TentCraft MONARCHSTOREFRONT Guía de configuración
HOW
TO SETUP
MONARCHSTOREFRONT
Billboard Style Pop-Up Tent With 4-Legs
1Remove the tent from the shipping box and transit
bag. Have two people stand on opposite sides
of the tent. (If your setup includes a peak
banner, install the hardware into the peak cap
now.)
2Have each person grab the scissor piece and walk
backwards, gradually expanding the tent frame
until you reach full extension.
3Get under the tent and connect the two halves
of the floating center poles.
4Holding the tent down with your foot on the foot
pad, press up on the scissor piece attached to the
corner bracket as it slides up the leg and clicks into
place. Repeat for remaining legs.
5Get under the tent. Locate the valance straps in
the center of each valance. Wrap the long end of
the strap down and back up through the
connecting element, then snap the buckle
together.
6Pull on the strap to tighten until the valance
itself is taut. Repeat for the remaining straps.
(Remember to unbuckle these straps when
taking the tent down.)
7Standing again by the tent leg with your foot on
the foot pad (as in Step 4), extend the leg by
pressing the push button in and pulling up on
the leg until it snaps into place.
8Repeat for this leg until you have reached desired
height. Repeat for remaining legs.
Wheel Kit Instructions
Otros manuales de Carpa de TentCraft
TentCraft
TentCraft S-Series Manual
TentCraft
TentCraft 15x15 E Series Manual de usuario
TentCraft
TentCraft MONARCHSTALL Manual
TentCraft
TentCraft HEXAGON PAVILION Manual
TentCraft
TentCraft MASTERTENT Manual
TentCraft
TentCraft X-Series Manual
TentCraft
TentCraft X Series Manual
TentCraft
TentCraft X-Series Manual
TentCraft
TentCraft GYBE Manual
TentCraft
TentCraft GYBE FUSION PANEL Manual
