Wali TVF001 Manual de usuario

WARNING

！

USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.

SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.

If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a

qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may

cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.

Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect

assembly or inappropriate use.

SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:

100x100\100x200

200x100\200x200

1-844-SATTLER (18447288537)

[email protected]

www.walielectric.com

40kg/88lbs

RATED

MAX 43”

TIPOVER WARNING

INSTALLATION MANUAL

TABLETOP TV STAND

TVF001

Supplied Parts List

Base

A (x1)

Washer

J (x3)

Step Washer

K (x3)

M4x14 Bolt

M-A (x4)

M5x14 Bolt

M-B (x4)

M6x14 Bolt

M-C (x4)

M6x30 Bolt

M-D (x4)

D5 Washer

M-E (x4)

D8 Washer

M-F (x4)

Spacer

M-G (x8)

Pole

B (x1)

VESA Plate

C (x1)

Pole Cover

D (x1)

Plate

E (x1)

Wire Clip

F (x2)

Anti-Skid Pad

G (x4)

M6x25 Bolt

H (x3)

M6x50 Bolt

I (x1)

Tear off the protective paper to attach Anti-Skid Pad to the bottom designated position of Base as image shown.

1Connect Pole , Plate and Base from the bottom using M6x25 Bolt , Washer and Step Washer , tighten with a screwdriver.

(Screwdriver not included)

GB E A

Too S hort

Too l ong

OR OR

Hand thread screws

into the threaded

insertson the backof

your TVto determine

which screw diameter

(M4, M5or M6) to use.

M4 M5 M6

Only one screw size fits your TV

Press Pole Cover into the top of Pole . Select the preferred height and attach the VESA plate to the hole on the Pole .

Tighten the VESA plate using the M6X50 bolt with a screwdriver. (Screwdriver not included)

Fix the Wire Clip onto the back of Pole and guide the cable through the Wire Clips .

5Manually adjust swivel angle. (Swivel -35°/+35°)

Select bolts and spacers (if needed) according to your TV/Monitor. Attach the VESA Plate to the

TV and tighten with a screwdriver. (Screwdriver not included)

Step 3.1

Step 3.2

F B F

± 35°

M-A

M-B

M-C M-D M-D

M-F M-F

M-G M-G

M-F

M-E

15.5”

13.6”

11.6”

Tabla de contenidos

Otros manuales de Rack y soporte de Wali

Manuales populares de Rack y soporte de otras marcas

Salamander

Salamander Acadia AC/W/L400/WH Manual de usuario

Fohhn

Fohhn VAT-09 Guía del usuario

ricoo

ricoo FS0522 Manual de usuario

AMSOIL

AMSOIL BMK-22 Guía rápida

Kargo Master

Kargo Master 48220 Manual de usuario

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manual de usuario

ricoo

ricoo S1222 Manual de usuario

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manual de usuario

VidaBox

VidaBox VB MNT FFS2 Manual de usuario

Welch Allyn

Welch Allyn 48960 Manual de usuario

Arkon

Arkon CM035-ST-2 Manual de usuario

PROEL

PROEL PLWIN60C Manual de usuario

Agilent Technologies

Agilent Technologies E2609B Manual de usuario

Mustang

Mustang MV-ARM4 Manual de usuario

Mounting Solutions

Mounting Solutions WRM-320 Manual de usuario

Pyle

Pyle PMKSPAD1 Manual de usuario

ShelterIt

ShelterIt 21208 Manual de usuario

SPL

SPL RackPack?4 1040 Manual de usuario