Tripp Lite SmartRack SR4POST48HD Manual de usuario
1
Assembly Instructions
SmartRack® 4-Post
Heavy-Duty Open Frame Racks
Models: SR4POST48HD, SR4POST50HD, SR4POST52HD, SR4POST58HD
1111 West 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
Copyright © 2014 Tripp Lite. All trademarks are the sole property of their respective owners.
PROTECT YOUR INVESTMENT!
Register your product for quicker service and ultimate peace of mind.
You could also win an ISOBAR6ULTRA surge protector—a $50 value!
www.tripplite.com/warranty
2
Parts List
Front Upright Rear Upright Top Flange Base Flange Horizontal Beam PDU Bracket
M10 Acorn Nut M10 Flat Washer M6x12 Phillips
Head Screw
M6x16mm Hex
Head Screw
M6 Hex Nut M6 Flat Washer Caster
A B C D E F
G H I J K L M
x2x2 x4
x16 x16 x4 x16 x16 x32 x4
x2x2 x2
Required tools (User Supplied):
• Phillips Head Screwdriver
• 16 mm Open End Wrench
WARNING: The rack enclosure is extremely heavy. Do not attempt to unpack, move, assemble or install the
enclosure without assistance. Until it has been properly assembled and stabilized, the enclosure is prone to
tipping and could cause property damage and/or personal injury. Use extreme caution when assembling
the enclosure. Do not attempt to install equipment without first stabilizing the enclosure.
SRCASTER Kit (Optional, Sold Separately)
3
1
2
step
step
A B
E
C
G
H
Lay out parts
on the floor or a
stable work surface
and assemble as
shown.
Attach the washers and acorn
nuts, but leave them loose.
This will allow the unit to flex
later in the assembly process.
1 1
2
2
4
4
4
3
4
step
step
D
E
G
H
Attach the washers
and acorn nuts, but
leave them loose.
2
2
4
4
5
5
6
step
step
Lay rear upright on the
unit. Pull apart the base
flange and horizontal
beam 1. Align the
holes at the end of the
upright with the studs
in the horizontal beam
and push the upright
onto the beam 2. Push
the base flange and
horizontal beam back
together.
Attach the
washers and
acorn nuts, but
leave them
loose.
G
H
4
4
A B
1 1
Repeat steps 5 & 6 to attach front upright.
Repeat this process for the other end of the upright.
x2
2
1
6
7
8
step
step
Using an open
end wrench (user-
supplied), tighten
all acorn nuts
firmly. Place the
rack upright on a
level surface and
confirm it’s stable.
(Optional)
Attach PDU
Brackets
F
I
2
4
x16
7
(Optional)
Attach Casters
Warning: Do not
attempt to install
casters while
equipment is
installed in the rack.
Note:
Installation requires
Tripp Lite’s Heavy-
Duty Rolling Caster
Kit (model SRCASTER,
sold separately)
9
step
J
K
L
M
16
16
32
4
x4
Configuration 1 Configuration 2
814-08-120 • 9333B4_revA
1111 West 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
10
Warranty and Product Registration
step
(Optional)
Attach Side Panels
(sold separately)
SR4POST48HD
SR4POST50HD
SR4POST52HD
SR4POST58HD
x2
x2
5-Year Limited Warranty
Seller warrants this product, if used in accordance with all applicable instructions,to be free from original defects in material and workmanship for a period of 5 years from the date
of initial purchase. If the product should prove defective in material or workmanship within that period, Seller will repair or replace the product, in its sole discretion.
THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT, MISUSE, ABUSE OR NEGLECT. SELLER MAKES NO EXPRESS WARRANTIES OTHER THAN
THE WARRANTY EXPRESSLY SET FORTH HEREIN.EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES, INCLUDING ALL WARRANTIES OF MERCHANTABILITY
OR FITNESS, ARE LIMITED IN DURATION TO THE WARRANTY PERIOD SET FORTH ABOVE; AND THIS WARRANTY EXPRESSLY EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL DAMAGES.
(Some states do not allow limitations on how long an implied warranty lasts, and some states do not allow the exclusion or limitation of incidental or consequential damages, so the above
limitations or exclusions may not apply to you.This warranty gives you specific legal rights, and you may have other rights which vary from jurisdiction to jurisdiction).
WARNING:The individual user should take care to determine prior to use whether this device is suitable, adequate or safe for the use intended. Since individual applications are
subject to great variation, the manufacturer makes no representation or warranty as to the suitability or fitness of these devices for any specific application.
Product Registration
Visit www.tripplite.com/warranty today to register your new Tripp Lite product.You’ll be automatically entered into a drawing for a chance to win a FREE Tripp Lite product!*
* No purchase necessary.Void where prohibited. Some restrictions apply. See Web site for details.
Tripp Lite follows a policy of continuous improvement.Product specifications are subject to change without notice.
SR48SIDE4PHD
SR50SIDE4PHD
SR52SIDE4PHD
SR58SIDE4PHD
Este manual sirve para los siguientes modelos
3
Otros manuales de Rack y soporte de Tripp Lite
Tripp Lite
Tripp Lite DDR1730TAL Manual de usuario
Tripp Lite
Tripp Lite DDR1527SDC Manual de usuario
Tripp Lite
Tripp Lite SRWF12U38 Manual de usuario
Tripp Lite
Tripp Lite DWT3770X Manual de usuario
Tripp Lite
Tripp Lite DWM3770X Manual de usuario
Tripp Lite
Tripp Lite 1U Manual de usuario
Tripp Lite
Tripp Lite DMCS3780HDS Manual de usuario
Tripp Lite
Tripp Lite DMR1015X3 Manual de usuario
Tripp Lite
Tripp Lite DCTM Manual de usuario
Tripp Lite
Tripp Lite DMPDS3255CF Manual de usuario
Tripp Lite
Tripp Lite DWM2342M Manual de usuario
Tripp Lite
Tripp Lite DWTSC3780MUL Manual de usuario
Tripp Lite
Tripp Lite DDR1327SQFC-1 Manual de usuario
Tripp Lite
Tripp Lite SmartRack SR25UBEXPKD Manual de usuario
Tripp Lite
Tripp Lite DMPDS3255F Manual de usuario
Tripp Lite
Tripp Lite DWT2655XE Manual de usuario
Tripp Lite
Tripp Lite DMPDT1732AM Manual de usuario
Tripp Lite
Tripp Lite AG-0072 Manual de usuario
Tripp Lite
Tripp Lite SmartRack SRDUCTN7009 Manual de usuario
Tripp Lite
Tripp Lite SmartRack NEMA 3R Manual de usuario
