1.3 Safety Information
The HS3E and HS4E heat seal machines have a Power Saver energy feature.
The machine heater element will be de-energized after a preset time and cool
down to room temperature. This will occur when the preset “Power Saver Time”
has elapsed.
Re-activation of the HS3E or HS4E machine is achieved by lowering the Seal Arm
handle of the machine. Once the Seal Arm Handle is lowered into the “Locked”
position, the machine will exit the Power Saver Mode. The Heater Element of the
machine will become re-energized and increase in temperature to the preset
“Power Saver Temperature.” Upon achieving the preset Power Saver
Temperature, the Sealing Cycle Timer will begin counting down to zero seconds.
This machine is equipped with a fully grounded 3-wire cord and plug. It must be
used only in conjunction with a properly grounded outlet of the correct voltage.
WARNING: THE HEATER ELEMENT CAN CAUSE SKIN BURNS!
1.4 Conditions of Warranty
Thermopatch Corporation, Syracuse, New York (”Seller”) warrants this product to be free from
defects in material and workmanship under normal use and service. Any part which proves to be
defective in material or workmanship within one year of the date of original purpose for use will be
repaired or replaced, at Seller’s option, free of service or labor charges, with a new or functionally
operative part. Seller’s liability under the Warranty shall be limited to repairing or replacing at its own
factory or through an authorized service distributor or dealer, material which is determined by Seller
to have been defective in manufacture and upon which a claim has been made by the original
purchaser or user to Seller (or an authorized distributor or dealer) within the warranty period. An
authorized officer of Seller will honor claims under this Warranty only upon written approval.
Approved return of parts or products will be on a prepaid transportation charges basis only. Claims
under this Warranty will be honored only upon Seller’s determination that the claim is covered by this
Warranty, and Seller shall incur no obligation under this Warranty prior to such determination. This
Warranty does not apply: (1) To any machinery or equipment which has been altered or repaired,
except by Seller or its authorized representatives, or (2) to any machinery or equipment which has
been subject to misuse, negligence or accident, including, without limitation, use and operation of
such machinery or equipment while parts are loose, broken, out of order, or damaged by the
elements. Parts replaced under this Warranty are warranted only through the remainder of the
original Warranty. Any and all claims for warranty service must include such information as Seller
designates, and shall include specifically the serial number of each unit (if appropriate).
The foregoing shall constitute the sole and exclusive remedy of any using purchaser and the sole and
exclusive liability of Seller in connection with this product. THIS WARRANTY IS IN LIEU OF ALL OTHER
WARRANTIES, EXPRESS, IMPLIED OR STATUTORY, INCLUDING BUT NOT LIMITED TO, ANY WARRANT
OF MERCHANTABILITY OR FITNESS AND ALL OTHER OBLIGATIONS OR LIABILITIES OF SELLER,
INCLUDING ANY TORT LIABILITY, FOR NEGLIGENT DESIGN OR MANUFACTURE OF THIS PRODUCT,
OR OTHERWISE. It is expressly agreed that Buyer shall not be entitled to recover any incidental or
consequential damages, as those terms are defined in the Uniform Commercial Code, and that Buyer
shall have no right of rejection or of revocation of acceptance of any part or of the goods covered
hereby.
