TRENDnet TPL-110AP - 125Mbps 802.11g Wireless Powerline Access... Manual de usuario
Copyright ©2005. All Rights Reserved. TRENDware International, Inc.
TRENDnet
TRENDware, USA
What's Next in Networking
TPL-110AP
Version 07.12.2005
54Mbps 11g Wireless Powerline Access Point Quick Installation Guide
Point d'accès Powerline sans fil 11g 54Mbps
Guide d'installation rapide
Drahtloser 54 MBit/s 11g Powerline Access Point
Kurzanleitung zur Installation
Punto de acceso Powerline inalámbrico 11g a 54Mbps
Guía de instalación rápida
Table of Contents
English ......................................................................................................
Troubleshooting...........................................................................................
1
1
2
3
5
8
1. Prepare for Installation ......................................................................
2. Install Hardware ................................................................................
3. Configure TCP/IP Settings ................................................................
4. Configure the Access Point ...............................................................
Thank you for purchasing TRENDnet's TPL-110AP 802.11g Powerline Access
Point
This guide will help you set-up your Access Point quickly and easily. Just follow
the step-by-step instructions below, and enjoy the benefits of accessing the
Internet without ever being tied down to wires! If you run into problems, please
refer to the Troubleshooting section. If you need further technical support,
please visit www.TRENDNET.com or call technical support by phone.
Verify Equipment
Before setting up the Access Point, you should have:
1. A Computer with a Wired (RJ45) network card and a powerline adapter or
Wireless network card.
2. TCP/IP protocol installed on the Computer.
3. A Web Browser such as Internet Explorer (5.0 or higher) or
Netscape Navigator (4.7 or higher).
Verify Package Contents
Please make sure you have everything in the box:
1
CD-ROM (User’s Guide) Quick Installation Guide
TPL-110AP
1. Prepare for Installation
English QIG
English
Copyright ©2005. All Rights Reserved. TRENDware International, Inc.
TRENDnet
TRENDware, USA
What's Next in Networking
TPL-110AP
Version 07.12.2005
54Mbps 11g Wireless Powerline Access Point Quick Installation Guide
Point d'accès Powerline sans fil 11g 54Mbps
Guide d'installation rapide
Drahtloser 54 MBit/s 11g Powerline Access Point
Kurzanleitung zur Installation
Punto de acceso Powerline inalámbrico 11g a 54Mbps
Guía de instalación rápida
2
1. Locate an optimum location for the Access Point. The best place for the
Access Point is usually at the center of your wireless network.
2. Plug the TPL-110AP into an available Power Outlet. DO NOT plug the TPL-
110AP into a Power Surge protector.
2. Install Hardware
Make sure the front panel lights are on: Power, WLAN.
Verify Hardware Installation
NOTE: If you are using a wired computer to configure the Access Point,
please connect this computer to your Powerline Router.
2
English
POWER
WLAN
3
3. Configure TCP/IP Settings
Before the Access Point can be accessed and configured, the computer's
TCP/IP settings need to be changed. (That also includes your wireless card's
IP address)
English
Windows 2000/XP
1. Find the Start button located on the Desktop.
2. Click Start, and click on Control Panel. For Windows 2000, click Start,
highlight Settings, and click Control Panel.
3. Double-Click the Network Connection icon.
4. Right-Click on the Local Area Connection icon, then click on Properties.
The Local Area Connection Properties box will appear.
4
6. Click on Use the following IP address. Enter 10.0.0.50 for IP
address and 255.255.255.0 for Subnet, then click OK.
7. Click OK.
8. Your computer is now ready to access and configure the Access Point.
5. Under the General tab, locate and select Internet Protocol TCP/IP and
then click Properties. The Internet Protocol (TCP/IP) Properties box will
appear.
English
5
4. Configure the Access Point
From a Wired Computer
1. Open a web browser (Internet Explorer or Netscape) and enter
http://10.0.0.3 at the address bar, then press the Enter key. Type admin for
your username, and type admin for your password.
If you are configuring the TPL-110AP through a powerline computer, follow
steps 1-3. If you are configuring the TPL-110AP through a wireless computer,
follow steps 4-7.
English
6English
2. Click Wireless. Enter any AP Name for your Access Point. Create a SSID
that your wireless network will be using, and select a channel. (For example:
Wireless AP, Home AP, or Office AP). Scroll down to the bottom of the page
and click Apply.
3. Click LAN. If your current network belongs to a different network segment
(i.e. 192.168.0.1~254), please type an IP address, and Subnet Mask. Click
Apply. If you are content with the TPL-110AP's current settings, please
proceed to the next section. .
7English
From a Wireless Computer
(using TRENDnet's TEW-501PC as example in this section)
The default settings of the Access Point are:
SSID - default
Channel - 11
4. On your wireless computer, open up your Wireless Utility Program.
5. Click AP List, select default, and click Connect.
6. Click Link Information and verify that your wireless PC is communicating
with the TPL-110AP.
7. Go to the beginning of section 4. Configure the Access Point and follow
steps 1-3.
8
Troubleshooting
Q1:
A1:
Q2:
A2:
Q3.
A3:
Q4.
A4:
I specified the IP address http://10.0.0.3 in my internet browser's
address bar, but error message says "The page cannot be displayed".
How can I get into the TPL-110AP’s web configuration page?
Please check your hardware and TCP/IP settings again by following
the instructions in sections 1~3. Make sure that the Power and WLAN LEDs
are lit, and the TCP/IP configurations are correct. Afterwards, try accessing
http://10.0.0.3 again.
If my network's IP is different than the Access Point's range, what
should I do?
You should still configure the access point first. After all the settings
are applied, go to the Access Point's configuration page, click on TCP/IP
settings and change an IP address for the Access Point to match your
network's IP.
After I successfully configured the Access Point to meet my network
settings, I cannot connecting to my network using wireless computers.
If you have a DHCP server in your network, you need to go into TCP/IP
settings again and re-select "Obtain an IP automatically" for
Windows 98/ME and "Obtain an IP Address automatically" for Windows
2000/XP to allow the PC to regain an IP address from your DHCP server.
All the settings are set correct, but I still can't use the Access Point,
what should I do?
You can find additional information in the User's Guide. If you still have
Problems, contact our Technical Support by email or phone.
Certifications
This equipment has been tested and found to comply with FCC and CE Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received.
Including interference that may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
Otros manuales para TPL-110AP - 125Mbps 802.11g Wireless Powerline Access...
3
Otros manuales de Punto de acceso inalámbrico de TRENDnet
TRENDnet
TRENDnet TEW-450APB - Wireless Super G Access Point Manual de usuario
TRENDnet
TRENDnet TEW-735AP Manual de usuario
TRENDnet
TRENDnet TEW-455APBO - 9dBi High Power Wireless Outdoor PoE Access... Manual de usuario
TRENDnet
TRENDnet TEW-753DAP Manual de usuario
TRENDnet
TRENDnet TEW-610APB Manual de usuario
TRENDnet
TRENDnet TEW-809UB(V1) Manual de usuario
TRENDnet
TRENDnet TEW-814DAP Manual de usuario
TRENDnet
TRENDnet TEW-638APB Manual de usuario
TRENDnet
TRENDnet TEW-821DAP Manual de usuario
TRENDnet
TRENDnet TEW-690AP Manual de usuario
TRENDnet
TRENDnet TEW-230APB Manual de usuario
TRENDnet
TRENDnet TEW-814DAP Manual de usuario
TRENDnet
TRENDnet TEW-310APB Manual de usuario
TRENDnet
TRENDnet TEW-412APBO Manual de usuario
TRENDnet
TRENDnet TEW-630APB - Wireless Access Point Manual de usuario
TRENDnet
TRENDnet TEW-WLC100 Manual de usuario
TRENDnet
TRENDnet TEW-638APB Manual de usuario
TRENDnet
TRENDnet TEW -739APBO Manual de usuario
TRENDnet
TRENDnet TEW-610APB Manual de usuario
TRENDnet
TRENDnet TEW-815DAP Manual de usuario
