TomTom LINK 300 Manual de usuario
TomTom LINK 300/310 Installation Guide
English 4
Deutsch 30
Français 56
Nederlands 82
Italiano 108
Español 134
Português 160
Danske 186
Svenska 212
Polska 238
České 264
EN
DE
FR
NL
IT
ES
PT
DA
SV
PL
CS
Bremen-IG_(EN+DE+FR+NL+IT+ES+PT+DA+SV+PL+CS)_toc.fm Page 3 Tuesday, February 1, 2011 2:08 PM
What’s in the box
4
EN
What’s in the
box aTomTom LINK 300/310
ATop side
BBottom side
CLED
DPower cable connector
EGPS antenna connector (SMB) for
optional use of an external GPS antenna
FService/Update cable connector
GReset button
HSIM card holder
IRelease button for SIM card holder
Important: Do not remove the SIM card from the
TomTom LINK 310. Only use the SIM card provided
in the TomTom LINK 310. Other SIM cards may
damage the LINK device.
bPower cable
cPlastic seal
dTwo adhesive strips (transparent, for
windscreen mounting)
eTwo adhesive strips (grey, for dashboard
mounting)
fCleaning tissue
gHolder
hTwo self-tapping screws and washers
F I H D E
C G
2
4
6
8
3
5
7
A B
1
IG_EN.book Page 4 Friday, June 10, 2011 3:26 PM
Before the Installation
5
EN
Before the In-
stallation Congratulations
You have chosen the TomTom LINK 300/310,
a core hardware component of TomTom
WORKsmart fleet management solutions.
With WORKsmart from TomTom Business
Solutions you are always connected to your
people on the road in a smart and easy way.
TomTom LINK 300/310 is a GPS receiver and
GSM/GPRS module in one unit, always
providing the vehicle’s current position. When
used with a compatible TomTom navigation
device*, you will be able to easily handle
orders, as well as text and status messages.
What you need for the installation
Before starting the installation of your
TomTom LINK 300/310, read the safety
notices and warnings carefully and make sure
you have the following things:
•TheTomTomWEBFLEETContract
Confirmation letter including the
Activation Code and the SIM Card*.
• All parts mentioned in the chapter What’s
in the box on page 4 and two 2 A / fast
blow fuses (not included in the box).
•Aplace with clear view of the sky where
you can move your vehicle to check GPS
reception.
•ATomTom navigation device that is
compatible to TomTom LINK 300/310**.
* SIM Card are sent separately only for TomTom
LINK 300.
** Compatible devices to the LINK 300/310:
TomTom GO 7000 or any device of the PRO 7xxx
series
IG_EN.book Page 5 Friday, June 10, 2011 3:26 PM
Safety first
6
EN
Safety
first Important safety notices and warnings
Important: Read the following safety
instructions carefully
TomTom Business Solutions accept no
liability for damage that results from disregard
for the safety instructions.
This document is part of the product. Keep it in
a safe place. If you pass the unit on to a new
user, make sure you give them this document
as well.
•Important - damage caused through
improper installation
The installation and initial operation of the
unit must be performed by authorised
personnel only, e.g. a qualified radio dealer
or an automotive electronics workshop.
Consider the quality standards of the motor
vehicle trade.
•Caution - risk of injury in case of accidents
Do not mount the unit or accessories in the
inflation area of airbags or in the impact
area of the head or knees. Search carefully
for an installation location that will avoid
interference with displays, safety
equipment and controls.
•Caution - damage to the chassis
Make sure you do not drill into parts of the
chassis that have structural or security-
related functions. You cannot be certain
that they will function properly after
modification.
•Caution - risk of fire
Make sure you do not drill into covered
wiring harnesses, fuel lines or similar
components. Drilling into these can cause
fire.
•Caution - use of this product is restricted
in some areas
The GSM module of the TomTom LINK
300/310 is likely to interfere with electric
devices such as cardiac pacemakers,
hearing aids, electric devices used in
intensive medicine, and aviation
equipment. The interference with these
devices can endanger the health or life of
the users. Do not use near unprotected
electrical units nor in areas where the use
of mobile telephones is prohibited, such as
hospitals and airplanes! Switch off the unit
if there is a danger of interference with such
equipment.
IG_EN.book Page 6 Friday, June 10, 2011 3:26 PM
Safety first
7
EN
•Caution - danger of explosion
Parts of TomTom LINK 300/310 can cause
sparks, which can lead to explosions. This
may endanger human health and life. Do
not use the unit in areas with high risk of
explosion. When using TomTom LINK 300/
310 in a vehicle fueled by liquefied gas,
follow the safety regulations of the country
in which the vehicle is operated.
•Warning - repair and replacement
Repairs must be carried out by authorised
and qualified personnel only. Never replace
damaged parts of the unit yourself. Give
the defective unit to TomTom Business
Solutions. Only the qualified staff of
TomTom Business Solutions are
authorised to repair or replace parts.
•Warning - damage to the device
Short-circuits inside the unit can be caused
by contact with water or other liquids. The
unit may be damaged by contact with
water. Use and store the unit in an area
protected from water.
•Caution - risk of accidents
Using the unit while driving is distracting
and can cause accidents. To ensure road
safety, only enter information in the unit
when the vehicle is not being driven.
IG_EN.book Page 7 Friday, June 10, 2011 3:26 PM
Find the right Place
8
EN
Find the
right
Place First you need to find the right place to install
your LINK 300/310. You can either decide for a
hidden or for a non hidden installation.
If you are using the LINK 300/310 together with
a TomTom navigation device, then keep a
distance bigger than 30 cm between the two
devices to ensure optimal operation.
Non hidden installation
If you do not want to use an external GPS
antenna and always have free access to the
device you can simply affix it to the dashboard
or to the windscreen of your vehicle. (see
Mounting LINK 300/310 on page 14)
If the vehicle is often parked for longer periods
exposed to direct sunlight and/or to high
outside temperature, without the utilisation of
an aircondition, the device might not work
properly. In those cases TomTom Business
Solutions recommends a hidden installation.
Hidden installation
If you prefer to keep the LINK 300/310 in a
hidden place, to protect it from high
temperatures or for safety reasons (to not
obstruct the driver’s view e.g. in the
windscreen) you can place the device beneath
the dashboard e.g. in the glove compartment.
For this you need to find a place where the top
side of the device is not obstructed by metal
items. Also, you need the external GPS
antenna (see Alternative Mounting on
page 21). Use only the external GPS antenna
from TomTom Business Solutions. This is an
optional accessory which is not included in the
box.
IG_EN.book Page 8 Friday, June 10, 2011 3:26 PM
Find the right Place
9
EN
IG_EN.book Page 9 Friday, June 10, 2011 3:26 PM
Connection overview
10
EN
Connec-
tion
overview
* See Technical data on page 27
** Make sure this wire is fused with 15 A.
SMB
GPS Antenna
S
MB
G
P
S
Antenna
TomTom GO 7000
TomTom PRO 7xxx
TomTom LINK 300/310
BluetoothTM
Power Cable
+9-30VClamp 30**
GNDClamp 31
IN 1+9-30V (green/blue)
(brown)
(red)
F1 2Af*
F2 2Af*
F3 2Af*
(black) IGN (+9-30V)Clamp 15**
Optional
IG_EN.book Page 10 Friday, June 10, 2011 3:26 PM
Insert the SIM Card
11
EN
Insert the SIM
Card
For the transmission process
The following instructions apply for the LINK 300
only. The LINK 310 already comes with a built-in SIM
card.
To prepare the LINK 300 for data exchange
with TomTom WEBFLEET you need to insert
the SIM Card in the unit.
1. Press the release button for the SIM Card
holder with a pointed object until it
releases.
2. Pull out the SIM card holder.
3. Gently press the SIM card into the SIM card
holder until it clicks into place.
4. Hold the SIM card holder with the SIM card
facing down, then insert the holder into
LINK 300 as shown in the figure.
IG_EN.book Page 11 Friday, June 10, 2011 3:26 PM
Connecting to power
12
EN
Connecting to
power Connect LINK 300/310 to the vehicle power
supply with the standard vehicle voltage (12 V
/ 24 V). Do not connect to a voltage converter.
The three wires GND, IGN and PWR+ (supply
voltage) must be connected.
1. Connect the GND wire (brown) to ground
(clamp 31).
2. Fuse the PWR+ wire (red) and the IGN wire
(black) with one 2 A / fast blow fuse
(Technical data on page 27) each.
3. Connect the fused PWR+ wire (red) to the
carry current (clamp 30).
4. Then connect the fused IGN wire (black) to
ignition (clamp 15).
5. The IN1 wire can be used for multiple
purposes, e.g. connecting a digital
tachograph, reporting idle times or
recording other digital inputs. See Using
the digital input on page 19 for details. If
you do not make use of the input IN1,
please connect the IN1 wire (green/blue) to
GND.
6. Insert the 4-pin plug into the power cable
connector.
IG_EN.book Page 12 Friday, June 10, 2011 3:26 PM
Otros manuales para LINK 300
2
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Idiomas:
Otros manuales de GPS de TomTom
TomTom
TomTom RIDER 2nd Edition Manual de usuario
TomTom
TomTom XL 540S - Widescreen Portable GPS Navigator Manual de usuario
TomTom
TomTom Ease Manual de usuario
TomTom
TomTom NAVIGATOR 5 Manual de usuario
TomTom
TomTom ONE Manual de usuario
TomTom
TomTom XL 30 Manual de usuario
TomTom
TomTom PRO 7150 Manual
TomTom
TomTom GO Manual de usuario
TomTom
TomTom One XL Manual de usuario
TomTom
TomTom Rider Pro Manual de usuario
TomTom
TomTom Daihatsu Manual de usuario
TomTom
TomTom Car Navigation System TomTom Toyota Manual de usuario
TomTom
TomTom Navigator Navigator 4 Manual de usuario
TomTom
TomTom Eclipse AVN2210p Manual de usuario
TomTom
TomTom NAVIGATOR 5 Manual de usuario
TomTom
TomTom XXL 530S - Widescreen Portable GPS Navigator Manual de usuario
TomTom
TomTom ONE Manual de usuario
TomTom
TomTom GO Manual de usuario
TomTom
TomTom Mobile Manual de usuario
TomTom
TomTom PRO 82 SERIES Manual de usuario
