6
OPERATION AND
CLEANING 3
Using the grater
•In combined mincer-grater models, remove the mincer set before using the grater.
•Lift the grater lever and place the product to be processed inside the grater mouth.
•Lower the grater lever and press the switch on position “I”.
•Gradually press the lever until the product is finished.
•In order to stop the machine, press the switch on position “0”.
•At the end of processing lift the lever and introduce more product into the grater mouth; lower the lever
once more and press the switch on position “I”.
•At the end of the work session press the switch on position “0”.
•At the end of the work cycle, grate a piece of hard bread or use the appropriate brush to clean the roller.
Using the mincer
•In combined grater-mincer versions, lower the grater lever.
•Tighten the filler knob.
•Tighten the handwheel on the output mouth of the mincer without blocking.
•Start-up the machine by pressing the switch on position “I”.
•Place the product inside the upper mincer mouth and press it down using the pestle supplied.
•At the end of the work session press the switch on position “0”.
•At the end of the work cycle remove the mincer set and wash using suitable detergents in hot water or in
the dishwasher.
Dismantling the mincer set
Mod.AB.8/D – TR.8/D:
•Remove the hopper from the upper mouth.
•Rotate the handwheel anti-clockwise.
•Extract:
-the mincing plate;
-the blade;
-and the volute, in sequence
•Unscrew the filler knob by turning anti-clockwise
and extract the mincer filler.
•Perform operations in reverse order to
reassemble the mincer group.
INFORMATION: Prior to each work cycle ensure that the removable parts are properly fixed
to the machine.
