 5/8ths" 54 5/16ths" 82 11/16ths" 42 1/2ths" 41 9/16ths" 40 3/4ths"
Jumpy, 5dr Van 07-15 (AU) 600mm 1380mm 2100mm 1080mm 1055mm 1035mm
23 5/8ths" 54 5/16ths" 82 11/16ths" 42 1/2ths" 41 9/16ths" 40 3/4ths"
Jumpy, 5dr Van 07-15 (EU) 600mm 1380mm 2100mm 1080mm 1055mm 1035mm
23 5/8ths" 54 5/16ths" 82 11/16ths" 42 1/2ths" 41 9/16ths" 40 3/4ths"
Jumpy, 5dr Van 07-15 (NZ) 600mm 1380mm 2100mm 1080mm 1055mm 1035mm
23 5/8ths" 54 5/16ths" 82 11/16ths" 42 1/2ths" 41 9/16ths" 40 3/4ths"
ProAce, 5dr Van 07-16 (AU) 600mm 1380mm 2100mm 1080mm 1055mm 1035mm
23 5/8ths" 54 5/16ths" 82 11/16ths" 42 1/2ths" 41 9/16ths" 40 3/4ths"
ProAce, 5dr Van 07-16 (EU) 600mm 1380mm 2100mm 1080mm 1055mm 1035mm
23 5/8ths" 54 5/16ths" 82 11/16ths" 42 1/2ths" 41 9/16ths" 40 3/4ths"
ProAce, 5dr Van 07-16 (NZ) 600mm 1380mm 2100mm 1080mm 1055mm 1035mm
23 5/8ths" 54 5/16ths" 82 11/16ths" 42 1/2ths" 41 9/16ths" 40 3/4ths"
Scudo, 5dr Van 07-+ (EU) 600mm 1380mm 2100mm 1080mm 1055mm 1035mm
23 5/8ths" 54 5/16ths" 82 11/16ths" 42 1/2ths" 41 9/16ths" 40 3/4ths"
Scudo, 5dr Van 07-+ (NZ) 600mm 1380mm 2100mm 1080mm 1055mm 1035mm
23 5/8ths" 54 5/16ths" 82 11/16ths" 42 1/2ths" 41 9/16ths" 40 3/4ths"
Scudo, 5dr Van 07-+ (AU) 600mm 1380mm 2100mm 1080mm 1055mm 1035mm
23 5/8ths" 54 5/16ths" 82 11/16ths" 42 1/2ths" 41 9/16ths" 40 3/4ths"
Trafic, 5dr Van 06-+ (NZ) 655mm 1455mm 1940mm 1240mm 1240mm 1240mm
25 13/16ths" 57 5/16ths" 76 3/8ths" 48 13/16ths" 48 13/16ths" 48 13/16ths"
Trafic, 5dr Van 06-Mar 15 (AU) 655mm 1455mm 1940mm 1240mm 1240mm 1240mm
25 13/16ths" 57 5/16ths" 76 3/8ths" 48 13/16ths" 48 13/16ths" 48 13/16ths"
3
Fitting Kit EN
K462W
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type B crossbar
fitted. They also apply to type A, C and D.
●Use keys to remove covers.
4
Fitting Kit EN
K462W
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
●Set bars to length (revert to rear of these
instructions).
●Please check the front of this manual for
information relating specifically to your
vehicle.
5
Fitting Kit EN
K462W
●Tighten adjusting screw to 2 Nm (1.5 ft lb)
hand tight.
●Remove plastic clamp block by gripping bar
leg with fingers and push firmly with
thumbs until clamp block drops out behind
leg.
●Select plastic internal block (from fitting kit)
and insert into foot.
●Repeat for all legs.
6
Fitting Kit EN
K462W
●Fit rubber pad (supplied with crossbar) to
foot.
●Make sure the pad fits into the holes
underneath the foot.
●Apply protective strip as shown.
Trim if required.
Fitment
●Slide nut under fixed-point mount
7
Fitting Kit EN
K462W
●Place crossbar foot over fixed-point mount.
●Tighten the plastic knob.
●Do not over tighten.
●Ensure the plastic knob is in the position
shown when fully tightened.
●Repeat for all legs.
8
Fitting Kit EN
K462W
●Check crossbar is securely attached to the
vehicle.
●Use keys to fit and lock covers
CAUTION: Recheck all fasteners immediately after
a load is applied to the crossbars.
Regularly check screws are tight.
9
Fitting Kit EN
K462W
Maintenance
●Clean the car roof and surfaces of the
product that will be in contact with the car
roof.
●Follow the fitting instructions for fitting the
product to your vehicle. Make sure all steps
are carried out in order.
●Set crossbars a minimum distance of
700mm (27 1/2") apart where no other
distance is specified in the fitting
instructions. This is especially important
when carrying long loads.
●Check unit is securely attached whenever
you refit it to the vehicle. If the unit feels
loose, refer to the fitting instructions and
readjust.
●Some glass/panoramic roofs and radio
antennae may not be able to be used when
the product is fitted.
●Do not modify this product.
●Refer to the maximum permitted load
capacity specified in the fitting instructions.
Do not exceed the vehicle manufacturers
roof load rating if it is lower than the
maximum load capacity specified in the
fitting instructions.
●Loads should not overhang the sides of the
product and be evenly distributed with the
lowest possible centre of gravity.
●Long loads should be secured with non-
elastic straps to the front and rear of the
vehicle.
●Objects with pointed ends (e.g. ski poles)
should be carried with the pointed ends to
the rear of the vehicle.
●Remove all loose or removable objects
from the load prior to loading.
●Make sure all loads are securely fastened
with non-elastic straps. Check regularly
during longer journeys.
●A loaded roof rack system can alter the
performance of your vehicle. Be especially
aware of the effects of side winds,
changing of direction, and braking
performance. Avoid rapid acceleration and
deceleration. Drive carefully.
●Note that the total height of the vehicle
increases when upright loads are carried.
●Products should be locked during transport
if they have locks fitted.
10
Tabla de contenidos
Otros manuales de Accesorios para automóviles de Yakima
Yakima
Yakima FatCat 4 Manual de usuario
Yakima
Yakima MultiMount Manual de usuario
Yakima
Yakima JayHook Manual de usuario
Yakima
Yakima BasketCase Manual de usuario
Yakima
Yakima forklift Manual de usuario
Yakima
Yakima Outdoorsman Manual de usuario
Yakima
Yakima Q6 Manual de usuario
Yakima
Yakima BoatLocker Manual de usuario
Yakima
Yakima MegaWarrior Manual de usuario
Yakima
Yakima ROCKETBox PRO 11 Manual de usuario
Yakima
Yakima KingJoe 2 Manual de usuario
Yakima
Yakima K319W Manual de usuario
Yakima
Yakima CopperHead Manual de usuario
Yakima
Yakima POWDERHOUND Manual de usuario
Yakima
Yakima BuckHorn 4 Manual de usuario
Yakima
Yakima ROC 4 Manual de usuario
Yakima
Yakima StickUp Manual de usuario
Yakima
Yakima LANDING PAD 17 Manual de usuario
Yakima
Yakima Q102 Manual de usuario
Yakima
Yakima SweetRoll Manual de usuario
