Whispbar K391W Manual de usuario
K391W
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 2 x 2 x 2 x 2
x 4
Revision No: 7G 1
Fitting Kit K391W
MAX kgs (lbs)
W/P WHD
Volkswagen
Passat Mk6, 4dr Sedan 05-09 ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat Mk6, 4dr Sedan 05-10 US 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat Mk6, 4dr Sedan 05-10 EU 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat Mk6, 4dr Sedan 05-10 CN 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat Mk6, 4dr Sedan Dec 05-10 NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat Mk6, 4dr Sedan Mar 06-10 AU 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat, 4dr Sedan 10-10 US 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat, 4dr Sedan 10-Oct 14 EU 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat, 4dr Sedan 10-Sep 15 AU 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat, 4dr Sedan 10-Sep 15 ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat, 4dr Sedan 10-Sep 15 NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
Passat, 4dr Sedan 10-Sep 15 CN 75 kgs (165 lbs) 75 kgs (165 lbs)
2
Fitting Kit K391W
X
A B C 1 2 3
Passat Mk6, 4dr Sedan 05-09 (ZA) -280mm 470mm - 894mm 884mm -
-11" 18 1/2ths" - 35 3/16ths" 34 13/16ths" -
Passat Mk6, 4dr Sedan 05-10 (US) -280mm 470mm - 894mm 884mm -
-11" 18 1/2ths" - 35 3/16ths" 34 13/16ths" -
Passat Mk6, 4dr Sedan 05-10 (EU) -280mm 470mm - 894mm 884mm -
-11" 18 1/2ths" - 35 3/16ths" 34 13/16ths" -
Passat Mk6, 4dr Sedan 05-10 (CN) -280mm 470mm - 894mm 884mm -
-11" 18 1/2ths" - 35 3/16ths" 34 13/16ths" -
Passat Mk6, 4dr Sedan Dec 05-10 (NZ) -280mm 470mm - 894mm 884mm -
-11" 18 1/2ths" - 35 3/16ths" 34 13/16ths" -
Passat Mk6, 4dr Sedan Mar 06-10 (AU) -280mm 470mm - 894mm 884mm -
-11" 18 1/2ths" - 35 3/16ths" 34 13/16ths" -
Passat, 4dr Sedan 10-10 (US) -275mm 475mm - 895mm 885mm -
-10 -13/16ths" 18 11/16ths" - 35 1/4ths" 34 13/16ths" -
Passat, 4dr Sedan 10-Oct 14 (EU) -275mm 475mm - 895mm 885mm -
-10 -13/16ths" 18 11/16ths" - 35 1/4ths" 34 13/16ths" -
Passat, 4dr Sedan 10-Sep 15 (AU) -275mm 475mm - 895mm 885mm -
-10 -13/16ths" 18 11/16ths" - 35 1/4ths" 34 13/16ths" -
Passat, 4dr Sedan 10-Sep 15 (ZA) -275mm 475mm - 895mm 885mm -
-10 -13/16ths" 18 11/16ths" - 35 1/4ths" 34 13/16ths" -
Passat, 4dr Sedan 10-Sep 15 (NZ) -275mm 475mm - 895mm 885mm -
-10 -13/16ths" 18 11/16ths" - 35 1/4ths" 34 13/16ths" -
Passat, 4dr Sedan 10-Sep 15 (CN) -275mm 475mm - 895mm 885mm -
-10 -13/16ths" 18 11/16ths" - 35 1/4ths" 34 13/16ths" -
3
Fitting Kit EN
K391W
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
NOTE: Clamp images in these instructions may
not be representative of the clamps in this kit
4
Fitting Kit EN
K391W
●Use keys to remove covers.
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
5
Fitting Kit EN
K391W
●Remove locking screw.
●Apply protective strip as shown.
Trim if required.
●It is important to put the clamps in the
correct position on the vehicle.
●Letters refer to the part numbers stamped
on clamps.
●Clamp Part Number:
A = 504A
B = 505A
6
Fitting Kit EN
K391W
●Attach clamp to each leg. NOTE; clamps
may have labels showing their positions on
the vehicle (For example; "Front Right").
●Refit locking screw so that it goes through
the hole in the clamp. Do not begin to
tighten the locking screw.
●It is important to put the pads in the correct
position on the vehicle.
●Letters refer to the pad part numbers and
position.
●Pad Part Number:
A = 11-04-250
B = 11-04-251
7
Fitting Kit EN
K391W
●Refer to the underside of the pad for the
part number.
●Fit rubber pads (supplied with fitting kit) to
foot. Pad may vary in shape to that shown.
●Make sure the pad fits into the holes
underneath the foot.
8
Fitting Kit EN
K391W
Fitment
●Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
●Clamps directly to edge of roof under the
doors, pin locates in hole on vehicle
●Please check the front of this manual for
information relating specifically to your
vehicle.
●Locate vehicle's fixed points.
●Clamps directly to edge of roof under the
doors, pin locates in hole on vehicle
●Adjust the legs on the crossbar so that they
are positioned equally from the ends of the
crossbar, and the clamps engage firmly on
the body work of the vehicle.
●Tighten adjusting screw to 5 Nm (3.7 ft lb)
hand tight.
9
Fitting Kit EN
K391W
●Tighten locking screw on both legs evenly.
●Check crossbar is securely attached to the
vehicle.
●Use keys to fit and lock covers
10
Tabla de contenidos
Otros manuales de Accesorios para automóviles de Whispbar
Whispbar
Whispbar K802W Manual de operación e instalación
Whispbar
Whispbar K059W Manual de usuario
Whispbar
Whispbar S44W Manual de usuario
Whispbar
Whispbar K725W Manual de usuario
Whispbar
Whispbar K412 Manual de usuario
Whispbar
Whispbar K478W Manual de usuario
Whispbar
Whispbar K606W Manual de usuario
Whispbar
Whispbar K891W Manual de usuario
Whispbar
Whispbar K062W Manual de usuario
Whispbar
Whispbar K390W Manual de usuario
Whispbar
Whispbar K447W Manual de operación e instalación
Whispbar
Whispbar K557W Manual de usuario
Whispbar
Whispbar K583W Manual de usuario
Whispbar
Whispbar K033W Manual de usuario
Whispbar
Whispbar K002W Manual de operación e instalación
Whispbar
Whispbar K596W Manual de usuario
Whispbar
Whispbar K821W Manual de usuario
Whispbar
Whispbar K449W Manual de usuario
Whispbar
Whispbar K484W Manual de usuario
Whispbar
Whispbar K478W Manual de operación e instalación
