Superbrightleds EPLL Series Manual de usuario

Linear Explosion Proof Light

Important: Read all instructions prior to installation. EPLL Series

4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com

Rev Date: V1.1 06/29/2020

User Manual

5yr

Safety and Notes

Specications

EPLL-50K40-UGN-110

Check product label for specific electrical

specifications related to installation.

Improper installation will void warranty.

Wiring Diagram

Line

Neutral

Ground

Black

L L

N N

GND GND

White

Dim (+)

Dim (-)

Purple

+ +

- -

Gray

Green

Line

Neutral

Ground

Black

L L

N N

GND GND

White

Dim (+)

Dim (-)

Purple

+ +

- -

Gray

Green

• Product should be installed by a certied electrician in accordance with applicable national,

state, and local building and electrical codes. Proper earth grounding is required.

• To reduce the risk of electric shock, ensure that the main power source and circuit breakers

are switched o󰀨 before performing any installation or wiring procedures. If smoke is detected

or a short circuit is present, switch o󰀨 power immediately and notify relevant personnel.

• Avoid looking directly into the light when illuminated.

• Failure to properly support the xture may result in damage or injury, for which the manufacturer

does not assume responsibility. Check whether any accessories are correctly installed

prior to installation.

• If the light is damaged during shipping, do not install and contact customer service immediately.

Model EPLL -xK40-UGN-110 -xK80-UGN-110 -xK120-UGN-110

Operating Temperature -40°–122° F(-40°–50° C)

IP Rating IP66

Fixture Weight 16.9 lb (7.7 kg) 25.5 lb (11.6 kg) 26.1 lb (11.8 kg)

Conduit Installation

Chain Installation (EPLL-HM)

Wire Guard Installation (EPLL-WG)

Safety Cable Installation

Pipe Mount Installation (EPLL-PM220)

Ø10 mm

Ø170 mm

Yoke Mount Installation (Included)

1. Attach mount to light.

2. Drill 10 mm mounting holes 170 mm apart.

3. Hammer in mounting bolts into ceiling.

4. Fasten yoke mount/light assembly to mounting bolts until secure.

5. With supply power o󰀨, open driver box and connect wiring.

6. Rotate light to desired angle and tighten adjustment screw.

Linear Explosion Proof Light

Important: Read all instructions prior to installation. EPLL Series

4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com

Rev Date: V1.1 06/29/2020

User Manual

5yr

Conduit Installation

Chain Installation (EPLL-HM)

Wire Guard Installation (EPLL-WG)

Safety Cable Installation

Pipe Mount Installation (EPLL-PM220)

Ø10 mm

Ø170 mm

1. Remove yoke mount if assembled.

2. Remove conduit plug.

3. With supply power o󰀨, open driver box, feed

wire into box, and make all wiring connections.

4. Ensure silicone gel is added around the

threads and securely install conduit pipe/nut.

Note: All conduit openings must be closed by

conduit or NPT nut.

5. Close access panel and re-install screws.

Linear Explosion Proof Light

Important: Read all instructions prior to installation. EPLL Series

4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com

Rev Date: V1.1 06/29/2020

User Manual

5yr

Wire Guard Installation (EPLL-WG)

Safety Cable Installation

Pipe Mount Installation (EPLL-PMx) Installation

Conduit Installation

Chain Installation (EPLL-HM)

Wire Guard Installation (EPLL-WG)

Safety Cable Installation

Pipe Mount Installation (EPLL-PM220)

Ø10 mm

Ø170 mm

Conduit Installation

Chain Installation (EPLL-HM)

Wire Guard Installation (EPLL-WG)

Safety Cable Installation

Pipe Mount Installation (EPLL-PM220)

Ø10 mm

Ø170 mm

Conduit Installation

Chain Installation (EPLL-HM)

Wire Guard Installation (EPLL-WG)

Safety Cable Installation

Pipe Mount Installation (EPLL-PM220)

Ø10 mm

Ø170 mm

1. Remove yoke mount if assembled.

2. Measure diameter of pipe to select correct pipe mount hardware.

3. Drill and tap holes to align with two holes in bracket where the wing

bolts go to keep the light from being able to rotate on the pipe.

4. Slide pipe rings over pipe, then attach to light bracket using nuts

and wing bolts.

5. Attach light to bracket.

6. With supply power o󰀨, open driver box and make all wiring

connections.

1. Locate threaded holes on xture and

align wire guard to front of xture.

2. Tighten screws to secure wire guard.

1. Latch safety cable carabiner to body of light.

2. Wrap safety cable around a sturdy, load-bearing

structure and secure.

Este manual sirve para los siguientes modelos

Otros manuales de Equipo de iluminación de superbrightleds

superbrightleds

superbrightleds RWLA Series Manual de usuario

superbrightleds

superbrightleds WPGL Series Manual de usuario

superbrightleds

superbrightleds ELS-RW Manual de usuario

superbrightleds

superbrightleds NDC2K-RGB150 Manual de usuario

superbrightleds

superbrightleds WPFC2 Series Manual de usuario

superbrightleds

superbrightleds EL-S Series Manual de usuario

superbrightleds

superbrightleds XS-RG Manual de usuario

superbrightleds

superbrightleds ALKW8-RGB72 Manual de usuario

superbrightleds

superbrightleds EL2-SW Manual de usuario

superbrightleds

superbrightleds MSTRB2 Manual de usuario

superbrightleds

superbrightleds FLD-CNL-60005-150W Manual de usuario

superbrightleds

superbrightleds STN-1-UC Manual de usuario

superbrightleds

superbrightleds EL2-RW Manual de usuario

superbrightleds

superbrightleds FUT Series Manual de usuario

superbrightleds

superbrightleds RSL Series Manual de usuario

superbrightleds

superbrightleds EL3-RW Manual de usuario

superbrightleds

superbrightleds HBU-50K240W Manual de usuario

superbrightleds

superbrightleds WP Series Manual de usuario

superbrightleds

superbrightleds HLV8 Series Manual de usuario

superbrightleds

superbrightleds STN-2-TW Manual de usuario

superbrightleds

superbrightleds LPL-RGB9WR Manual de usuario

superbrightleds

superbrightleds XSCS-RW Manual de usuario

superbrightleds

superbrightleds WPGL2 Series Manual de usuario

superbrightleds

superbrightleds STAC Series Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario

superbrightleds EPLL Series Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas