Whalen WSF54OW30W Manual de usuario
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION.
PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Date 2016-05-27 Rev. 0001-A Factory: DOCHDI
Leland 54" Fireplace Console
Model # WSF54OW30W
ADULT ASSEMBLY REQUIRED
If you have any questions regarding assembly or if parts are missing, DO NOT return this item to the
store where it was purchased. Please call our toll-free customer service number and have your
instructions and parts list ready to provide the model name, part name or factory number:
1-866-942-5362
Pacific Standard Time: 8:30 a.m. - 4:30 p.m., Monday - Friday
Or visit our website www.whalenfurniture.com
Or e-mail your request to: parts@whalenfurniture.com
LOT NUMBER:
DATE PURCHASED: / /
2
MANUFACTURER: Whalen Furniture Manufacturing
CATALOG: Leland 54" Fireplace Console (WSF54OW30W)
MADE IN CHINA
Important
Before you begin: Open, identify and count all parts prior to assembly. Lay out parts on a flat and non-abrasive
surface. You will need the parts identified on pages 3 and 4 of this instruction manual.
NOTE: IT IS VERY IMPORTANT TO USE GLUE WITH THE DOWELS. EXCESS GLUE CAN BE
WIPED OFF WITH A DAMP CLOTH.
Insert Dowel at least half way by tapping lightly with a rubber mallet (not included), IF NECESSARY.
MAXIMUM RECOMMENDED WEIGHT LOADS
THIS UNIT IS NOT INTENDED FOR USE WITH CRT TVS. USE ONLY WITH FLAT
PANEL TVS AND AUDIO/VIDEO EQUIPMENT MEETING RECOMMENDED SIZE AND WEIGHT
LIMITS. NEVER USE WITH LARGER/HEAVIER THAN RECOMMENDED FLAT PANEL TVS OR
EQUIPMENT. TO AVOID INSTABILITY, PLACE FLAT PANEL TV IN THE CENTER OF THE UNIT; THE
BASE OF THE TELEVISION MUST BE ABLE TO REST ON THE SUPPORTING SURFACE OF THE
UNIT WITHOUT OVER-HANGING THE EDGES. IMPROPERLY POSITIONED FLAT PANEL TVS, OR
FLAT PANEL TVS INCLUDING OTHER EQUIPMENT THAT EXCEED RECOMMENDED SIZE AND
WEIGHT LIMITS COULD FALL OFF OR BREAK THE UNIT
,
CAUSING POSSIBLE SERIOUS INJURY.
FITS UP TO MOST 65” FLAT PANEL TVs
MAXIMUM LOAD 61.2 kg / 135 lb.
PLACE TV BEHIND THE STOPPER
MAXIMUM LOAD 22.7 kg / 50 lb.
XX
FINAL
12 43
3
Parts and Hardware List
Please read completely through the instructions and verify that all listed parts and hardware are present
before beginning assembly.
A- Top Panel B- Top Corner Extension C- Left Upper Side Frame
(Qty. 1) (Qty. 1) (Qty. 1)
D- Right Upper Side Frame (Qty. 1) E- Center Shelf (Qty. 1) F- Lower Side Panel (Qty. 2)
G- Lower Front Panel (Qty. 2) H- Back Panel (Qty. 1) I- Center Crossbar (Qty. 2)
J- Base (Qty. 1) K- Corner Support (Qty. 1) L- Barrister Door (Qty. 1)
M- Glass Door Panel (Qty. 1) N- Speaker Grill (Qty. 1) O- Wood Door Panel (Qty. 1)
(Pre-attached)
P- Firebox Back Support (Qty. 1) Q- Firebox Left Support (Qty. 1) R- Firebox Right Support (Qty. 1)
4
Parts and Hardware List
Please read completely through the instructions and verify that all listed parts and hardware are present
before beginning assembly.
Fireplace Insert (Qty. 1) Remote Control with Battery (Qty. 1)
(1) Ø1/4” x 5/8” Bolt (2) Ø1/4” x 1-1/4” Bolt (3) Lock Washer
(Qty. 10+1 extra) (Qty. 38+1 extra) (Qty. 38+1 extra)
(4) Flat Washer (5) M8 x 30 mm Wood Dowel (6) Ø3.5 x 12 mm Screw
(Qty. 38+1 extra) (Qty. 48+2 extra) (Qty. 12+1 extra)
(7) Ø3.5 x 15 mm Washer Head Screw (8) Knob (9) Small Metal Bracket
(Qty. 28+1 extra) (Qty. 2) (Qty. 4)
(10) Knob Bolt (Qty. 2) (11) Acrylic Stopper (Qty. 1) (12) Hook (Qty. 2)
(13) Large Metal Bracket (Qty. 4) (14) Plastic Connector (Qty. 5) Allen Wrench (Qty. 1)
Glue (Qty. 1) Touch-up Pen (Qty. 1) Tipping Restraint Hardware Kit (Qty. 2)
(Included in plastic bag)
Tools required: Allen wrench (provided), Phillips screwdriver and hammer (not provided).
5
Assembly Instructions
1. Unpack the unit and confirm that you have all the hardware and required parts. Assembly the unit on a
carpeted floor or the empty carton to avoid any scratch.
2. Glue two Wood Dowels (5) into the inner holes on one Lower Side Panel (F) and attach it to one Lower
Front Panel (G) with three 1-1/4” Bolts (2) and three Washers (3 and 4).
3. Repeat the same procedure to combine the remainder Lower Side Panel (F) and Lower Front Panel (G)
together.
4. Using the pilot holes as a guide, attach two Small Metal Brackets (9) to each Center Crossbar (I) with
two 12 mm Screws (6) as shown.
I
6
9
6
9
234
5
F
G
X2
X2
6
Assembly Instructions
5. Glue the Wood Dowels (5) into the drilled holes on the Center Crossbars (I) at both ends and attach
them between the two Lower Front Panels (G) as shown. Insert four 12 mm Screws (6) through the
Small Metal Brackets (9) and screw into the Lower Front Panels (G).
6. Glue ten Wood Dowels (5) into the top holes of the previous assembly.
7. Position the Center Shelf (E) onto the inserted Wood Dowels (5) and fasten in place with nine 1-1/4”
Bolts (2) and nine Washers (3 and 4).
G
G
F
F
I
I
I
I
G
G
9
6
5
5
5
5
F
F
F
F
I
I
G
G
E
2
3
4
5
7
Assembly Instructions
8. Glue ten Wood Dowels (5) into the non-threaded holes on the Base (J).
9. Position the previous assembly onto the inserted Wood Dowels (5) on the Base (J) and attach in place
with nine 1-1/4” Bolts (2) and nie Washers (3 and 4).
10. Glue six Wood Dowels (5) into the non-threaded holes on the Center Shelf (E).
11. Position the Upper Side Frames (C and D) onto the inserted Wood Dowels (5) and attach them to the
Fixed Shelf (E) with four 1-1/4” Bolts (2) and four Washers (3 and 4).
F
G
G
F
I
J
2
3
4
5
5
2
3
4
E
C
D
8
Assembly Instructions
12. Using the pilot holes as a guide, fasten two Hooks (12) to the upper corners of the Barrister Door (L)
with four 12 mm Screws (6) as shown.
13. Attach two Knobs (8) to the front side of the Barrister Door (L) with two Knob Bolts (10).
NOTE: The Barrister Door is shipped with the Speaker Grill (N). You can keep the door as it is or
interchange with Glass Door Insert (M) or Wood Door Insert (O) depending on your configuration.
14. To change the configuration, loosen the screws on the inside of the Barrister Door (L) and rotate the
clips to remove the panel. Replace with the desired panel, then rotate clips to secure the panel within the
door frame and tighten screws.
M
N
L
O
6
12
6
12
8
10
8
10
L
9
Assembly Instructions
15. Hook the Barrister Door (L) onto the pre-attached plastic slides on the Upper Side Frames (C and D).
16. Glue six Wood Dowels (5) into the top holes on the Upper Side Frames (C and D).
17. Position the Top Panel (A) onto the inserted Wood Dowels (5) and fasten in place with four 1-1/4”
Bolts (2) and four Washers (3 and 4).
D
C
L
12
L
C/D
5
2
3
4
D
C
L
A
10
Assembly Instructions
18. Now, go back and securely tighten all the bolts and the screws. Make sure that all the parts are tight and
there are no gaps between the parts. This will help keep the unit square.
19. Pick up the Back Panel (H) and align the pre-drilled holes against the upper long edge with the pilot
holes on the back stretcher of the Top Panel (A). Attach the Back Panel (H) in place with the provided
Washer Head Screws (7).
20. Align and attach the Firebox Left and Right Supports (Q and R) onto the Base (J) with four 1-1/4” Bolts
(2) and four Washers (3 and 4).
J
R
Q
2
3
4
2
3
4
H
A
D
7
7
Tabla de contenidos
Otros manuales de Chimenea de interior de Whalen
Whalen
Whalen Middleton WSF72WV26-DB Manual de usuario
Whalen
Whalen MNFP52EW26CA Manual de usuario
Whalen
Whalen WMFP48FH-10-KD Manual de usuario
Whalen
Whalen WSF48FM23R-AO Manual de usuario
Whalen
Whalen Linwood MNFP60LW26IO Manual de usuario
Whalen
Whalen BJFP60-3 Manual de usuario
Whalen
Whalen Kellum WMFP48EC-26GR Manual de usuario
Whalen
Whalen Middleton WSF32WV23-DB Manual de usuario
Whalen
Whalen Millstead WSF60MS26GAO Manual de usuario
Whalen
Whalen MNFP60PV26WT Manual de usuario
Whalen
Whalen WSLWFP54-6 Manual de usuario
Whalen
Whalen WMFP54HL-23 Manual de usuario
Whalen
Whalen GRANTVILLE WS03061433 Manual de usuario
Whalen
Whalen FP32EC23I-1BC Manual de usuario
Whalen
Whalen SUMCMF-23 Manual de usuario
Whalen
Whalen WSF61DL26C-AC Manual de usuario
Whalen
Whalen Farmstead WSF60FM23R-AO Manual de usuario
Whalen
Whalen WSF42OW23W Manual de usuario
Whalen
Whalen Barston WMFP48EC-25DC Manual de usuario
Whalen
Whalen MNFP54LW23 Manual del propietario
