Stiga T8580 Manual de usuario

MODEL NO.

T8580

2018 Escalade Sports

2L-7650-00

A D V A N T A G E

T A B L E T E N N I S T A B L E

A S S E M B L Y I N S T R U C T I O N S

Escalade® Sports products may be manufactured and/or licensed under the following patents.

6120397, 5816957, 5769744, 5119741, 4911085, 4717157, D460140, D420563, 8414431

Additional patents may be pending. One or more of the listed patents and/or pending patents may cover specific product.

Contact Escalade® Sports customer service department at:

Phone: 1-866-873-3528 Toll-Free!

Fax: 1-866-873-3533 Toll-Free!

E-mail: [email protected]

Please Do Not Return This

Product to the Store!

Contact Escalade® Sports customer service department at:

Phone: Toll – Free !

Fax: 1-866-873-3533 Toll – Free !

E-mail: tabletennis@escaladesports.com

Mailing Address (correspondence only):

Escalade Sports

PO Box 889

Evansville, IN 47706

Please visit our Website at:

www.escaladesports.com

ON-LINE TROUBLE SHOOTING TECHNICAL ASSISTANCE

ON-LINE PARTS REQUESTS FREQUENTLY ASKED QUESTIONS

ADDITIONAL ESCALADE®

SPORTS PRODUCT INFORMATION

1-866-873-3528

2018 Escalade Sports

2L-7650-00

TWO WRENCHES REQUIRED FOR

ASSEMBLY (NOT INCLUDED)

P R E - A S S E M B L Y T I P S

1. Read this manual carefully before starting assembly. Read each step completely before beginning each step.

2. Some smaller parts may be shipped inside larger parts. Check inside all parts and cartons before assembling or ordering

parts.

3. To make assembly easier, use the Hardware Identifier on page 3 to identify and sort all fasteners.

4. Do not tighten hardware until instructed to do so. If hardware is tightened too soon, mounting holes may not align and

parts may not easily fit together. Leave locknuts slightly loose until you are instructed to tighten them.

5. Save these instructions and your proof of purchase (receipt) in the event that the manufacturer has to be contacted for

replacement parts.

Please Do Not Return This Product to the Store!

1/2”

(QTY. 1)

NET & POST SET

5A-4319-00

7B-4069-00

NYLON LOCKNUT

5/16-18”

2B-6009-03

5/16-18 X 1-3/4”

1B-4170-00

P A R T S N E E D E D

HEX HEAD BOLT PLASTIC WASHER

5/16”

CASTER BEAM

CONECTOR CHANNEL

2S-4707-01

PRE-ASSEMBLED TABLE TOP

4A-5434-00

CASTER BEAM ASSEMBLY

4A-8250-00

(QTY. 4) (QTY. 8)

(QTY. 2)

(QTY. 8)(QTY. 8) (QTY. 8)

456

H A R D W A R E I D E N T I F I E R ( A C T U A L S I Z E )

A C C E S S O R I E S

DETAIL A

ASSEMBLY TIP

2. Press the tab on the Safety Latch (#30) to unlock the H leg (#19) and raise

the Front legs (#15) until they are in the vertical position. See DETAIL A.

Safety Latch

DO NOT pull up from legs (#19)

because you can damage the table.

These legs raise automatically when

Front Legs (#15) are raised.

1. Lay Table Top (#1) painted side down, on a smooth, flat surface.

CAUTION: Make sure that the table top is secure on the

sawhorses and NEVER leave the table top unattended.

Table top can be set on two saw horses. Although this will make

assembly easier it is not necessary to complete assembly. Always use

shipping container to protect the painted surface of the table top.

Raise the Front legs

(#15) until they are in

the vertical position

3. Push up to lock both hinges (#16 & #17) so that the front legs

remain in the vertical position. See DETAIL B.

DETAIL B

Hinge Locked

PUSH UP

4. Insert Bolt (#4) through the Plastic Washer (#5), Connector Channel

(#3), H legs (#19), another Connector Channel (#3), another Plastic

Washer (#5) and a Locknut (#6) but do not tighten the hardware yet.

See DETAIL C.

DETAIL C

7B-4069-00

PLASTIC WASHER

5/16”

(QTY. 8)

HEX HEAD BOLT

5/16-18 X 1-3/4”

1B-4170-00

(QTY. 8)

NYLON LOCKNUT

5/16-18”

2B-6009-03

(QTY. 8)

DETAIL D

334

Do not tighten

until the next step

5. Insert the Caster Beam Assembly (#2) between the Connector

Channels (#3) then secure the assembly using bolts (#4), Washers

(#5), and Locknuts (#6) as shown in DETAIL D. Tighten all

hardware at this time.

6. Repeat steps 1-5 to assemble a second table

half.

HARDWARE NEEDED (ACTUAL SIZE)

7. Turn table half (#1) over and set it on its legs carefully. Repeat step for second table half (#1).

THIS STEP REQUIRES TWO OR MORE ADULTS.

VERY CAREFULLY TURN THE TABLE OVER AND SET IT ON

ITS LEGS. BE CAREFUL, THE TABLE HALVES ARE HEAVY.

If needed use the leg

levelers to level the table.

8. Attach Net posts to the middle of the table where the table halves meet. See Figure 1.

CAUTION

9. Slide the Net into both Posts making sure that the white cloth of the net is at the top. Use strings at either end of the Net

to tighten the net and attach to the base of net post securely.

NET POST

NET

POST

FIGURE 1

FIGURE 4.

FOLD THE TABLE:

1. Remove the Net Set and push hinges up as shown in

2. Fold each half table as shown in FIGURE 5.

3. Secure table into upright position as shown in FIGURE 6.

REMOVE NET SET

FIGURE 1

FIGURE 2 FIGURE 3

UNFOLD THE TABLE:

1. Push down on Lock Tab to release lock as shown in

2. Fold each half table as shown in FIGURE 5.

3. Push down and lock hinges as shown in FIGURE 6.

PUSH UP

ATTACH NET SET

FIGURE 6

FIGURE 5

PUSH DOWN

Unfold the table

Push down

on Lock Tab

FIGURE 4

FIGURE 4.

CAUTION:

READ OPERATING INSTRUCTIONS CAREFULLY BEFORE OPERATING TABLE! DO

NOT ALLOW CHILDREN TO OPEN TABLE! DO NOT CLIMB, STAND OR JUMP ON

TABLE! SERIOUS OR FATAL INJURY MAY RESULT! THIS IS NOT A TOY! TABLE IS

TO BE OPENED OR CLOSED BY ADULTS ONLY! FAILURE TO COMPLY WITH

OPENING AND CLOSING INSTRUCTIONS COULD RESULT IN PERSONAL INJURY OR

PROPERTY DAMAGE.

14 23

H CASTER UPRIGHT #19

19 21

922

*Parts list is on the next

page.

NOTE:

The numbers with

grey circles re pre-

installed to the

table.

Key# Description

Replacement Parts List for parts NOT pre-installed

5/8 TT TOP BLUE

CASTER BEAM ASSEMBLY

CASTER BEAM CONECTOR CHANNEL

5/16-18 X 1-3/4 HEX HEAD TAP BOLT BLACK

5/16" X .630 NYLON WASHER

5/16-18 NYLON LOCKNUT BLACK

NET AND POST SET

INSTRUCTION MANUAL

4A-5434-00

4A-8250-00

2S-4707-01

1B-4170-00

7B-4069-00

2B-6009-03

5A-4319-00

2L-7650-00

Part # Qty.

Key# Description

RH SIDE RAIL STIGA

LH SIDE RAIL STIGA

LONG END RAIL

SHORT END RAIL

CENTER RAIL POWDER COATED

LEG MTG BRACKET FLAT BLACK

H LEG ASSY

RH HINGE ASSY

LH HINGE ASSY

LINKAGE POWDER COATED RED WITH ADVANTAGE LOGO

H CASTER UPRIGHT FLAT BLACK

CORNER PROTECTOR FOR TOP, AND INSERT TUBING

PLUG FOR END RAIL & LINKAGE 30MM X 20MM

#8 X 1-5/8” PAN PHIL BLACK

5/16-18 X 2 HEX BOLT BLACK

8.5MM X 19MM X 4MM STEP BUSHING

5/16-18 LOCKNUT BLACK

#8X7/16 SHEET METAL SCREW

5/16-18X3 BOLT BLACK

5/16" X .630 NYLON WASHER

8.5MM X 19MM X 15MM LONG SPACER

SAFETY LATCH ASSEMBLY RED

LEG LEVELER

CONNECTOR AND INSERT TUBING PLUG 30MM X 20MM

CASTER WHEELS

CASTER BEAM ASSEMBLY PLUG

8S-4602-05

8S-4602-06

8S-4603-02

8S-4604-02

8S-4605-02

2S-4708-01

1A-4154-03

4A-8248-01

4A-8249-01

8S-4608-02

1A-4157-01

3M-4174M00

3M-4176M00

1B-4171M00

1B-6165M02

7B-4070M00

2B-6009M03

1B-6451M00

1B-6047M02

7B-4069M00

7B-4068M00

1A-4159M00

7B-4067M00

3M-4175M00

2Q-4036M00

3M-4173M00

Part # Qty.

Replacement Parts List for Pre-installed Parts

Tabla de contenidos

Idiomas:

Otros manuales de Robótica de Stiga

Manuales populares de Robótica de otras marcas

STEMCenter USA

STEMCenter USA Pi-Bot v2.00 Manual de usuario

SunFounder

SunFounder PiDog Manual de usuario

Universal Robots

Universal Robots UR5 Manual de usuario

Universal Robots

Universal Robots E Series Manual de usuario

YASKAWA

YASKAWA MOTOMAN-MPL80 II Manual de usuario

EFORT

EFORT ECR5 Manual de instrucciones

Epson

Epson C8 Series Manual de usuario

WowWee

WowWee ROBOQUAD Manual de usuario

Milvus Robotics

Milvus Robotics SEIT 100 Manual de usuario

RoboMaster

RoboMaster AI Robot 2020 Standard Version Manual de usuario

fischertechnik

fischertechnik Mini Bots Manual de usuario

YASKAWA

YASKAWA MA2010 Manual

Abicor Binzel

Abicor Binzel iCAT mini Manual de usuario

ABB

ABB OmniCore E10 Manual de usuario

YASKAWA

YASKAWA Motoman DX200 Manual de usuario

pitsco

pitsco Tetrix Max Manual de usuario

ECOVACS

ECOVACS DEEBOT R95 Manual de usuario

Feng Yuan

Feng Yuan Interstellar Warrior Manual de usuario