Key Function in Normal Mode.
Freeze the counter on the screen, the counter will continue
counting although the screen is frozen. One the FRZ key is
pressed a second time the display will show the current distance.
Set the distance to a pre-determined value. Once pressed, you can
enter a four figure distance using the keypad e.g. 0100. If at any
time you pause for 4 seconds, the display will revert to the original
distance plus any distance covered whilst in distance set mode.
Once the value has been entered you have to press ENTER to
Accept the new distance. As soon you press Enter the display will
read from the new set distance.
Cycles through Probe 1, Probe 2 and Probes Off. This selects the
input from probe 1, probe 2 or switches off both probes.
Press DIS FLY and the ‘on the fly’ distance adjustment indicators
will be shown over the 1/10ths of the Total distance display.
Pressing DIS FLY again will move the fly adjustment to the
1/100ths of the Total display. Press /\ or \/ to adjust the distance.
If DIS FLY is pressed and no adjustments are made, then after 3
seconds the fly adjustment will move back 1/100ths on the Total
display.
DIS FLY adjustment can be disabled by holding DIS FLY whilst
turning the unit on. One of the following indicators will be shown
DIS /\ / \/ - On or DIS /\ / \/ - Off. When DIS /\ / \/ - Off is shown, DIS
FLY is disabled.
Toggles between count up and count down. Display will show
Count + for a positive count and Count - for a negative count. If the
Reverse input is used and the vehicle is placed in reverse the
count direction will be overridden to count down and the
display will show Reverse.
Press the PWR key briefly to turn the power on. To power the T101
off, press and hold the PWR key. You will hear 3 short beeps and
one long beep to warn that the T101 is powering down. If you
release the key during these beeps the power will stay on.
Clear the current counter value. This will reset the counter to ‘0.00’.
Enters the setup menu where calibration, and display settings can
be altered. If pressed the T101 will go into the menu mode, but
automatically revert to the normal display after 5 seconds. Pressing
MENU again will also revert to the normal screen.
Key Function in Menu Mode.
Navigate up the menu or increase value. Where a slider is shown,
holding the key down will automatically increase the value.
