Targus Acp50ca Manual de usuario

USER GUIDE

MANUEL DE

L'UTILISATEUR

mobile

docking station

with video

station d’accueil

mobile

avec vidéo

Visit our website at www.targus.com/ca

Features and specifications are subject to change without notice.

Visitez notre Site: www.targus.com/ca

Caractéristiques et spécifications sujettes à modification sans préavis.

ACP50CA / 410-0003-002C

Table of Contents

English

Mobile Docking Station with Video .................... 3

Français

Station d'accueil mobile avec vidéo ................... 20

TARGUS MOBILE

DOCKING STATION

WITH VIDEO

Introduction

Congratulations on your purchase of the Targus Mobile

Docking Station with Video. This portable expansion

module allows you to connect through a single USB

connection up to 4 USB devices, monitor, network

(Ethernet/LAN) connection, speakers, microphone and a

serial device.

The docking station also offers Targus Always On

technology, Targus Power Port providing twice the USB

spec for high power devices, and USB ports that are

widely spaced for larger adapters. Targus Always ON

provides power to the USB ports even when the

notebook is shut-down, disconnected from the docking

station or in hibernate/stand-by mode. This allows USB

devices that charge via the USB port to keep charging

under any circumstance.

Fe at u re s

Heat dissipation by natural convection:

Place the back edge of your laptop on the rubber pads of

the Docking Station. Most laptops dissipate heat through

the bottom and the more air that’s allowed to flow under

the bottom, the better chance that heat will dissipate by

natural convection.

Targus Mobile Docking Station with Video

Comfort

The raised platform provides a more comfortable position

for hands and increased airflow for better cooling.

The Docking Station provides the

following ports:

• 15-pin VGA (supports up to 1600 x 1200 at 16 bit color)

• Two 3.5 mm Audio: (1) stereo out and (1) microphone

• RS232 serial

• RJ-45 Ethernet 10/100

• Two USB 2.0 (White)

• Two USB Power Ports (Black) - providing up to 1Amp

Package Contents

In addition to this user’s guide, the package contains:

• Targus Mobile Docking Station with Video

• High-speed USB 2.0 upstream cable

• Driver software CD

• AC power adapter (required)

System Requirements

Hardware

• PC with an Intel®Pentium®processor or equivalent

• CD-ROM drive

• USB version 2.0 port

Targus Mobile Docking Station with Video

• AC power source (AC adapter required)

NOTE: WHEN CONNECTED TO AUSB VERSION 1.1 PORT ON YOUR

COMPUTER, THE DOCKING STATION’SPERFORMANCE LEVEL WILL BE

LESS THAN OPTIMAL AND THE VIDEO PORT WILL NOT FUNCTION

PROPERLY. FOR BEST RESULTS, CONNECT IT TO AUSB VERSION 2.0

PORT.

Operating System

• Windows®2000 Service Pack 2 or greater

• Windows® XP Service Pack 1 or greater

• Windows Vista®

NOTE: TODOWNLOAD LATEST SERVICE PACKS, PLEASE VISIT YOUR

COMPUTER MANUFACTURER’SWEBSITE OR MICROSOFT’SDOWNLOAD

CENTER:

http://support.microsoft.com

Installing the Device and

Drivers

To use the Targus Docking Station, you must first install

the driver onto your computer. Connect the docking

station to your computer and Windows plug-and-play will

install the hardware drivers for each port.

WARNING: YOU MUST INSTALL THE DOCKING STATION SOFTWARE

BEFORE CONNECTING IT TO YOUR COMPUTER. OTHERWISE, THE

DOCKING STATION WILL NOT WORK PROPERLY.

Targus Mobile Docking Station with Video

Installing the Docking Station Driver

Installing the docking station driver enables your

operating system to recognize the docking station and its

ports once it’s connected.

1 Turn on your computer.

2 Insert the driver software CD into your computer’s CD-

ROM drive.

3 If setup does not begin automatically, click Start, Run,

then enter D:\Setup.exe (where D: is the path of your

CD-ROM drive) and then click OK.

4 Follow any on-screen instructions to complete the

installation.

5Click Finish and restart your computer when

prompted.

Connecting the Docking Station to

Your Computer

After installing the docking station software, you are

ready to connect the docking station to your computer. To

do this:

1 Connect the supplied AC power adapter to the AC

power jack on the docking station.

2 Connect one end of the USB cable to the docking

station and the other end into an available USB 2.0

port on your computer.

NOTE: THE DOCKING STATION WILL NOT FUNCTION PROPERLY

WITHOUT THE AC ADAPTER PLUGGED INTO AN AC OUTLET.

Targus Mobile Docking Station with Video

DONOT CONNECT ANY DEVICES TO THE DOCKING STATION UNTIL THE

INSTALLATION IS COMPLETED.

Installing the Default Device Drivers

Once you connect the docking station to your computer,

the default drivers begin installing for each of the ports.

Some hardware devices may prompt you to install the

drivers.

To install the drivers:

1 Select Install the software automatically

(Recommended) and click Next.

The Found New Hardware Wizard program begins

installing the hardware drivers.

The Completing the Found New Hardware Wizard

screen appears.

2ClickFinish and repeat as needed for each device.

3 Restart your computer.

LED Status Indicator Lights

Once all device drivers are installed, the USB LED status

indicator lights on the back of the docking station glow

and you can connect devices to the docking station.

• Green Tx light illuminates when connected to a

network and the yellow Rx light flashes when data is

transmitting to or from the network.

NOTE: THE DOCKING STATION SUPPORTS HOT SWAPPING OF THE

NETWORK CABLE.

Targus Mobile Docking Station with Video

• USB lights will glow when the docking station is

connected to your computer.

•Always ON LED glows green when button is

depressed.

Docking Station Ports

Connecting New Devices

To avoid possible damage when connecting a new

device, do not force the cable connector into the port on

the docking station. If the cable connector does not

attach smoothly, turn the connector over and try attaching

it again.

Connecting a Serial Mouse

To connect a serial mouse, attach the cable connector to

the serial port on the docking station.

USB Ports

Serial

Audio Audio

In Out

VGA

Always On

AC Adapter

Laptop

USB to P

Network

Laptop Support Pad

Connectio

Support

Pad

Targus Mobile Docking Station with Video

Connecting and Configuring a Serial

Modem

To connect a serial modem:

1 Attach the cable connector to the serial port on the

docking station.

2 Install the modem software driver according to the

instructions that come with the device.

3 When prompted to select the port, choose the Serial

USB (COMx), where xis the COM port number

assigned by your operating system.

Connecting a PDA

1 Attach the cable connector to the serial port on the

docking station.

2 Verify that the COM port setting, in either your

HotSync®or ActiveSync®software, matches the

setting on the docking station.

To verify the COM port setting on the docking station,

refer to “Verifying Devices are Installed” on page 16.

To verify the COM port setting on your PDA, refer to

the documentation that came with it.

Connecting to a Local Area Network

To connect an ethernet cable with RJ-45 connect, attach

the cable connector to the ethernet/network port on the

docking station. Additional procedures to connect to an

actual network depend on the type of network you are

Targus Mobile Docking Station with Video

using. Contact your network administrator for detailed

instructions.

Connecting a USB Device

To connect a USB device, plug it into a USB port on the

docking station and follow the additional instructions

provided with the device.

All four USB ports meet USB hi-speed requirements by

providing 480Mbps through-put and 500mA of power.

However, the two black USB ports have two unique

features. See “Targus Always On” on page 14 for more

details.

The white USB ports are high-speed ports that provide

standard 500mA of power. The black USB power ports

are high-speed ports that provide up to 1Amp.

Connecting and Configuring an

Audio Device

1 Plug your headphones or speakers into the green 3.5

mm Audio Out port on the docking station.

2 To connect a microphone, plug it into the mono Audio

In port.

3 To enable your headphones or speakers:

a For Windows 2000, click Start, Settings, Control

Panel, and then open the Sounds and Multime-

dia folder. Select the Audio tab. Under Sound

Playback, change Preferred Device to USB

Audio from the drop down list.

› Click Apply, then click OK.

Tabla de contenidos

Idiomas:

Otros manuales de Estación de acoplamiento de Targus

Targus

Targus DV1K-2K Manual de usuario

Targus

Targus DOCK180USZ Manual de usuario

Targus

Targus DOCK419 Manual de usuario

Targus

Targus DUAL VIDEO 4K p60 Manual de usuario

Targus

Targus ExpressCard ACP60US Manual de usuario

Targus

Targus USB-C Travel Dock DP ALT-MODE Manual de usuario

Targus

Targus DOCK423 Manual de usuario

Targus

Targus ACP45EU Manual de usuario

Targus

Targus DOCK414 Manual de usuario

Targus

Targus Universal Notebook Docking Station with Video... Manual de usuario

Targus

Targus Universal USB-C 4K Docking Station Manual de usuario

Targus

Targus DV1K-4K Manual de usuario

Targus

Targus DOCK220USZ Manual de usuario

Targus

Targus 410-3878-001A Manual de usuario

Targus

Targus ACP71AU Manual de usuario

Targus

Targus DOCK190USZ Manual de usuario

Targus

Targus ExpressCard ACP60US Manual de usuario

Targus

Targus USB 2.0 LATPOP DOCKING STATION Manual de usuario

Targus

Targus ACP45 Manual de usuario

Targus

Targus DV2K Manual de usuario

Targus

Targus DOCK190 Manual de usuario

Targus

Targus USB 3.0 SUPERSPEED Manual de usuario

Targus

Targus ACP50EU Manual de usuario

Targus

Targus DOCK190USZ Manual de usuario

Manuales populares de Estación de acoplamiento de otras marcas

Sony

Sony Dream Machine XDR-DS12iP Manual de usuario

Acer

Acer USB Type-C Dock II Manual de usuario

ATEN

ATEN UC-2000 Manual de usuario

Xcellon

Xcellon HDD-202 Manual de usuario

Dok

Dok CR09 Manual de usuario

Philips

Philips BTM630/12 Manual de usuario

IOGear

IOGear Travel Pro GUD3C09 Manual de usuario

RKI

RKI SDM-E2 Manual de usuario

iHome

iHome iP15 Manual de usuario

VITURE ONE

VITURE ONE MOBILE DOCK Manual de usuario

Lindy

Lindy 42984 Manual de usuario

CipherLab

CipherLab 8001 Manual de usuario

Pyle

Pyle PIPDSP2 Manual de usuario

Avol

Avol AS2350 Manual de usuario

Datalogic

Datalogic JoyaTouch Manual de usuario

Philips

Philips DC190/79 Manual de usuario

Akasa

Akasa DuoDockX3 AK-DK08U3-BK Manual de usuario

Sirius Satellite Radio

Sirius Satellite Radio SUBX2082808a Manual de usuario

Targus acp50ca Manual de usuario

Manuales populares de Estación de acoplamiento de otras marcas