Viking Range VDSC530 Manual de usuario

Installation Guide

Range/Rangetop Rear Trim Accessories

& Range Curb Base Fronts

(Illustration II)

Grasp the trim on each end and carefully place in the channels (B) located at each rear corner of the

product. Align the screw holes (A) at each end of the trim device with the holes (A) in each rear channel

of the product. Secure with the 4 enclosed screws.

RANGETOP

REAR VIEW

RANGE REAR

VIEW

(Illustration I)

HIGH SHELF

Rear Trim Accessories

ATTACHING REAR TRIM (Illustration I)

ATTACHING SHELF ON HIGH-SHELF (Illustration II)

All rear trim devices are installed in the same basic way.

Place the top rolled edge (X) over the front lip of the high-shelf back trim and secure with the 4

enclosed screws, two at each end.

WARNING

To reduce the risk of fire or injury to

persons, check to make sure all packaging

has been removed from the outside and

inside parts of the rear trim device before

installing. MAKE SURE ALL CORRUGATED

MATERIAL IS REMOVED FROM INSIDE

THE HIGH SHELF.

NOTE: High shelf is already installed on

Designer models.

Rear Trim Accessories

Backguards come equipped with Nylon Spacers (See Figure 1), which are needed to space the

range off a combustible wall a prescribed safe distance.

Note: If the back wall is Non-

Combustible, these spacers can be

removed. (See Figure 2)

These spacers can also be removed if used with any

of the models listed below:

• 30”, 36” and 48” VGCC/CVGCC

• VDSC530/CVDSC530

• VDSC536/CVDSC36

• VGRT530/CVGRT530

• VGRT536/CVGRT536

ATTACHING BACKGUARD (Illustration III)

Figure 1

(Illustration III)

Figure 2

On VGSC530/CVGSC530, VGSC536/CVGSC536

and VGSC548/CVGSC548 models there is a

regulator cover supplied with the backguard that

must be attached to the oven, with the supplied

screws, before the backguard is attached.

(See Figure 3)

Figure 3

*If you have one of these models, the

spacers are not required, even if with

a combustible wall.

IMPORTANT: USE OF ISLAND TRIM WITH AND WITHOUT 6” (15.2 CM) CLEARANCE.

Normal installation for island trim on either a range or rangetop is in an island/peninsula or where there is a

minimum clearance of 6”(15.2 cm) to any type of wall at the rear of the unit. Ranges and rangetops with an

island trim installation can be installed at zero clearance to the rear wall as long as the wall is non-combustible.

The responsibility for ensuring that the rear wall is non-combustible and heat resistant lies with the individual

owner and/or end user. Only in those cases where the island trim is installed with 6” (15.2 cm) of minimum

clearance to a rear wall, or when a truly non-combustible material is used, will the warranty apply. In no case will

Viking Range, LLC accept responsibility for any claims which may result from heat damage against a rear wall,

including cosmetic damage. It is the total responsibility of the owner/end user to ensure that the material

utilized in such applications is not only non-combustible, but is also truly heat-resistant.

Once you determine whether or not your product needs the provided spacers, the backguard is ready

to be attached.

Simply slide the backguard down onto the rear of the unit and attach using the (4) screws provided.

(See Figure 5)

Figure 5

Rear Trim Accessories

Custom VGIC ranges and 60” VGCC ranges require that two 1” standoff spacers be attached to the

back of the range when using a range with a backguard against a combustible surface. (See Figure 4)

Figure 4

Curb Bases

Alternate Curb Base View

for Custom Ranges

STANDARD CURB BASE FRONT

1. The standard curb base front (A) is completely assembled.

2. Remove the assembly from the carton and simply clip onto the front range legs.

3. The assembly is adjustable about 2” (5.1 cm) front to back so that alignment with the cabinet

toe front is possible. Loosen brackets on each side, but allow snug fit. Clip assembly onto

range legs; determine front to back setting; remove, tighten bolts, and reattach.

Important Note: The range must be installed as specified in the range installation guide for proper

airflow when using the standard curb base.

CUSTOM CURB BASE FRONT

1. Remove the standard curb base front assembly from the carton.

2. Remove the front (A) from the mounting assembly (B).

3. Attach locally supplied front (C) to the mounting assembly (B) and simply clip onto the front

range legs.

Important Note: The locally supplied front must not be any taller than 3-1/8” (7.9 cm) tall. Fronts taller

than 3-1/8” (7.9 cm) could obstruct the airflow.

4. The assembly is adjustable about 2” (5.1 cm) front to back so that alignment with the cabinet

toe front is possible. Loosen brackets on each side, but allow snug fit. Clip assembly onto

range legs; determine front to back setting; remove, tighten bolts, and reattach.

Curb Bases

Important Note: The range must be installed as specified in the range installation guide for proper

airflow when using the custom curb base.

COUNTERTOP REAR TRIM

1. Locate screw hole openings (A) on back of island trim near the top.

2. Align screw hole openings on countertop rear trim with the ones on the back of the island trim.

3. Attach rear trim to island trim with enclosed screws.

Curb Bases

Viking Range, LLC

111 Front Street

Greenwood, Mississippi 38930 USA

(662) 455-1200

For product information

call 1-888-845-4641

F1448N EN (100113)

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Rango de Viking Range

Viking Range

Viking Range Tuscany TVDR3614B Manual de usuario

Viking Range

Viking Range CVER530 Manual de usuario

Viking Range

Viking Range Tuscany TVDR4806B Manual de usuario

Viking Range

Viking Range 5 Series VGC Manual de usuario

Viking Range

Viking Range VGR5304B Manual de usuario

Viking Range

Viking Range CVRT530 Manual de usuario

Viking Range

Viking Range VGRT736 Manual de usuario

Viking Range

Viking Range VERT301-4B Manual de usuario

Viking Range

Viking Range VGIC5302 Manual de usuario

Viking Range

Viking Range 5 Series VGC Manual de usuario

Viking Range

Viking Range VGR736 Manual de usuario

Viking Range

Viking Range VER5301 Manual de usuario

Viking Range

Viking Range CVGR5304B Manual de usuario

Viking Range

Viking Range 5 Series VGC Manual de usuario

Viking Range

Viking Range 3 Series Manual de usuario

Viking Range

Viking Range 30" W. Models Manual de usuario

Viking Range

Viking Range 5 Series VGC Manual de usuario

Viking Range

Viking Range VESC530 Manual de usuario

Viking Range

Viking Range TVDR3604B Manual de usuario

Viking Range

Viking Range VESC530-4B Manual de usuario

Viking Range

Viking Range Professional Series Manual de usuario

Viking Range

Viking Range Tuscany Series Manual de usuario

Viking Range

Viking Range VGIC5301 Manual de usuario

Viking Range

Viking Range RVGR Manual de usuario

Manuales populares de Rango de otras marcas

Samsung

Samsung FCQ321HTUW Manual de usuario

Kenmore

Kenmore 790.45712 Manual de usuario

Wolf

Wolf CHR CHSSR Manual de usuario

Smeg

Smeg Built-in Microwave Oven Manual de instrucciones

Zanussi

Zanussi ZCG054G Manual de usuario

Whirlpool

Whirlpool 8575985-W Manual de lista de piezas

Frigidaire

Frigidaire 316000635 Manual de usuario

GE JCSS630 Manual de usuario

Samsung

Samsung NX58M9960P series Manual de usuario

Hotpoint

Hotpoint RB524R Guía de instalación

Whirlpool

Whirlpool Roper FGP305KW3 Manual de usuario

Amana

Amana ART6610 SERIES Manual de usuario

Maytag

Maytag MERH770WB Manual de usuario

Fulgor Milano

Fulgor Milano SOFIA Manual de usuario

Premier

Premier EF-4358GH Manual de usuario

Kenmore

Kenmore 790.9010 Series Manual de usuario

KitchenAid

KitchenAid KESC300 Manual de usuario

Frigidaire

Frigidaire FFEF3012LS Guía del usuario