Sunstream Evolve EHS Manual de usuario

Assembly Manual

Australia - 1800 316 962 | New Zealand 0800 21 8020

Ensure that the 2 wires protruding from

front of floor base are stood up straight.

Place the sauna floor in the desired location.

It is necessary to position the floor out from your walls for assembly and move the sauna following assembly.

Prepare & Position the Sauna Floor

If you are assembling your sauna on a hard surface floor, it is recommended that

you apply the included adhesive felt to the bottom of the sauna floor.

Please note: It is important that the sauna floor is level. Checking with a large level is recommended. If the

floor is not level, shimming or other remedies should be applied before assembling the sauna.

Australia - 1800 316 962 | New Zealand 0800 21 8020

Position the Back Wall

It is easiest if the Back Wall is placed behind the sauna floor base. Simply lean the Back Wall against

your room wall at this time.

Front Wall

Place the sauna front wall into the Floor

Base channel.

Take care with the 2 wires protruding from

floor base.

Australia - 1800 316 962 | New Zealand 0800 21 8020

Right Side Wall

Place the Right Side Wall in the

Floor Base channel

Front Right Corner

Connect the Right Side Wall to the

Front Wall by raising the Side Wall

approx 1/2" then sliding down to

connect the 2 fasteners.

Cinch the two walls together by

applying pressure on the outside of the

Side Wall with the inside of your knee.

It is helpful if the second person applies pressure against the opposite edge of the Front Wall. This will help

ensure that the two walls remain in contact and the fasteners will connect.

NOTE: It is NOT necessary to lift the

entire Side Wall. Simply slide the

Side Wall upward at the front corner

of the sauna to connect to the Front

Wall

Australia - 1800 316 962 | New Zealand 0800 21 8020

Hold Front Wall DOWN while

sliding Side Wall UP

There are two sets of fasteners to join the saunas' corners together. After lowering the Side Wall, check

to ensure that both sets of fasteners have connected by looking at the corner inside of the sauna. It is

possible to connect one set of fasteners and miss the other. If there is an obvious gap in the corner

between the two walls at least one fastener has not connected and the raising and lowering procedure

will need to be repeated.

Australia - 1800 316 962 | New Zealand 0800 21 8020

Position Back Wall

Place the Back Wall into the Floor Base channel.

Back Right Corner

Connect the Right Side Wall to the Back Wall by

raising the Side Wall approx 1/2" then sliding down

to connect fasteners

Back Wall

NOTE: It is NOT necessary to lift the entire Side Wall.

Simply slide the Side Wall upward at the back corner of the sauna to connect to the Back Wall

Hold Back Wall DOWN while sliding Side Wall UP

Australia - 1800 316 962 | New Zealand 0800 21 8020

Position Left Side Wall

Place the Left Side Wall into the Floor Base channel

Front Left Corner

Slide Left Side Wall up then down to connect

the Left Side Wall to Front Wall

Hold Front Wall DOWN while sliding Left Side Wall UP

Australia - 1800 316 962 | New Zealand 0800 21 8020

Position Back Wall

Place the Back Wall into the Floor Base channel

Back Left Corner

Slide Left Side Wall up then down to connect the Left Side Wall to Back Wall

Hold the Back Wall DOWN while sliding the Left Side Wall UP

Back Wall

Australia - 1800 316 962 | New Zealand 0800 21 8020

Under-Bench Electrical

NOTE: Do not connect main power cord to your wall outlet at this time.

Connect the circular connector to power supply

box. Align the groove in connector to properly

insert. Thread the cuff of the connector on fully.

Attach the 'D-Sub' computer

style connector as shown.

Plug in all heater leads to the

receptacles in the power supply box.

Australia - 1800 316 962 | New Zealand 0800 21 8020

Feed the main Power Supply Cord in through the hole in the Back Wall and

insert in Power Supply Box.

Do NOT plug power cord into your wall outlet until all electrical connections are finished

inside of the sauna and for the roof.

Connect the 2 floor/front wall connectors and install wooden cover plate

Australia - 1800 316 962 | New Zealand 0800 21 8020

Tabla de contenidos

Otros manuales de Producto de plomería de Sunstream

Sunstream

Sunstream Evolve 30 Manual de usuario

Sunstream

Sunstream evolve 10 Manual de usuario

Sunstream

Sunstream Evolve 20 Manual de usuario

Sunstream

Sunstream Supreme One Manual de usuario

Sunstream

Sunstream Evolve Mini EHS Manual de usuario

Sunstream

Sunstream Evolve Mini EHS Far Infrared Sauna Manual de usuario

Sunstream

Sunstream evolve 30 Manual de usuario

Sunstream

Sunstream Evolve 20 EHS Manual de usuario

Sunstream

Sunstream Mini Manual de usuario

Sunstream

Sunstream Evolve 10 EHS Manual de usuario

Sunstream

Sunstream Evolve Mini Manual de usuario

Manuales populares de Producto de plomería de otras marcas

Weka

Weka 506.2020.00E Instrucciones de funcionamiento

Kohler

Kohler K-6228 Instrucciones de montaje

UBERHAUS DESIGN

UBERHAUS DESIGN 75175017 Manual de usuario

American Standard

American Standard DetectLink 6072121 Manual de usuario

Uponor

Uponor Contec TS Manual de usuario

Pfister

Pfister Selia 49-SL Manual de usuario

Fortis

Fortis VITRINA 6068700 Manual de usuario

Fortis

Fortis MILANO 78211JS Manual de usuario

Kohler

Kohler K-12183 Instrucciones de montaje

Maxxus

Maxxus MX-M206-01 Manual de usuario

Moen

Moen 5922 Series Manual de usuario

Viega

Viega Prevista Pure 8512 Manual de usuario

Kohler

Kohler Centerset K-15240 Instrucciones de montaje

Viega

Viega Prevista Dry 8522.33 Manual de usuario

Sanela

Sanela Lema SLP 59RB Manual de usuario

Elkay

Elkay EDF15AC Manual de instalación

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Manual

baliv

baliv WT-140 Manual de usuario

Sunstream evolve EHS Manual de usuario

Manuales populares de Producto de plomería de otras marcas