TRENDnet TPE-082WS Manual de usuario
TPE-082WS (V1)
Quick Installation Guide
Table of Contents
1 English
1. Before You Start
2. Hardware Installation and Configuration
ENGLISHFRANÇAISDEUTSCH
ESPAÑOLРORTUGUÊS
1
1. Before You Start
Package Contents
ŸTPE-082WS
ŸQuick Installation Guide
ŸCD-ROM (Utility and User's Guide)
ŸPower adapter
ŸRack mount kit
Minimum Requirements
ŸComputer with an Ethernet port and web browser
ŸNetwork cable
Optional Equipment
ŸEIA standard 19” rack
ŸSFP modules (e.g. TE100-MGBFX, TEG-MGBSX, TEG-MGBS10, TEG-MGBS40, TEG-MGBS80)
2. Hardware Installation and Configuration
3. Assign a Static IP address to your computer's network adapter in the subnet of 192.168.10.x
(e.g. 192.168.10.25) and a subnet mask of 255.255.255.0.
4. Open your web browser, type the IP address of the switch in the address bar, and then press
Enter. The default IP address is 192.168.10.200.
2
http://192.168.10.200
http://192.168.10.200
1
2
TPE-082WS
ENGLISHFRANÇAISDEUTSCH
ESPAÑOLРORTUGUÊS
5. Enter the User name and Password, and then click Login. By default:
User Name: admin
Password: admin
Note: User Name and Password are case sensitive.
3
6. Click System and then click IPv4 Setup.
7. Configure the switch to match the requirements of your network. Then click Apply to save
changes.
8. Click OK.
WARNING
The management session will be disconnected. Use new
IP address to connect to device.
Cancel
OK
OK
Switch Info
System
§ System Management
§ IPv4 Setup
§ IPv6 Setup
§ IPv6 Neighbor
§ IP Access List
§ Administration
§ Timeout
§ System Time
§ SSL
§ DHCP Auto Configuration
§ DNS
IPv4 Setup
System MAC
Address:
System IP Address:
System Subnet
Mask:
System Default
Gateway:
System IP Mode:
00:01:02:03:04:05
192 168 10 200
. ..
. ..
. ..
255 255 255 0
0000
Apply
Static
IPv4 Setup
Note:
1. If you would like to easily discover all the Web Management Switches on the network, assign
IP address, change password, then install the Web Smart Switch Management Utility. Follow
the steps provided on the user's guide.
2. To download the latest version of the user's guide and the utility, please go to
http://www.trendnet.com/support and select the TPE-082WS within the Products Download
dropdown list.
10. Click Save Settings to Flash (button).
11. Click OK.
4
WARNING
Save configuration finished.
OK
9. In the left hand panel, click Tools, click on Configuration, and click Save.
Save
Save Settings to Flash
Product Information:
Product Name:
Model Number:
Trade Name: TRENDnet
Manufacturer’s Name and Address
TRENDnet, Inc.
20675 Manhattan Place
Torrance, CA 90501 USA
Zwolsestraat 156 2587 WB
The Hague The Netherlands
TPE-082WS
10-Port Gigabit Web Smart PoE+ Switch
Safety
EN 55032:2012+AC: 2013 (CISPR32:2012) (Class A)
EN 61000-3-2:2014
EN 61000-3-3:2013
EN 55024:2010
AS/NZS CISPR 32:2013
Directives
Date: June 08, 2017
Title: Director of Technology
Person responsible for this declaration.
Place of Issue: Torrance, California, USA
Name: Sonny Su
Signature:
EMC Directive 2014/30/EU
RoHS Directive 2011/65/EU
WEEE Directive 2012/19/EU
REACH Regulation (EC) No. 1907/2006
Low Voltage Directive 2014/35/EC
TRENDnet hereby declare that the product is in compliance with the essential requirements
and other relevant provisions under our sole responsibility.
EN 60950-1:2006+A11:2009+A1:2010+A12:2011+A2:2013
EMC
This product is herewith confirmed to comply with the Directives
Certifications
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received.
Including interference that may cause undesired operation.
TRENDnet
20675 Manhattan Place
Torrance, CA 90501
USA
Applies to PoE Products Only: This product is to be connected
only to PoE networks without routing to the outside plant.
Note
The Manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this
equipment. Such modifications could void the user’s authority
to operate the equipment.
Advertencia
En todos nuestros equipos se mencionan claramente las
caracteristicas del adaptador de alimentacón necesario para
su funcionamiento. El uso de un adaptador distinto al
mencionado puede producir daños fisicos y/o daños al equipo
conectado. El adaptador de alimentación debe operar con
voltaje y frecuencia de la energia electrica domiciliaria exitente
en el pais o zona de instalación.
Product Warranty Registration
Please take a moment to register your
product online. Go to TRENDnet’s website at:
www.trendnet.com/register
Technical Support
If you have any questions regarding the product
installation, please contact our Technical Support.
Toll free US/Canada: 1-866-845-3673
Regional phone numbers available
at www.trendnet.com/support
Waste electrical an electronic products must not
be disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or Retailer for recycling advice.
Copyright © 2017. All Rights Reserved. TRENDnet. TPE-082WS (V1) / 06.08.2017
Tabla de contenidos
Otros manuales de Cambiar de TRENDnet
TRENDnet
TRENDnet TI-G50 Manual de usuario
TRENDnet
TRENDnet TK-204K Manual de usuario
TRENDnet
TRENDnet TK-222DVK Manual de usuario
TRENDnet
TRENDnet TK-217i Manual de usuario
TRENDnet
TRENDnet TPE-S88 - Web Smart PoE Switch Manual de usuario
TRENDnet
TRENDnet TEG-2248WS - Gigabit Web Smart Switch Manual de usuario
TRENDnet
TRENDnet TE100-SK1 Manual de usuario
TRENDnet
TRENDnet TEG-S240TX - DATA SHEETS Manual de usuario
TRENDnet
TRENDnet TPE-S44 - Switch Manual de instalación y operación
TRENDnet
TRENDnet TPE-P521ES Manual de usuario
TRENDnet
TRENDnet TE100-S1212 Manual de usuario
TRENDnet
TRENDnet TEG-224WSplus Manual de usuario
TRENDnet
TRENDnet TE100-S24V Manual de usuario
TRENDnet
TRENDnet TK-408K Manual de usuario
TRENDnet
TRENDnet TU3-H4E Manual de usuario
TRENDnet
TRENDnet TEG-240WS Manual de usuario
TRENDnet
TRENDnet TEG-S5g - Gigabit GREENnet Switch Manual de usuario
TRENDnet
TRENDnet TEG-S811Fi Manual de usuario
TRENDnet
TRENDnet TPE-S80 Manual de usuario
TRENDnet
TRENDnet TPE-S80 Manual de usuario
