Ubiquiti LTU-Pro Manual de usuario

Tabla de contenidos

Otros manuales de Punto de acceso inalámbrico de Ubiquiti

Ubiquiti

Ubiquiti UniFi AP-AC PRO Manual de usuario

Ubiquiti

Ubiquiti RocketM Series Manual de usuario

Ubiquiti

Ubiquiti M900 Manual de usuario

Ubiquiti

Ubiquiti NanoBeam NBE2ACN Manual de usuario

Ubiquiti

Ubiquiti LiteBeam LBE-5AC-LR Manual de usuario

Ubiquiti

Ubiquiti AmpliFi MeshPoint HD Manual de usuario

Ubiquiti

Ubiquiti UniFi UAP--AC--HD Manual de usuario

Ubiquiti

Ubiquiti Bullet M5 HP Manual de usuario

Ubiquiti

Ubiquiti Loco5AC Manual de usuario

Ubiquiti

Ubiquiti UAP-AC-PRO Manual de usuario

Ubiquiti

Ubiquiti UniFi AP AC Lite Manual de usuario

Ubiquiti

Ubiquiti UAP-AC-M-PRO Manual de usuario

Ubiquiti

Ubiquiti LiteBeam LBE-5AC-16-120 Manual de usuario

Ubiquiti

Ubiquiti PBE-M5-300-US Manual de usuario

Ubiquiti

Ubiquiti Bullet Manual de usuario

Ubiquiti

Ubiquiti UF-Nano Manual de usuario

Ubiquiti

Ubiquiti UniFi UAP--AC--HD Manual de usuario

Ubiquiti

Ubiquiti UniFi AP FlexHD Manual de usuario

Ubiquiti

Ubiquiti airFiber 24 HD Manual de usuario

Ubiquiti

Ubiquiti UniFi UAP Manual de usuario

Ubiquiti

Ubiquiti IsoStation M5 Manual de usuario

Ubiquiti

Ubiquiti Rocket2AC Prism Manual de usuario

Ubiquiti

Ubiquiti NanoStation NSM365 Manual de usuario

Ubiquiti

Ubiquiti LiteBeam LBE-5AC-LR Manual de usuario

Manuales populares de Punto de acceso inalámbrico de otras marcas

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Manual de usuario

Cisco

Cisco Aironet 1550 Series Manual de usuario

Aruba

Aruba IAP-335 Manual de usuario

Advantek Networks

Advantek Networks AWN-AP-54MR Manual de usuario

IP-COM

IP-COM AP355 Manual de usuario

Buffalo

Buffalo AirStation WLA-L11G Manual de usuario

EnGenius

EnGenius EnStationACv2 Manual de usuario

D-Link

D-Link DAP-3662 Manual de usuario

xG Technology

xG Technology xMax CN1300 Manual de usuario

Widelink

Widelink ezWave WAP-1100 Series Manual de usuario

Edimax

Edimax CAP1200 Manual de usuario

Aruba

Aruba AP-203R Manual de usuario

LuXout Shades

LuXout Shades LUXSHADE MOTION Manual de usuario

CreatComm

CreatComm TB5F Manual de usuario

SineDigital

SineDigital MW-1500AP(H) Manual de usuario

TP-Link

TP-Link AP9650 V1 Manual de usuario

Draytek

Draytek VIGORAP 902 Manual de usuario

EnGenius

EnGenius EAP350 Manual de usuario

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

LTU-Pro Mount Bracket Bracket Clamp

Bracket Clamp Carriage Bolts (Qty. 2) Flange Nuts (Qty. 2)

Gigabit PoE (24V, 0.5A) with

Mounting Bracket

Power Cord

Package Contents

Installation Requirements

LTU PtMP AP, such as model LTU-Rocket

13 mm wrench

Surge protection should be used for all outdoor installations. We recommend that you use

two Ethernet Surge Protectors, model ETH-SP-G2, one near the device and the other at the

entry point to the building. The ETH-SP-G2 will absorb power surges and safely discharge

them into the ground.

Note: For guidelines about grounding and lightning protection, follow your local

LTU-Pro Quick Start Guide

×

Click for

Table of Contents

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

electrical regulatory codes.

Outdoor, shielded Category 6 (or above) cabling and shielded RJ45 connectors are

required for all wired Ethernet connections.

Hardware Overview

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

Reset Button

USB-C Port

5 GHz LED

To reset to factory defaults, press and hold the Reset button for more than 10 seconds

while the device is powered on.

Reserved for future use.

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

GPS LED

UNMS LED

LAN LED

Power LED

PoE In [24V] Port

Blue The LED will light blue when the link is active.

Blue

The LED will light blue when the GPS signal strength is

sufficient. This requires a minimum of three satellite

connections.

Flashing White Bootup in progress.

White

Ready for use, not connected to Ubiquiti® Network

Management System (UNMS™). See “UNMS

Management”.

Blue Ready for use, connected to UNMS.

Steady Blue with Occasional

Flashing

Ready for use, unable to connect to UNMS, check

connection to UNMS server.

Quickly Flashing Blue Used to locate a device in UNMS.

Alternating

Blue/White Firmware upgrade in progress.

Blue

The LED will light steady blue when an active Ethernet

connection is made to the Ethernet port and flash when

there is activity.

Blue The LED will light blue when the device is connected to a

power source.

This 10/100/1000 Ethernet port is used to connect the power and should be connected to

the LAN and DHCP server. Default IP address: 192.168.1.20

Pole Mounting

1.

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

2.

3.

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

4.

5.

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

6.

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

7.

8.

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

9.

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

10.

Connecting Power

WARNING: The switch port must comply with the power specifications listed in the

“Specifications”.