Free Standing
his unit has been designed to be used only in an upright position on a rm, at
level surface.
he unit can safely be used both indoors and outdoors.
Failure to follow these instructions may result in personal injury, damage to the
product or damage to property.
Ensure that the position of the unit allows sucient space for the lifting on and
o of the clean water tank (top) and the removal of the waste water container
(right hand side).
Remove the red ller cap to add clean, fresh water. Replace the cap when the unit
has been lled to the correct level.
Do not over-tighten xings as this may damage the unit.
Check that the unit is upright and level before lling.
Waste Water
All KiddiSynk models come complete with a removable waste water container
that retains all the dirty water.
here is no need for a separate waste pipe or waste water storage container.
FAILURE TO FOLLOW THESE INSTRUCTIONS MAY INVALIDATE YOUR WARRANTY.
Installation
he unit can be lled with the clean water tank in place on top of the unit if
required.
he clean water tank can also be lifted from the unit to be carried to a water
source such as an outside tap. Hold the handles of the clean water tank rmly in
order to lift it away from the unit.
Ensure that the location pegs on the base unit are slotted accurately into place in
the water tank location holes when repositioning the clean water tank. See the
relevant parts identication photograph on page 7.
Remove the ller cap at the top of the unit and add clean, fresh water.
Unit must only be lled with clean water of the required temperature, which
should not exceed 40˚C.
Do not overll - only ll to the water ll line indicated on the relevant parts
identication photograph on page 7.
Replace the ller cap.
Ensure that the white waste water container inlet has been pushed into place
beneath the waste water pipe - see the relevant parts identication photograph
on page 7.
Use the tap to discharge water to wash hands.
If a continuous ow of water is required, fully depress the tap lever.
Waste water will drain into the waste water container.
o remove waste water, remove the water container and lift it out.
ip the water from the water container into a foul water drain.
Rinse with clean water.
Rell the unit and with clean water of the required temperature, which should not
exceed 40˚C.
Operating instructions
Page 8 Page 9
