Volvo A2DIY-VOL Manual de usuario

Courtesy of: DiscountCarStereo.com

Serving the internet community since 1995

A2DIY-VOL

QUICK START BLUETOOTH INSTALLATION GUIDE FOR VOLVO CD CHANGER CONTROLLING RADIOS

CreatedMarch1, 2017

Revised: October12, 2020

Introduction:

Many Volvo owners adamant about keeping their cars as stock possible, will be

thrilled with the A2DIY-VOL kit which adds modern Bluetooth features without

changing the look and feel of dashboard components. Features Bluetooth

Hands-Free and music streaming from any Smartphone with A2DP and HFP

support. In addition to Bluetooth, a hardwired 3.5mm input jack is available for

users to connect and play non-Bluetooth devices such as Mp3 players, satellite

radio kit, iPods etc. A smart remote control for Apple and Android devices allows

users to track up/down, pause, increase/decrease device volume and more.

Optional USB charging port to keep devices charged while on the road.

Keep the radio and car you love while enjoying Bluetooth features only

available on newer cars. For more details, see Frequently Asked question at

the end of this guide.

Installation:

Although not critical, we recommend disconnecting battery.

Keep in mind, most Volvo radios are coded and will not operate

without code. Radio code must be available for radio to operate

upon reconnection

1. Remove radio by pressing both spring-loaded release tabs as seen in

Fig. 1

2. Place finger inside release ring and pull outward as seen in Fig. 2

Fig. 2

3. Connect adapter harness 8-pin plug (See Fig. 3) to radio “CD”port

(See. Fig. 4).

Factory CD Changer (if present) must be disconnected.

Fig. 3

Fig. 4

Radio’s 8-pin Changer port

4. AUX input connection: Connect supplied 3.5mm audio cable (See Fig.

5) to module “AUX” jack (See Fig. 6). Route and connect other end to

front of the dash or wherever Aux device will reside (within 3 ft.)

Fig. 5

Fig. 6

5. Connect push button (See Fig. 7) to module “CTL”jack

Fig. 7

Control button

6. Secure push button in location that is within reach of the driver (cable

is 6ft. long). Simply remove tape backing (See Fig. 7) and adhere to

surface.

7. Install microphone to visor or headliner using included visor clip (See

Fig. 8).

Fig. 8

Microphone

Fig. 8

Visor clip

8. Carefully route microphones 3.5mm plug down side pillar and behind

the dash and connect to module “MIC” input.

9. Tap adapter harness RED wire to one of two Green/brown Accessory

wires on radio harness (See Fig. 9)

10. Tap YELLOW wire from installation harness to yellow/purple (Battery

supply) wire on radio harness or wherever 12V battery is available in

your car (See Fig. 9)

Fig. 9

11. Secure adapter box and proceed to next section.

Optional USB charging port: (not for thumb drives etc.)

Add Optional “Fast charge kit –to charge devices while on the road. Custom

install in a convenient location and discover how this charger is a massive

improvement over many anemic aftermarket cigar lighter chargers.

To add USB charging kit to your order, tap the option on order page,

installation harness USB port

Should you decide to add the USB Port, we suggest 2 mounting options:

A. Flush to dash/panel requires drilling a ¾” hole in the dash

B. Flush with Support bracket (use this option to mount USB terminal

wherever your installation demands without drilling)

A. Flush to Dash or Panel (requires drilling)

1. Drill a ¾” hole in the dash or panel using a step drill bit or equivalent

(See Fig. 10)

Fig. 10

Step drill bit

2. Insert USB male terminal through the ¾” hole created in step 1 and

connect to module USB port (See Fig. 12)

Fig. 11

USB 6 ft. cable with bracket

Fig. 12

USB charging port

3. Push USB head (See Fig. 13) until it snaps in place and flush with

mounting surface (See Fig. 14)

Fig. 13

USB head

Fig. 14

Flush mounted to dash

4. Tuck and secure any extra wire from moving parts and test operation

(See Enabling the AUX section below)

B. USB with Bracket Mount (No drilling)

1. Locate a flat surface at location of choice within 3.2 ft. of radio and

mount USB support bracket (See Fig. 15) to surface using

adhesive/tape or screws.

Fig. 15

USB mounting bracket

2. Insert the 6 ft. USB male terminal through bracket hole (See Fig. 16)

and connect to Module USB port (See Fig. 12)

Fig. 16

3. Push USB head until it snaps in place and flush (See Fig. 17)

Fig. 17

Tuck and secure any extra wire away from moving parts and test operation (

See

Bluetooth Pairing and Connection

Pairing:

Pairing varies among devices but basic steps are the same. This process is

done upon initial install and will not have to be repeated

1. Turn Ignition and radio “ON”

Blue LED in adapter peephole will flash (pairing mode)

2. On A2DP device: go to

Settings, Wireless & Networks, Bluetooth

Settings

3. Select

Bluetooth

and turn on, select Bluetooth settings

4. Tap

Scan for devices

Wait for Bluetooth device name (See below) to appear and select it.

Once paired Blue LED inside peephole flashes once every 2 seconds

and confirmation tone is heard on car speakers

One connection

The A2DIY-VOL connects to one device at a time. You must disconnect/unpair

first device before pairing a second, or simply disable Bluetooth on first device.

Warning! Voice Recognition applications (e.g. Siri, Google Play etc.) must be enabled on

device as you would in portable mode.

Smart remote

Pairing smart remote: The included smart remote must be paired with

smartphone for media control functions (does not operate C5 radio).

Smart remote pairs with multiple devices but can only operate one at a time.

Follow 3-step pairing process below:

Operation:

Pair with iOS7.0 and higher and Android 4.4 and higher.

In addition to above, use smart remote to:

Answer/end call; press Play/Stop (Android only)

Switch between streaming and AUX press, Play/Stop (Android only).

To pause stream or switch to “AUX” mode press Play/Stop

Push button works both Android and Apple devices to:

Answer/end call, Switch between streaming and AUX mode

Push button Commands

Proceed this way

Answer call

Press and release button

End call

Press and release button

Switch between AUX and Bluetooth

Press and release button

Pair/un-Pair Bluetooth

Press/hold button for 2 seconds

Redial last number called

Press button twice in succession

Note: if no auxiliary device is connected, pressing control button once pauses

music streaming

Bluetooth Comparison Chart

Feature

A2D-VOL

A2DIY-BKR

CD changer retention

3.5mm AUX input

✓

USB charging port

Muting

Hands-Free profile

✓

Music streaming

✓

Push-to-talk button

✓

Remote control

✓

Multi-device pairing

✓

* When radio is in CD changer (Bluetooth Mode)

** Optional

Test Operation:

1. Turn ignition and radio “ON”

2. Press CD, CH6 or CHGR button on radio.

3. Launch streaming application (e.g. Pandora, Apple music etc.)

4. Use device built-in control or smart remote to switch tracks, adjust

device volume, pause/play etc.

5. Place phone call or ask someone to call. Use push button to answer call

(iPhone or Android) or press “Play/Pause” on smart remote (Android

only)

Note: Push button not required for Android devices we tested; however,

it is required to answer/end calls from Apple devices.

Smart remote pause/play button only works to answer/end calls

and switch between AUX and Bluetooth in Android applications.

Apple applications must use push button for Pause/Play function.

6. If correct operation is confirmed go ahead and reinstall radio.

Playlist and Track selection *NOT* possible from Volvo

radio button/display. Use audio device built-in controls

or optional wireless remote to access and control

audio files and applications.

Notes:

Adding additional load to older vehicles may result in alternator whine or similar

noise. For these instances we have included a noise filter (See Fig. 18).

Filter Installation

Install filter between vehicle supply wire and module as follows:

Connect filter (in) red wire to vehicle accessory supply wire

Connect filter (out) red wire to Bluetooth module red wire

Connect filter (in) black wire to vehicle ground wire

Connect filter (out) black wire to radio chassis

Frequent asked questions

1. What’s the difference between A2D-VOL and A2DIY-VOL?

See Bluetooth comparison chart on previous page.

2. Does the A2DIY-VOL work on all Volvo radios?

NO; works only on Volvo “SC” and select “CT” radios with CD changer

controls. (non-changer controlling radios are not supported)

3. Is there something available for non- “CD changer “controlling radios?

YES; Purchase our ISFM23 or ISFM2351.

4. Can I control Smartphone from radio buttons?

NO; you must use Smartphone built-in controls and display to operate

device, or use included smart remote control. Volume button on radio is

used to set the playback level.

5. Can I pair or save more than one device to the A2DIY-VOL?

YES; more than one device (slaves) can be paired however only one

connection can be active at a time. To pair a second device, you must

disconnect first device.

6. When listening to aux device, audio playback is interrupted with every

press of smartphone button.

Is this normal?

YES,when in aux mode, smartphone button operation temporarily

interrupts music playback.

Disclaimer

• This product has no affiliation with Volvo.

• We’re not liable for misuse of this product.

•We recommend professional installation.

Email [email protected]

to change without notice. Other products and companies referred to herein are trademarks or

registered trademarks of their respective companies or mark holders.

Otros manuales para A2DIY-VOL

Tabla de contenidos

Otros manuales de Sistema de navegación para automóviles de Volvo

Volvo

Volvo RTI Manual de usuario

Volvo

Volvo Navigation System Manual de usuario

Volvo

Volvo RTI Manual de usuario

Volvo

Volvo VOLVO NAVIGATION SYSTEM (VNS) Manual de usuario

Volvo

Volvo SENSUS Manual de usuario

Volvo

Volvo 31285224 Manual de usuario

Volvo

Volvo V50 2008 Manual de usuario

Volvo

Volvo XC60 - ANNEXE 541 Manual de usuario

Volvo

Volvo V70 SPORT Manual de usuario

Volvo

Volvo SENSUS Manual de usuario

Volvo

Volvo XC60 - ANNEXE 541 Manual de usuario

Volvo

Volvo SENSUS Manual de usuario

Volvo

Volvo 31285222 Manual de usuario

Volvo

Volvo SENSUS NAVIGATION WEB EDITION Manual de usuario

Volvo

Volvo S60 - ANNEXE 931 Manual de usuario

Volvo

Volvo XC90 - ANNEXE 951 Manual de usuario

Volvo

Volvo VOLVO NAVIGATION SYSTEM (VNS) Manual de usuario

Volvo

Volvo VOLVO NAVIGATION SYSTEM (VNS) Manual de usuario

Volvo

Volvo V70 SPORT Manual de usuario

Volvo

Volvo C30 - ANNEXE 798 Manual de usuario

Volvo

Volvo ROADANDTRAFFICINFORMATIONSYSTEM(RTI) Manual de usuario

Volvo

Volvo SENSUS Manual de usuario

Volvo

Volvo SENSUS Manual de usuario

Volvo

Volvo 31330114 Manual de usuario

Manuales populares de Sistema de navegación para automóviles de otras marcas

Clarion

Clarion Navigation In-Car Entertainment Manual de usuario

Rosen

Rosen DP-1001 Manual de usuario

Alpine

Alpine INE-W970HD Manual de usuario

Skoda

Skoda AMUNDSEN+ Manual de usuario

Blaupunkt

Blaupunkt TravelPilot DX-N Manual de usuario

Pioneer

Pioneer MZ360500EX Manual de usuario

Sanyo

Sanyo NVM-4030 - Easy Street - Automotive GPS... Manual de usuario

Kenwood

Kenwood DNN991HD Manual de usuario

AvMap

AvMap Geosat 2C Manual de usuario

Eonon

Eonon GE01B Manual de usuario

Pioneer

Pioneer AVIC-Z920DAB Manual de usuario

Nextar

Nextar M3-MX - Automotive GPS Receiver Manual de usuario

Furrion

Furrion NV2200 Manual de usuario

Mio

Mio MOOV 200-Series Manual de usuario

Prestigio

Prestigio GeoVision 5150 Manual de usuario

Hummer

Hummer 2006 H3 Manual de usuario

Magellan

Magellan Maestro 4210 - Automotive GPS Receiver Guía de configuración

Garmin

Garmin StreetPilot c510 Manual de usuario