Volt VWL-7125-BBZ Manual de usuario
VOLT®Low Voltage Landscape Lighting
VOLT®RGBW Salty Dog Integrated LED Brass Well Light (Bronze)
VWL-7125-BBZ
INSTALLATION INSTRUCTIONS
Specications and product details subject to change without notice.
© Copyright 2022, VOLT® Lighting, Lutz FL USA 33549 • All rights
reserved. [email protected] • 813.978.3700
Help Hotline:
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)
- 1 -
VOLT®RGBW Salty Dog Integrated LED Brass Well Light (Bronze)
VWL-7125-BBZ
Important: Please Read Before Installation
Important: Safety Instructions
INSTALLATION INSTRUCTIONS
!
!
www.voltlighting.com
- 2 -
This xture is intended for installation in accordance with local codes and the
National Electric Code (NEC). Failure to adhere to these codes and instructions
may result in serious injury, property damage and void the warranty.
These instructions do not intend to cover all variations in installation,
operation maintenance or mounting situations.
1. Make sure the power is turned OFF before installing or servicing this
luminaire.
2. WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M)
or more from pool, spa or fountain.
3. This luminaire is intended to be used only with a power supply
(transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.
4. Wiring connections must be made with UL listed wire connectors that are
suitable for outdoor use.
5. Position the low voltage wire and wire connector so that it is located
within 6 inches (15.2 cm) from a building structure, a luminaire or tting.
6. The main low voltage cable is intended for shallow burial - less than 6
inches (152 mm).
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
Lighted lamp is HOT!
WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.
1. Turn o/unplug and allow to cool before replacing lamp.
2. Lamp gets HOT quickly! Contact only switch/plug when turning on.
3. Do not touch the hot lens, guard or enclosure.
4. Keep lamp away from materials that may burn.
5. Do not touch lamp at any time. Use a soft cloth. Oil from skin may
damage lamp.
6. Do not operate the luminaire tting with a missing or damaged shield.
SAVE THESE INSTRUCTIONS
Package Contents
Product Dimensions
- 3 -
A. (1) Fixture
B. (1) PVC Tube
8.25”
6.25”
5.5”
www.voltlighting.com
INSTALLATION INSTRUCTIONS
- 4 -
Wire Connection
2
Dig Hole
1
VOLT®RGBW Salty Dog Integrated LED Brass Well Light (Bronze)
VWL-7125-BBZ
3”
3”
3”
Dig a hole in the ground. Make
sure there is approximately 3
inches surrounding the PVC Tube
for pea gravel or sand on all sides.
PVC Tube
Hole
Soil
Place the xture into the PVC
Tube and pass the luminaire pigtail
through the PVC Tube.
Strip both leads from the luminaire
pigtail. Using two wire connectors
(sold separately), connect the leads
from the luminaire to the main
supply cable leads.
PVC Tube
Wire Connector
Main Supply Wire
Soil
Pigtail
Fixture
- 5 -
Fill Pea Gravel or Sand
3
Remove Luminaire from bracket
1
Soil
Install the PVC Tube with the
xture in the hole and ll
around the xture securing it in
place with pea gravel or sand to
allow for water drainage.
Now you can power on the
system, and the light is 2700K
and the optic is 60 degree as
default.
PVC Tube
with Fixture
Pea Gravel
or Sand
By using the Allen wrench,
loosen the screw in the handle
and remove the luminaire from
the bracket.
Luminaire
Allen
Wrench
Handle
Screw
Bracket
Install/Replace Opc
www.voltlighting.com
INSTALLATION INSTRUCTIONS
- 6 -
VOLT®RGBW Salty Dog Integrated LED Brass Well Light (Bronze)
VWL-7125-BBZ
Remove Faceplate and Lens
2
Replace Optic
3
Loosen all screws on the faceplate.
Remove the faceplate and lens from
the xture.
xture
Screw
Faceplate
Lens
xture
Screw
Loosen the screws and remove
the optic from the xture.
Install the new optic in the
xture. Make sure that you have
the optic properly aligned over
the LED board before tightening
down. Improper alignment when
tightening the screws can cause
the optic to break.
Optic
customersupport@voltlighting.com • 813.978.3700
- 7 -
Reinstall Luminaire to bracket
4
Remove the Battery compartment Cover
1
IR Remote (Oponal)
Place the luminaire between
the brackets. Pass previously
removed screws through the
handle and bracket. Thread the
screws back onto the luminaire.
Hand tighten until snug with the
Allen wrench.
Luminaire
Allen
Wrench
Handle
Screw
Bracket
1
2
3
Press the tab and rotate the battery
compartment cover to remove it
from the IR Remote.
Ta b
Cover
Backing
IR Remote
An IR Remote is optional for this xture. The IR remote requires two AAA
batteries.
INSTALLATION INSTRUCTIONS
www.voltlighting.com
- 8 -
Install Two AAA Batteries
2
Install the Battery Compartment Cover
3
VOLT®RGBW Salty Dog Integrated LED Brass Well Light (Bronze)
VWL-7125-BBZ
+
-
+-
Place two AAA batteries into the
battery compartment properly.
AAA Battery Battery
Compartment
Backing
IR Remote
1
2Place the battery compartment
cover back onto the IR Remote.
Ta b
Cover
Backing
IR Remote
customersupport@voltlighting.com • 813.978.3700
- 9 -
IR Remote Functions
4
OFF ON
R B
W
G
FLASH
FADE
SMOOTH
STROBE
2
3
4
1
5
6
7
8
1. On
2. O
3. Brightness Control
4. 16 color selections
5. Flash
• Mode 1: Repeats Red, Green,
Blue + color cycle for 1
second duration of each of
the seven colors within this
mode.
• Mode 2: Hit ash a second
time and this mode slowly
blends the same seven
colors from mode one,
mixing them together.
6. Strobe
• Mode 1: Pick any color on the remote, then press strobe and that
color will strobe every second alternating between on and o.
• Mode 2: Hit strobe a second time and this mode will strobe a
blended white color at the same speed as before.
7. Fade
• Mode 1: Pick any color on the remote, then press fade and that
color will slowly fade on and o every second.
• Mode 2: Hit fade a second time and it will fade a blended white
color on and o at the same speed as before.
8. Smooth
• Mode 1: Repeats a ash cycle of Red, Green, and Blue only.
• Mode 2: Hit smooth a second time and this mode slowly blends Red,
Green, and Blue only; on and o at the same speed.
INSTALLATION INSTRUCTIONS
www.voltlighting.com
- 10 -
VOLT®RGBW Salty Dog Integrated LED Brass Well Light (Bronze)
VWL-7125-BBZ
Tabla de contenidos
Otros manuales de Iluminación de paisajes de Volt
Volt
Volt VPL-1011-4-BBZ Manual de usuario
Volt
Volt All Star Mini Twinnovator Manual de usuario
Volt
Volt VAL-2101-0-BBZ Manual de usuario
Volt
Volt VWL-500-4-PBK Manual de usuario
Volt
Volt VPL- 398 Manual de usuario
Volt
Volt VFL-4501-4-BBZ Manual de usuario
Volt
Volt VWL-55 Series Instrucciones de funcionamiento y seguridad
Volt
Volt VDL-6007 Manual de usuario
Volt
Volt VPL-1019-26-4-BBZ Manual de usuario
Volt
Volt VFL-450X-BBZ Manual de usuario
Volt
Volt VAC-STK-PWR-PGR Manual de usuario
Volt
Volt Top Dog Innovator VPL-398 Manual de usuario
Volt
Volt VAL-1810-40-BBZ Manual de usuario
Volt
Volt VPL-1006 Manual de usuario
Volt
Volt VAL-91 Series Instrucciones de funcionamiento y seguridad
Volt
Volt VSPL-1045-BBZ-R1 Manual de usuario
Volt
Volt VFL-4027 Manual de usuario
Volt
Volt VFL-4002-ABZ Manual de usuario
Volt
Volt VAL-2010-BBZ Manual de usuario
Volt
Volt VAL-1004-4-BBZ Manual de usuario
Manuales populares de Iluminación de paisajes de otras marcas
Cooper Lighting
Cooper Lighting MCGRAW-EDISON WBG Manual de usuario
Cooper Lighting
Cooper Lighting Invue 42 - 175W Manual de usuario
Saxby Lighting
Saxby Lighting Islay 68784 Manual
LIGMAN
LIGMAN EU-10016-3 Manual de usuario
Cooper Lighting
Cooper Lighting McGraw-Edison ZD Credenza Manual de usuario
LIGMAN
LIGMAN KI-60475 Manual de usuario
