Tripp Lite ISOBAR6ULTRAHG Manual de usuario
Owner’s Manual
1111 W. 35th Street Chicago, IL 60609 USA
Customer Support: (773) 869-1234 • www.tripplite.com
Important Safety Instructions 2
Quick Installation 2
Troubleshooting 3
Specifications 4
Warranty 4
Isobar®
Model: ISOBAR6ULTRAHG
Premium Surge Suppressor (120V)
Copyright © 2003 Tripp Lite. All rights reserved. Isobar®is a registered trademark of Tripp Lite.
Español 5
Français 9
200304051 ISOBAR6ULTRAHG Owner’s Manual Update.qxd 4/17/2003 12:24 PM Page 1
2
• Do not use with life support applications. Do not use in the presence of a flammable
anaesthetic mixture with air, oxygen or nitrous oxide.
• Install your surge suppressor indoors, away from excess moisture, heat and dust.
• Connect your surge suppressor to a three-wire, grounded AC power outlet. Do not
remove or modify the ground pin of the surge suppressor's plug. Do not use two-prong
adapters with the surge suppressor's plug.
• Your surge suppressor does not require maintenance. Do not open your surge suppressor
for any reason. There are no user-serviceable parts inside.
Important Safety Instructions
Quick Installation
Plug surge suppressor into a
three-wire, grounded 120V
electrical outlet.
The surge suppressor cannot provide full protection
unless it is plugged into a properly wired and
grounded outlet. The ISOBAR6ULTRAHG
features a hospital grade plug and outlets. Grounding
continuity should be checked periodically.
Grounding reliability can only be achieved
when the ISOBAR6ULTRAHG is connected
to an equivalent grounded receptacle marked
“Hospital-Only” or “Hospital-Grade.”
Flip surge suppressor’s ON - OFF
switch ON (switch will light up).
When this switch is lit, it indicates that AC
power is enabled at the surge suppressor's outlets.
Plug the power cords of your
electrical equipment into your
surge suppressor’s outlets.
DO NOT OVERLOAD the Surge Protector.
Each outlet can handle up to 15 amps, but
do not exceed a total load of more than 15
amps for all outlets. If the circuit breaker
trips, the outlets will cease to provide
power. Remove overload and depress circuit
breaker to reset.
Your electrical equipment is now protected
from AC surges on the power line.
3
2
1
1
2
3
These devices feature an internal protection that will disconnect
the surge protective component at the end of its useful life but
will maintain power to the load—now unprotected.
200304051 ISOBAR6ULTRAHG Owner’s Manual Update.qxd 4/17/2003 12:25 PM Page 2
3
Troubleshooting
PROBLEM
Your circuit breaker trips.
Your Isobar is overloaded.
The green “Protection
Present” and/or “Line OK”
LED(s) do not light.
Your equipment is not fully protected against
surges or there is a wiring fault in your wall
outlet.
The red “Fault” LED lights when
you first plug in your Isobar.
There is a wiring fault in your wall outlet.
(Phases are reversed, ground is missing, etc.)
The red “Fault” LED lights after
continued use of your Isobar.
Your Isobar may have been damaged by a surge.
Equipment plugged into the
Isobar exhibits audio static or
video “snow.”
Some equipment may be generating electrical
interference.
SOLUTION
Unplug some equipment. Wait one minute
while your Isobar cools, then push the circuit
breaker button back in.
Make sure that power is available at the wall
outlet, the power switch is on and lit, and the
Isobar is completely plugged in.
Have a qualified electrician fix the fault
immediately. NOTE: A loose wall outlet may
cause the “Fault” LED to light. Your Isobar
will identify most wiring faults, but may not
identify every possible type of fault.
Have a qualified electrician examine your
outlet to determine if a fault has developed.
If no fault exists, contact Tripp Lite for service.
Plug your equipment into outlets not directly
across from each other and plug equipment
with heavy power draws (such as printers) into
outlets away from monitors and AV equipment.
200304051 ISOBAR6ULTRAHG Owner’s Manual Update.qxd 4/17/2003 12:25 PM Page 3
4
ISOBAR6ULTRAHG*
AC Energy Absorption (Joules): 600
Rated Input Voltage: 105 to 135V AC; 60 Hz; (120V AC nominal)
AC Outlets: 6 NEMA 5-15R HG hospital grade
AC Line Cord: 15', 14 gauge, 3-conductor grounded with
NEMA 5-15PHG hospital grade plug
Controls: Illuminated RED “ON/OFF” switch
Transient Response Time: Instantaneous**
* UL 1449 Listed (330V let-through, 1998). ** Transient amplitude reduction occurs faster than the clamp response of the varistors because
of the high rejection rate of the ISOBAR filter networks.
Specifications
Warranty
LIFETIME LIMITED WARRANTY
TRIPP LITE warrants its products to be free from defects in materials and workmanship for life. TRIPP LITE's obligation under this warranty is limited to repairing
or replacing (at its sole option) any such defective products. To obtain service under this warranty, you must obtain a Returned Material Authorization (RMA)
number from TRIPP LITE or an authorized TRIPP LITE service center. Products must be returned to TRIPP LITE or an authorized TRIPP LITE service center
with transportation charges prepaid and must be accompanied by a brief description of the problem encountered and proof of date and place of purchase.
This warranty does not apply to equipment which has been damaged by accident, negligence or misapplication or has been altered or modified in any way.
The warranties of all TRIPP LITE surge suppressors are null and void if they have been connected to the output of any UPS system. The warranties of all
TRIPP LITE UPS Systems are null and void if a surge suppressor has been connected to its output receptacles.
EXCEPT AS PROVIDED HEREIN, TRIPP LITE MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE. Some states do not permit limitation or exclusion of implied warranties; therefore, the aforesaid limitation(s)
or exclusion(s) may not apply to the purchaser.
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL TRIPP LITE BE LIABLE FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL
DAMAGES ARISING OUT OF THE USE OF THIS PRODUCT, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. Specifically, TRIPP LITE is
not liable for any costs, such as lost profits or revenue, loss of equipment, loss of use of equipment, loss of software, loss of data, costs of substitutes, claims
by third parties, or otherwise.
The policy of TRIPP LITE is one of continuous improvement. Specifications are subject to change without notice.
200304051 ISOBAR6ULTRAHG Owner’s Manual Update.qxd 4/17/2003 12:25 PM Page 4
Otros manuales para ISOBAR6ULTRAHG
2
Tabla de contenidos
Otros manuales de Protector contra sobretensiones de Tripp Lite
Tripp Lite
Tripp Lite TLP808 Manual de usuario
Tripp Lite
Tripp Lite ISOBAR 4/220 Manual de usuario
Tripp Lite
Tripp Lite TLP808TEL Manual de usuario
Tripp Lite
Tripp Lite CCIEURO Manual de usuario
Tripp Lite
Tripp Lite TRAVELERC8 Manual de usuario
Tripp Lite
Tripp Lite Protect It! TLP26USBB Manual de usuario
Tripp Lite
Tripp Lite TLP606USB Manual de usuario
Tripp Lite
Tripp Lite TLP2USBD Manual de usuario
Tripp Lite
Tripp Lite TLP808NETG Guía de configuración
Tripp Lite
Tripp Lite TLM626TEL15 Manual de usuario
Tripp Lite
Tripp Lite MT-6PLUS Manual de usuario
Tripp Lite
Tripp Lite Network Dataline Surge Suppressors Manual de usuario
Tripp Lite
Tripp Lite 93-2243 Manual de usuario
Tripp Lite
Tripp Lite Surge Suppressor SWIVEL6 Manual de usuario
Tripp Lite
Tripp Lite Protect It! SK6-6/SPIKEBAR Manual de usuario
Tripp Lite
Tripp Lite SUPER6TEL12 Manual de usuario
Tripp Lite
Tripp Lite ISOBAR6ULTRA Manual de usuario
Tripp Lite
Tripp Lite SPIKESTIK Manual de usuario
Tripp Lite
Tripp Lite IBAR4 Manual de usuario
Tripp Lite
Tripp Lite HT810ISOCTR Manual de usuario
