TRENDnet 15-AH28B Manual de usuario

15AH-28B

Quick Installation Guide

English

Version 02.27.2007

1. Before you start

Installation Requirements

15AH-28B

Quick Installation Guide

Wall Mount

Package Contents

Internet Camera Server (e.g. TV-IP100, TV-IP201, TV-IP301)

Dry Wall or Wood surface

Power Cord

Knife or box cutter

Wire Stripper

Screwdriver

Pliers

Electrical Tape

RJ-45 cable

RJ-45 Jack

The following items below are not included. Users must provide the items

themselves. Make sure to have each item on hand before installation.

*Note: You must know how to terminate a network cable with an RJ-45 connector

in order to install a wired internet camera server into the 15AH-28B. If you do not

know how to terminate a network cable with an RJ-45 connector, please consult a

network professional.

Fasteners, washers and wall

mount screws

2. Hardware Installation

English

2. Remove the metal bracket from

the camera enclosure by

unscrewing the four screws. Save

these screws. You will need to use

these screws later.

1. Lift up the latch and pull the roof

upward.

Note: Configure your Internet Camera Server to match your network settings

before installing the device.

3. Use the following 2 sets of screws

and washers to mount the metal

bracket onto the base of the

Internet Camera Server. The

screws and washers can be found

in the plastic bags included with

the 15AH-28B.

English

5. Remove the circuit board from the

camera enclosure by unscrewing

the two screws. Save these

screws. You will need to use these

screws later.

4. Flip over the camera housing and

remove the rubber stoppers and

washers.

7. Cut the rubber insulation using a

knife or box cutter.

6. Take a power cord and cut it using

a wire cutter. Cut it near the female

end of the power cord. Note: The

power cord is not included with

15AH-28B.

English

8. Remove the insulation with pliers.

9. Run the power cord through the

rubber stopper.

10. Insert the power cord through the

hole and securely screw in the

rubber stopper.

11. Insert the wires of the power cord

into the power receptacle. Make

sure the green and white wires

match up. Make sure the black

wires matches up with the orange

wires. Then use a screwdriver to

secure the wires.

English

12. Mount the Internet Camera

Server inside the camera

enclosure with the screws.

Temporarily leave one hole

unscrewed. This example shows

a TRENDnet TV-IP100W.

13. Ground the green wire on the

15AH-28B. Then screw in the last

hole.

14. Take the camera's power adapter

and cut about 7 inches from the

end the power connector using

the wire cutter. Note: This is the

AC/DC adapter that is included

with your Internet Camera Server.

15. Take a knife or box cutter and cut

along the middle to split the cable.

16. Cut the rubber insulation using a

knife or box cutter, then remove

the insulation with pliers to

expose the copper wiring.

English

18. Insert the power adapter, RJ-45

Ethernet Cable through the

rubber stopper screw it in

securely.

17. Run the power adapter and the

RJ-45 Ethernet cable from the

base to the top of the mounting

arm. Make sure to leave one end

of the RJ-45 Ethernet cable

unterminated.

19. Connect the two ends of the

power adapter back by twisting

the copper wiring. Make sure you

do not cross the copper wires.

20. Use electrical tape to seal the

cables back together.

English

22. Connect the Ethernet cable and

power adapter to the camera.

23. Close and secure the back panel.

24. Plug the power cord and the

camera power adapter into an

available power outlet.

21. Reconnect the circuit board back

to the camera enclosure using the

two screws.

English

2. Drill holes for the fastener plugs at

each marked position. Make sure

the drill bit matches the size of the

provided white screw anchors.

1. Place the mounting bracket against

the wall and mark each of the four

holes with a pencil.

3. Insert the fastener plugs into the

holes.

Mounting the Camera Housing

English

Your installation is now complete.

5. Align the Wall Mount bracket with

the fasteners, and then use the

provided wood screws to secure it.

4. Use the bracket screws to mount

the mounting bracket to the

housing.

Otros manuales para 15-AH28B

Tabla de contenidos

Otros manuales de Cámara de seguridad de TRENDnet

TRENDnet

TRENDnet TV-IP440PI Manual de usuario

TRENDnet

TRENDnet TV-IP252P - SecurView PoE Dome Internet Camera... Manual de usuario

TRENDnet

TRENDnet TV-IP612WN Manual de usuario

TRENDnet

TRENDnet TV-IP400 Manual de usuario

TRENDnet

TRENDnet TV-IP612WN Manual de usuario

TRENDnet

TRENDnet TV-IP851WC Manual de usuario

TRENDnet

TRENDnet TV-IP312PI Manual de usuario

TRENDnet

TRENDnet TV-IP301 - ProView Advanced Day/Night Internet Surveillance... Manual de usuario

TRENDnet

TRENDnet TV-IP344PI Manual de usuario

TRENDnet

TRENDnet 15-AH28B Manual de usuario

TRENDnet

TRENDnet TV-IP311PI Manual de usuario

TRENDnet

TRENDnet TV-IP410PI V1 Manual de usuario

TRENDnet

TRENDnet TV-IP321PI Manual de usuario

TRENDnet

TRENDnet TV-IP345PI Manual de usuario

TRENDnet

TRENDnet TV-IP1315PI Manual de usuario

TRENDnet

TRENDnet TV-IP651W Manual de usuario

TRENDnet

TRENDnet TV-IP430PI Manual de usuario

TRENDnet

TRENDnet TV-IP751WIC Manual de usuario

TRENDnet

TRENDnet TV-IP501W Manual de usuario

TRENDnet

TRENDnet TV-IP1313PI Manual de usuario

TRENDnet

TRENDnet TV-IP110 - SecurView Internet Surveillance... Manual de usuario

TRENDnet

TRENDnet TV-IP201 Manual de usuario

TRENDnet

TRENDnet TV-IP400 Manual de usuario

TRENDnet

TRENDnet TV-IP651W Manual de usuario

Manuales populares de Cámara de seguridad de otras marcas

Okina USA

Okina USA SIR36-870VF650LP Manual de usuario

Divio

Divio NDR155PA Manual de usuario

Canon

Canon VB-C500D Manual de usuario

Easy Access

Easy Access EasyGuard Manual de usuario

Vivotek

Vivotek FD9389-EHV-v2 Manual de usuario

TUYA

TUYA COSMO W2 Manual de usuario

Eusso

Eusso UNC7500-IR Guía de configuración

urmet domus

urmet domus 1096/204 Manual de usuario

VC VC20 series Manual de usuario

Axis

Axis Q1614 Manual de usuario

ieGeek

ieGeek DD201 Manual de usuario

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manual de usuario

Vicon

Vicon V662-D-1 Instrucciones de funcionamiento

Grundig

Grundig GCH-K0274P Manual de usuario

Lorex

Lorex VANTAGE LBC7032 Manual de usuario

4xem

4xem WPT Manual de usuario

Samsung

Samsung SCV-3082 Manual de usuario

Vitek

Vitek VTC-C544 Manual de usuario