V-TAC VT-511S Manual de usuario

WEEE Number: 80133970

!WARNING

• Please make sure to turn off the power before starting the installation.

• Installation should only be performed by a certified electrician.

• The light source of this luminaire is not replaceable, when the light source reaches its end of

life the whole luminaire should be replaced.

• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively

replaced by the manufacturer or his service agent or a similar qualified person in order to avoid

a hazard.

• Make sure the local voltage is the same with the product before plugging into the power

supply.

• The unit is designed with replacement battery. Battery replacement should only be performed

by a qualified electrician.

• Forbid to use in the rain or outdoors.

• Daily check – check that the status GREEN LED indicator is illuminated

• Do not install this product on damp or newly plastered surfaces.

• Ensure all electrical connections are secure and that there are no loose strands.

• For Indoor Use Only

INSTALLATION INSTRUCTION

LED EMERGENCY LIGHT

INTRODUCTION & WARRANTY

Thank you for selecting and buying V-TAC product. V-TAC will serve you the best. Please read

these instructions carefully before starting the installation and keep this manual handy for future

reference. If you have any another query, please contact our dealer or local vendor from whom

you have purchased the product. They are trained and ready to serve you at the best. The

warranty is valid for 3 years from the date of purchase. The warranty does not apply to damage

caused by incorrect installation or abnormal wear and tear. The company gives no warranty

against damage to any surface due to incorrect removal and installation of the product. This

product is warranted for manufacturing defects only.

YEARS

WARRANTY *

IN CASE OF ANY QUERY/ISSUE WITH THE PRODUCT, PLEASE REACH OUT TO US AT: SUPPORT@V-TAC.EU

FOR MORE PRODUCTS RANGE, INQUIRY PLEASE CONTACT OUR DISTRIBUTOR OR NEAREST

DEALERS. V-TAC EUROPE LTD. BULGARIA, PLOVDIV 4000, BUL.L.KARAVELOW 9B

Model VT-511S

Was3.8W Max

Lumens 110LM

Output Voltage 4.5W

Ouput Power 1.2W

IP Rang IP20

Viewing Distance 22 Meters

Charging Time 12H

DischargeTime >4H

Charge Current (mA) 200mA

Discharge Current (mA) 360mA

Safety Classicaon II

Product Material ABS+PC

Baery 3.7V2000mAH Li-ion Baery

[REPLACEABLE]

Mode of Operaon Non-Maintained / Maintained

Input Power AC: 220-240, 50/60Hz

Legends Available 4 Ways Dierent Legends

Dimension

Dimension with Recessed Box

292x79x102mm

292x93.7x102mm

We do not recommend any modification

to this product. Any modification may

render the product to be unsafe and will

invalidate any Safety /Approvals.

PRODUCT FEATURES MODIFICATIONS

TECHNICAL DATA

• The product can use in Public place, Hotel,

Office Block, House and so on.

• Above the 40°C (104°F) or under the 0°C

(32°F), the efficacy of lighting will decline.

Emergency Luminaire Designation

X2A*C*E 180

Luminaires not suitable

for covering with

thermally insulating

material.

Caution, risk of

electric shock.

This marking indicates that this

product should not be disposed

of with other household wastes.

MULTI-LANGUAGE

MANUAL QR CODE

Please scan the QR code

to access the manual in

multiple languages.

NOTE: Jumper cap switching position has the functions of AC/DC (Maintained) and DC

(non-maintained). P1 is AC/DC position, P2 is DC position. (Refer to Picture F)

1. Switch off the main power before installation

2. Open the emergency light with a help of a screwdriver (Figure A).

3. Insert the Lead wires from the wall through the hole base cover as shown in (Figure B).

4. Install the base cover on the wall with the help of screws.

5. For connecting the wires, pull out the connector from the front cover, unscrew the

screws on them and connect the lead wires to PCB AC and green terminal.

6. Put back the connector on the front cover.

7. Place back the front cover on the base

8. Switch on the main power

INSTALLATION INSTRUCTIONS

I SURFACE MOUNTING (For wall only):

WALL MOUNTING FLUSH MOUNTING CEILING MOUNTING

THREE INSTALLATION METHODS

1. Switch off the main power before installation

2. Push the conduit of the recessed box with a screwdriver

3. Open the emergency light with a help of a screwdriver (Figure A).

4. Place the Recessed Box on the Wall cutting and Insert the Lead wires from the

wall through the Recessed box and base cover hole as shown in (Figure B).

5. For connecting the wires, pull out the connector from the front cover, unscrew the

screws on them and connect the lead wires to PCB AC and green terminal.

6. Put back the connector on the front cover.

7. Place back the front cover on the base

8. Switch on the main power

II RECESSED/FLUSH MOUNTING (For wall only):

RECESSED INSTALLATION METHODS

3. RECESSED

BOX

2. BASE

CONDUIT

1. REFLECTOR

FJUMPER CAP

P1 P2

1. If the AC power is normal, the green charging indicator will be ON which shows the

lamp is charging.

2. If a power failure occurs, the emergency light senses the AC power failure and

automatically switches to emergency mode. The emergency light will illuminate for a

minimum of 4 hours. When the AC power is restricted, the emergency light switches

the system back to normal mode and resumes battery charging.

OPERATION

Use a small cotton swab with cleaning alcohol to clean the unit, never use strong or

volatile chemicals to clean the unit as it will damage the plastic parts.

MAINTENANCE

CONNECTOR

Otros manuales para VT-511S

Tabla de contenidos

Otros manuales de Equipo de iluminación de V-TAC

V-TAC

V-TAC 11410 Manual de usuario

V-TAC

V-TAC VT-4225 Manual de usuario

V-TAC

V-TAC VT-7571 Manual de usuario

V-TAC

V-TAC VT-519-S Manual de usuario

V-TAC

V-TAC VT-11-R Manual de usuario

V-TAC

V-TAC VT-1140 Manual de usuario

V-TAC

V-TAC VT-559 Manual de usuario

V-TAC

V-TAC 8604 Manual de usuario

V-TAC

V-TAC VT-781 RD Manual de usuario

V-TAC

V-TAC VT-403 Manual de usuario

V-TAC

V-TAC VT-768 Manual de usuario

V-TAC

V-TAC VT-91100 Manual de usuario

V-TAC

V-TAC VT-519 Manual de usuario

V-TAC

V-TAC VT-ST42 Manual de usuario

V-TAC

V-TAC VT-522-S Manual de usuario

V-TAC

V-TAC VT-16010 Manual de usuario

V-TAC

V-TAC VT-13 Manual de usuario

V-TAC

V-TAC VT-1147 Manual de usuario

V-TAC

V-TAC VT-1134 Manual de usuario

V-TAC

V-TAC VT-45010 Manual de usuario

V-TAC

V-TAC VT-1607 Manual de usuario

V-TAC

V-TAC VT-967 Manual de usuario

V-TAC

V-TAC VT-1143 Manual de usuario

V-TAC

V-TAC VT-061 Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario