Whispbar K590W Manual de usuario
K590W
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 2 x 2 x 2 x 2
x 1 x 1 x 1 x 1
Revision No: 5E 1
Fitting Kit K590W
MAX kgs (lbs)
W/P WHD
Alfa Romeo
Giulietta, 5dr Hatch 10-13 AU 50 kgs (110 lbs) 50 kgs (110 lbs)
Giulietta, 5dr Hatch 10-13 EU 50 kgs (110 lbs) 50 kgs (110 lbs)
Giulietta, 5dr Hatch 10-13 ZA 50 kgs (110 lbs) 50 kgs (110 lbs)
Giulietta, 5dr Hatch 10-13 NZ 50 kgs (110 lbs) 50 kgs (110 lbs)
Giulietta, 5dr Hatch 10-13 CN 50 kgs (110 lbs) 50 kgs (110 lbs)
Giulietta, 5dr Hatch 14-+ NZ 50 kgs (110 lbs) 50 kgs (110 lbs)
Giulietta, 5dr Hatch 14-+ AU 50 kgs (110 lbs) 50 kgs (110 lbs)
Giulietta, 5dr Hatch 14-+ EU 50 kgs (110 lbs) 50 kgs (110 lbs)
Giulietta, 5dr Hatch 14-+ ZA 50 kgs (110 lbs) 50 kgs (110 lbs)
Giulietta, 5dr Hatch 14-+ CN 50 kgs (110 lbs) 50 kgs (110 lbs)
2
Fitting Kit K590W
X
A B C 1 2 3
Giulietta, 5dr Hatch 10-13 (AU) -360mm 400mm - 805mm 775mm -
-14 -3/16ths" 15 3/4ths" - 31 11/16ths" 30 1/2ths" -
Giulietta, 5dr Hatch 10-13 (EU) -360mm 400mm - 805mm 775mm -
-14 -3/16ths" 15 3/4ths" - 31 11/16ths" 30 1/2ths" -
Giulietta, 5dr Hatch 10-13 (ZA) -360mm 400mm - 805mm 775mm -
-14 -3/16ths" 15 3/4ths" - 31 11/16ths" 30 1/2ths" -
Giulietta, 5dr Hatch 10-13 (NZ) -360mm 400mm - 805mm 775mm -
-14 -3/16ths" 15 3/4ths" - 31 11/16ths" 30 1/2ths" -
Giulietta, 5dr Hatch 10-13 (CN) -360mm 400mm - 805mm 775mm -
-14 -3/16ths" 15 3/4ths" - 31 11/16ths" 30 1/2ths" -
Giulietta, 5dr Hatch 14-+ (NZ) -365mm 400mm - 805mm 775mm -
-14 -3/8ths" 15 3/4ths" - 31 11/16ths" 30 1/2ths" -
Giulietta, 5dr Hatch 14-+ (AU) -365mm 400mm - 805mm 775mm -
-14 -3/8ths" 15 3/4ths" - 31 11/16ths" 30 1/2ths" -
Giulietta, 5dr Hatch 14-+ (EU) -365mm 400mm - 805mm 775mm -
-14 -3/8ths" 15 3/4ths" - 31 11/16ths" 30 1/2ths" -
Giulietta, 5dr Hatch 14-+ (ZA) -365mm 400mm - 805mm 775mm -
-14 -3/8ths" 15 3/4ths" - 31 11/16ths" 30 1/2ths" -
Giulietta, 5dr Hatch 14-+ (CN) -365mm 400mm - 805mm 775mm -
-14 -3/8ths" 15 3/4ths" - 31 11/16ths" 30 1/2ths" -
3
Fitting Kit EN
K590W
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
NOTE: Clamp images in these instructions may
not be representative of the clamps in this kit
4
Fitting Kit EN
K590W
●Use keys to remove covers.
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
5
Fitting Kit EN
K590W
●Remove locking screw.
●Apply protective strip as shown.
Trim if required.
●It is important to put the clamps in the
correct position on the vehicle.
●Letters refer to the part numbers stamped
on clamps.
●Clamp Part Number:
A = 752A
B = 753A
6
Fitting Kit EN
K590W
●Attach clamp to each leg. NOTE; clamps
may have labels showing their positions on
the vehicle (For example; "Front Right").
●Refit locking screw so that it goes through
the hole in the clamp. Do not begin to
tighten the locking screw.
●Refer to the underside of the pad for the
part number.
7
Fitting Kit EN
K590W
●It is important to put the pads in the correct
position on the vehicle.
●Letters refer to the pad part numbers and
position.
●Pad Part Number:
A = 11-04-224
B = 11-04-225
C = 11-04-226
D = 11-04-227
●Fit rubber pads (supplied with fitting kit) to
foot. Pad may vary in shape to that shown.
●Make sure the pad fits into the holes
underneath the foot.
8
Fitting Kit EN
K590W
Fitment
●Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
●Please check the front of this manual for
information relating specifically to your
vehicle.
●Locate vehicle's fixed points.
●Adjust the legs on the crossbar so that they
are positioned equally from the ends of the
crossbar, and the clamps engage firmly on
the body work of the vehicle.
●Clamps directly to edge of roof under the
doors, pin locates in hole on vehicle
●Tighten adjusting screw to 5 Nm (3.7 ft lb)
hand tight.
9
Fitting Kit EN
K590W
●Tighten locking screw on both legs evenly.
●Check crossbar is securely attached to the
vehicle.
●Use keys to fit and lock covers
10
Tabla de contenidos
Otros manuales de Accesorios para automóviles de Whispbar
Whispbar
Whispbar K527W Manual de usuario
Whispbar
Whispbar K1010 Manual de usuario
Whispbar
Whispbar K343W Manual de usuario
Whispbar
Whispbar K906W Manual de usuario
Whispbar
Whispbar K802W Manual de usuario
Whispbar
Whispbar K888W Manual de usuario
Whispbar
Whispbar K337W Manual de usuario
Whispbar
Whispbar K131W Manual de usuario
Whispbar
Whispbar Q Series Manual de usuario
Whispbar
Whispbar K131W Manual de usuario
Whispbar
Whispbar K677W Manual de usuario
Whispbar
Whispbar K821W Manual de usuario
Whispbar
Whispbar K071W Manual de usuario
Whispbar
Whispbar K570W Manual de usuario
Whispbar
Whispbar K340W Manual de usuario
Whispbar
Whispbar K557W Manual de usuario
Whispbar
Whispbar K539W Manual de usuario
Whispbar
Whispbar K359W Manual de operación e instalación
Whispbar
Whispbar K838W Manual de operación e instalación
Whispbar
Whispbar K055W Manual de usuario
