TKH TKIB41M1S Manual de usuario
User manual
Network bullet
TKIB41M1S / TKIB42M1S
tkhsecurity.fr
V.201910.01
User Manual - Network Bullet - TKIB41M1S & TKIB42M1S
EN
2
Precautions
Precautions
Fully understand this document before using this device, and strictly observe rules in
this document when using this device. If you install this device in public places,
provide the tip "You have entered the area of electronic surveillance" in an eye-
catching place. Failure to correctly use electrical products may cause fire and severe
injuries. To prevent accidents, carefully read the following context:
Symbols
This document may contain the following symbols whose meanings are described
accordingly.
Symbol Description
It alerts you to fatal dangers which, if not avoided, may
cause deaths or severe injuries.
It alerts you to moderate dangers which, if not avoided,
may cause minor or moderate injuries.
It alerts you to risks. Neglect of these risks may cause
device damage, data loss, device performance
deterioration, or unpredictable results.
It provides a tip that may help you resolve problems or
save time.
It provides additional information.
To prevent electric shocks or other dangers, keep power plugs dry and clean.
z Strictly observe installation requirements when installing the device. The
manufacturer shall not be held responsible for device damage caused by users' non-
conformance to these requirements.
User Manual - Network Bullet - TKIB41M1S & TKIB42M1S
EN
3
z Strictly conform to local electrical safety standards and use power adapters that are
marked with the LPS standard when installing and using this device. Otherwise,
this device may be damaged.
z Use accessories delivered with this device. The voltage must meet input voltage
requirements for this device.
z If this device is installed in places with unsteady voltage, ground this device to
discharge high energy such as electrical surges in order to prevent the power supply
from burning out.
z When this device is in use, ensure that no water or any liquid flows into the device.
If water or liquid unexpectedly flows into the device, immediately power off the
device and disconnect all cables (such as power cables and network cables) from
this device.
z Do not place the camera and unpackaged products at a radiation source with a high
intensity regardless of whether the device is in the normal power-on state, for
example, the sun, laser, and electric arc welder, and place the camera and
unpackaged products against objects with a high heat source, for example, the sun.
Otherwise, the accuracy of the camera will be affected. In addition, the detector in
the camera may be permanently damaged.
z If this device is installed in places where thunder and lightning frequently occur,
ground the device nearby to discharge high energy such as thunder strikes in order
to prevent device damage.
z During the outdoor installation, prevent the morning or evening sunlight incidence
to the lens of the camera. The sun shade must be installed and adjusted according to
the angle of the sunlight illumination.
z Avoid heavy loads, intensive shakes, and soaking to prevent damages during
transportation and storage. The warranty does not cover any device damage that is
caused during secondary packaging and transportation after the original packaging
is taken apart.
z This device is a static sensitivity device. Improper static may damage the camera.
ESD protection measures and reliable grounding must be well prepared for device
installation and uninstallation.
z Protect this device from fall-down and intensive strikes, keep the device away from
magnetic field interference, and do not install the device in places with shaking
surfaces or under shocks.
z Use a soft and dry cloth to clean the device body. In case that the dirt is hard to
remove, use a dry cloth dipped in a small amount of mild detergent and gently wipe
the device, and then dry it again. Pay special attention to the front window of the
camera because this is precision optics. If the front window has water spots, use a
clean and soft cloth to moisten with water and wipe it. If the front window needs
further cleaning, use a soft cloth dampened with isopropyl alcohol or detergent.
Improper cleaning can cause damage to the device.
User Manual - Network Bullet - TKIB41M1S & TKIB42M1S
EN
4
z The lens window of the camera is designed to be applicable to an outdoor
environment. The window is coated with durable coating material, but may require
frequent cleaning. When you found lens image degradation or excessive
accumulation of pollutants, you should clear up the window in a timely manner.
Exercise caution when you use this device in severe sandstorm (such as deserts) or
corrosive environments (such as offshore). Improper use may cause surface coating
off.
z Do not jam the ventilation opening. Follow the installation instructions provided in
this document when installing the device.
z Keep the device away from heat sources such as radiators, electric heaters, or other
heat equipment.
z Keep the device away from moist, dusty, extremely hot or cold places, or places
with strong electric radiation.
z If the device is installed outdoors, take insect- and moisture-proof measures to
avoid circuit board corrosion that can affect monitoring.
z Remove the power plug if the device is idle for a long time.
z Before unpacking, check whether the fragile sticker is damaged. If the fragile
sticker is damaged, contact customer services or sales personnel. The manufacturer
shall not be held responsible for any artificial damage of the fragile sticker.
Special Announcement
All complete products sold by the manufacturer are delivered along with nameplates,
operation instructions, and accessories after strict inspection. The manufacturer shall
not be held responsible for counterfeit products.
This manual may contain misprints, technology information that is not accurate enough,
or product function and operation description that is slightly inconsistent with the
actual product. The manufacturer will update this manual according to product function
enhancement or changes and regularly update the software and hardware described in
this manual. Update information will be added to new versions of this manual without
prior notice.
This manual is only for reference and does not ensure that the information is totally
consistent with the actual product. For consistency, see the actual product.
User Manual - Network Bullet - TKIB41M1S & TKIB42M1S
EN
5
Contents
1 Quick Configuration............................................................................................... 澳
1.1 Login and Logout ........................................................................................................... 澳
1.2 Main Page layout............................................................................................................ 澳
1.3 Change the Password ..................................................................................................... 澳
1.4 Browse Video ................................................................................................................. 澳
1.4.1 Install Plugins................................................................................................... 1澳
1.5 Setting Local Network Parameters ............................................................................... 1澳
2 Parameter Setting................................................................................................... 1澳
2.1 Sensor Setting Interface................................................................................................ 1澳
2.2 Time Segment............................................................................................................... 1澳
2.3 Image Setting ............................................................................................................... 1澳
2.4 Scene Mode.................................................................................................................. 1澳
2.5 Exposure....................................................................................................................... 1澳
2.6 WB Setting ................................................................................................................... 澳
2.7 Daynight....................................................................................................................... 2澳
2.8 Noise Reduction ........................................................................................................... 2澳
2.9 Enhance Image ............................................................................................................. 2澳
3 Configure the Device ............................................................................................ 3澳
3.1 Local Network.............................................................................................................. 3澳
4 Troubleshooting..................................................................................................... 3澳
2. =RRP)RFXV ............................................................................................................. 2澳
User Manual - Network Bullet - TKIB41M1S & TKIB42M1S
EN
6
1 Quick Configuration
1.1 Login and Logout
You must use Internet Explorer 8 or a later version to access the web management
system; otherwise, some functions may be unavailable.
Login system
Step 1 Open the Internet Explorer, enter the IP address of IP camera (default value:
192.168.0.121) in the address box, and press Enter.
The login page is displayed, as shown in Figure 1-1.
Figure 1-1 Login page
Step 2 Input the User and password.
z The default name and password are both admin. Modify the password when you login
the system for first time to ensure system security. After modifying password, you need
to wait at least three minutes then power off to make sure modifying successfully . Or
login the Web again to test the new password.
z You can change the system display language on the login page.
Step 3 Click Login arrow. The main page is displayed.
User Manual - Network Bullet - TKIB41M1S & TKIB42M1S
EN
7
logout
To logout of system, click in the upper right corner of the main page, the login page
is display after you log out of the system.
1.2 Main Page layout
On the main page, you can view real-time video, set parameter, Video parameter, Video
control, and logout of the system. Figure 1-2 is shown the main page layout. Table 1-1
lists the elements on the main page layout.
Figure 1-2 Main page layout
Table 1-1 Elements on the main page
No. Element Description
1 Real-time video
area
Real-time videos are played in this area. You can also set
sensor parameters.
2 Playback You can query the playback videos in this area.
NOTE
Only when the SD card or NAS have videos that user can query
the playback videos.
3 Device
configuration
You can choose a menu to set device parameters,
including the device information, audio and video streams,
alarm setting, and privacy mask function.
123 4
67 89 10111213
5
User Manual - Network Bullet - TKIB41M1S & TKIB42M1S
EN
8
No. Element Description
4 Change
password You can click to change the password.
5 Sign Out
You can click to return to the login page.
6 Stream Three are three streams. Choose one type from drop-down
list.
7 PTZ Only used for dome cameras, set parameters.
8 Pause/Start Close live video or play live video.
9 Live/Smooth Switch image quality.
10 Audio Open/close the audio.
11 Sensor setting Click the icon, it will access to sensor setting.
12 Snapshot Click the icon, it will snapshot.
13 Local record Click the icon, it will record video and save.
14 Intelligent
analysis
Open or close intelligent analysis.
1. When the device generates an alarm, the alarm icon is displayed. You can click
to view the alarm information. When the device accepts an alarm signal, the alarm icon will
display within 10s in the web management system.
2. When the device encounters an exception, the fault icon is displayed. You can click
to view the fault information.
1.3 Change the Password
Description
You can click to change the password for logging to the system.
Procedure
Step 1 Click in the upper right corner of the main page.
The Change Password dialog box is displayed, as shown in Figure 1-3.
User Manual - Network Bullet - TKIB41M1S & TKIB42M1S
EN
9
Figure 1-3 Modify Password dialog box
The change password page will be displayed if you don’t change the default password when
you login the system for the first time. User need to wait at least three minutes after
changing password, and then restart the device. The password incorrect more than 3 times,
please login again after 5 minutes
Step 2 Input the old password, new password, and confirmation password.
Step 3 Click OK.
Step 4
If the message "Change own password success" is displayed, the password is
successfully changed. If the password fails to be changed, the cause is displayed. (For
example, the new password length couldn’t be less than eight.)
Click OK. The login page is displayed.
1.4 Browse Video
User can browse the real-time video in the web management system.
Preparation
To ensure the real-time video can be play properly, you must perform the following
operation when you login to the web for the first time:
Step 1 Open the Internet Explorer. Choose Tools > Internet options > Security > Trusted
sites > Sites.
User Manual - Network Bullet - TKIB41M1S & TKIB42M1S
EN
10
In the display dialog box, click Add, as shown in Figure 1-4.
Figure 1-4 Add the a trusted site
Step 2 In the Internet Explorer, choose Tool > Internet Options > Security > Customer
level, and set Download unsigned ActiveX control and initialize and script ActiveX
controls not marked as safe for scripting under ActiveX controls and plug-ins to Enable,
as shown in Figure 1-5.
Figure 1-5 Configuring ActiveX control and plug-ins
Step 3 Download and install the player control as prompted.
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Cámara de seguridad de TKH
TKH
TKH TKID45F2S Manual de usuario
TKH
TKH PD1103Z2-EI Manual de usuario
TKH
TKH TKIZ48E12S Manual de usuario
TKH
TKH 1004 Series Manual de usuario
TKH
TKH SiQURA PD1022v2 Manual de usuario
TKH
TKH SIQURA FD002F2-EI Manual de usuario
TKH
TKH Siqura FD810V1IR Manual de usuario
TKH
TKH FD1001V1-EI/T Manual de usuario
TKH
TKH PD1103Z2-E Manual de usuario
TKH
TKH trafficptz ultimo Manual de usuario
