Whispbar K649W Manual de usuario
K649W
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 1 x 1 x 1 x 1
x 1 x 1 x 1 x 1
Revision No: 6F 1
Fitting Kit K649W
x 1 x 1 x 1 x 1
x 2 x 2
2
Fitting Kit K649W
MAX kgs (lbs)
W/P WHD
Hyundai
Elantra, 4dr Sedan 11-15 ZA 65 kgs (143 lbs) 65 kgs (143 lbs)
Elantra, 4dr Sedan 11-15 EU 65 kgs (143 lbs) 65 kgs (143 lbs)
Elantra, 4dr Sedan 11-15 US 65 kgs (143 lbs) 65 kgs (143 lbs)
Elantra, 4dr Sedan 12-+ CN 65 kgs (143 lbs) 65 kgs (143 lbs)
Elantra, 4dr Sedan 15-16 EU 75 kgs (165 lbs) 75 kgs (165 lbs)
Elantra, 4dr Sedan 15-16 ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
Elantra, 4dr Sedan 15-16 US 75 kgs (165 lbs) 75 kgs (165 lbs)
Elantra, 4dr Sedan Jan 14-Jan 16 AU 75 kgs (165 lbs) 75 kgs (165 lbs)
Elantra, 4dr Sedan Jan 14-Jan 16 NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
Elantra, 4dr Sedan Jul 11-Dec 13 AU 65 kgs (143 lbs) 65 kgs (143 lbs)
Elantra, 4dr Sedan Jul 11-Dec 13 NZ 65 kgs (143 lbs) 65 kgs (143 lbs)
3
Fitting Kit K649W
X
A B C 1 2 3
Elantra, 4dr Sedan 11-15 (ZA) -310mm 340mm - 930mm 905mm -
-12 -3/16ths" 13 3/8ths" - 36 5/8ths" 35 5/8ths" -
Elantra, 4dr Sedan 11-15 (EU) -310mm 340mm - 930mm 905mm -
-12 -3/16ths" 13 3/8ths" - 36 5/8ths" 35 5/8ths" -
Elantra, 4dr Sedan 11-15 (US) -310mm 340mm - 930mm 905mm -
-12 -3/16ths" 13 3/8ths" - 36 5/8ths" 35 5/8ths" -
Elantra, 4dr Sedan 12-+ (CN) -310mm 340mm - 930mm 905mm -
-12 -3/16ths" 13 3/8ths" - 36 5/8ths" 35 5/8ths" -
Elantra, 4dr Sedan 15-16 (EU) -310mm 340mm - 930mm 905mm -
-12 -3/16ths" 13 3/8ths" - 36 5/8ths" 35 5/8ths" -
Elantra, 4dr Sedan 15-16 (ZA) -310mm 340mm - 930mm 905mm -
-12 -3/16ths" 13 3/8ths" - 36 5/8ths" 35 5/8ths" -
Elantra, 4dr Sedan 15-16 (US) -310mm 340mm - 930mm 905mm -
-12 -3/16ths" 13 3/8ths" - 36 5/8ths" 35 5/8ths" -
Elantra, 4dr Sedan Jan 14-Jan 16 (AU) -310mm 340mm - 930mm 905mm -
-12 -3/16ths" 13 3/8ths" - 36 5/8ths" 35 5/8ths" -
Elantra, 4dr Sedan Jan 14-Jan 16 (NZ) -310mm 340mm - 930mm 905mm -
-12 -3/16ths" 13 3/8ths" - 36 5/8ths" 35 5/8ths" -
Elantra, 4dr Sedan Jul 11-Dec 13 (AU) -310mm 340mm - 930mm 905mm -
-12 -3/16ths" 13 3/8ths" - 36 5/8ths" 35 5/8ths" -
Elantra, 4dr Sedan Jul 11-Dec 13 (NZ) -310mm 340mm - 930mm 905mm -
-12 -3/16ths" 13 3/8ths" - 36 5/8ths" 35 5/8ths" -
4
Fitting Kit EN
K649W
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
NOTE: Clamp images in these instructions may
not be representative of the clamps in this kit
5
Fitting Kit EN
K649W
●Use keys to remove covers.
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
6
Fitting Kit EN
K649W
●Remove locking screw.
●Apply protective strip as shown.
Trim if required.
●A = Clear
B = Grey
●It is important to put the clamps in the
correct position on the vehicle.
●Letters refer to the part numbers stamped
on clamps.
●Clamp Part Number:
A = A290
B = A291
C = A292
D = A293
7
Fitting Kit EN
K649W
●Attach clamp to each leg. NOTE; clamps
may have labels showing their positions on
the vehicle (For example; "Front Right").
●Refit locking screw so that it goes through
the hole in the clamp. Do not begin to
tighten the locking screw.
●Refer to the underside of the pad for the
part number.
8
Fitting Kit EN
K649W
●It is important to put the pads in the correct
position on the vehicle.
●Letters refer to the pad part numbers and
position.
●Pad Part Number:
A = 295A
B = 296A
●Fit rubber pads (supplied with fitting kit) to
foot. Pad may vary in shape to that shown.
●Make sure the pad fits into the holes
underneath the foot.
9
Fitting Kit EN
K649W
Fitment
●Clamps directly to edge of roof under the
doors
●Please check the front of this manual for
information relating specifically to your
vehicle.
●Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
●Adjust the legs on the crossbar so that they
are positioned equally from the ends of the
crossbar, and the clamps engage firmly on
the body work of the vehicle.
●Tighten adjusting screw to 2 Nm (1.5 ft lb)
hand tight.
10
Tabla de contenidos
Otros manuales de Accesorios para automóviles de Whispbar
Whispbar
Whispbar K621 Manual de usuario
Whispbar
Whispbar K683W Manual de usuario
Whispbar
Whispbar K090W Manual de usuario
Whispbar
Whispbar K401W Manual de usuario
Whispbar
Whispbar K138W Manual de usuario
Whispbar
Whispbar Basic Carrier K784W Manual de usuario
Whispbar
Whispbar K881W Manual de usuario
Whispbar
Whispbar S17W Manual de usuario
Whispbar
Whispbar K437W Manual de usuario
Whispbar
Whispbar K747W Manual de usuario
Whispbar
Whispbar K120W Manual de usuario
Whispbar
Whispbar K347W Manual de usuario
Whispbar
Whispbar K506W Manual de usuario
Whispbar
Whispbar K1218 Manual de usuario
Whispbar
Whispbar K505W Manual de usuario
Whispbar
Whispbar K526 Manual de usuario
Whispbar
Whispbar K377 Manual de usuario
Whispbar
Whispbar K471W Manual de usuario
Whispbar
Whispbar K485W Manual de usuario
Whispbar
Whispbar K892W Manual de usuario
