6
USING THE DIGIEXTRACT
Do not use your fingers or other utensils to push
the ingredients down the feed chute .
If the rotary switch eis not in the OFF position
when power is supplied to the appliance, it will
not function. Return the rotary switch eto the
off position before selecting a speed again.
•Wash the ingredients and remove any hard
or inedible parts such as stones, pits, hard
skin, rind, pith, etc.
•Ensure that the appliance is correctly
assembled, the juice jug yis placed under
the juice spout s, and pulp container tis in
position before juicing.
•Plug the mains cable into the power socket
(switch the power socket on if applicable).
•Place the ingredients into the feed chute
and turn the rotary switch eto the ‘ON’
position. The digital display will illuminate
to indicate it is ready to use.
•Turn the rotary switch eto the desired
speed to begin juicing. The digital
display will show the length of time
which has elapsed.
miN Low speed for juicing softer fruit and
vegetables such as apricots, berries,
cucumber, grapes, kiwis, mangoes,
oranges, watermelons, tomatoes, etc.
maX High speed for juicing harder fruit
and vegetables such as apples, pears,
carrots, brussels sprout, cabbage,
fennel, plums, beetroot, celery, etc.
•Use the food pusher to gently guide the
food down the feed chute and extract
the maximum amount of juice. The juice
will flow into the juice jug yand the pulp
will separate and accumulate in the pulp
container t.
•Do not allow the pulp container tto
overfill as this may prevent correct
operation or cause damage to the
appliance. To empty the pulp container
t during juicing, turn the rotary switch
eto OFF and remove it as described
in disassembling instructions. Replace
the empty pulp container tbefore
continuing to juice.
•After juicing, always turn the rotary switch
e to OFF and unplug the mains cable.
JUICING TIPS
•Always use fresh fruit and vegetables and
wash them well before use and storage.
•Add a little lemon juice to apples, pears
and similar fruits to prevent browning.
•When juicing herbs, sprouts or leafy
vegetables, form them together into a
bundle or mix them with softer ingredients
and juice on low speed for best extraction.
•Any pulp remaining after juicing should be
used promptly to avoid oxidation and loss
of nutrients.
•Consider lining the pulp container twith a
bio-degradable or food-safe bag for easier
disposal or consumption of the pulp.
CLEANING
Never immerse the motor unit in any liquids.
•Always ensure that the appliance is
disconnected from the mains supply before
disassembling, cleaning and storing.
•Wipe the motor unit with a damp cloth and
immediately dry with a soft, lint-free cloth.
•Thoroughly clean all the surfaces that
come into contact with food during use.
•Immediately after each use, rinse all the
removable parts under running water and
allow to air dry.
•Soak the micro-mesh filter for about 10
minutes in warm soapy water, then hold
it under the running water and use the
supplied brush to ensure that all the pulp is
removed from the mesh and any openings.
