Sony CDU625 Manual de usuario

CDU625

CD-ROM Drive Unit

User’s Guide

CDU625

CD-ROM Drive Unit

User’s Guide

3-862-263-02(1)

Owner’s Record

The model and serial numbers are located on the top side of the drive. Record these

numbers in the spaces provided below. Refer to them whenever you call upon your sales

representative regarding this product.

Model No. Serial No.

WARNING

To prevent fire or shock hazard, do not expose the unit

to rain or moisture.

To avoid electrical shock, do not open the cabinet.

Refer servicing to qualified personnel only.

This unit uses CD-ROM discs with the following mark.

When you use this unit as an audio CD player, use compact

discs with the following mark.

This label is located on

the top of the drive.

DieserAufkleber befindet

sich an der Oberseite des

Gehäuses.

Caution-Use of controls or adjustments or performance of procedures other than those

specified herein may result in hazardous radiation.

Caution-The use of optical instruments with this product will increase eye hazard.

CAUTION INVISIBLE LASER RADIATION WHEN OPEN. DO NOT

STARE INTO BEAM OR VIEW DIRECTLY WITH OPTICAL

INSTRUMENTS.

VORSICHT UNSICHTBARE LASERSTRAHLUNG, WENN ABDECKUNG

GEÖFFNET.NICHT IN DEN STRAHL BLICKEN, AUCH

NICHT MIT OPTISCHEN INSTRUMENTEN.

ADVARSEL USYNLIG LASERSTRÅLING VED ÅBNING SE IKKE IND I

STRÅLEN-HELLER IKKE MED OPTISKE INSTRUMENTER.

ADVARSEL USYNLIG LASERSTRÅLING NÅR DEKSEL ÅPNES. STIRR

IKKE INN I STRÅLEN ELLER SE DIREKTE MED OPTISKE

INSTRUMENTER.

VARNING OSYNLIG LASERSTRÅLNING NÄR DENNA DEL ÄR

ÖPPNAD. STIRRA EJ IN I STRÅLEN OCH BETRAKTA EJ

STRALEN MED OPTISKA INSTRUMENT.

VARO! AVATTAESSA OLET ALTTIINA NÄKYMÄTTÖMÄLLE

LASERSÄTEILYLLE. ÄLÄ TUIJOTA SÄTEESEEN ÄLÄKÄ

KATSO SITÄ OPTISEN LAITTEEN LÄPI.

INFORMATION

You are cautioned that any changes or modifications not expressly approved in this

manual could void your warranty covering this equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.

This CD-ROM Drive Unit is classified as a CLASS

1 LASER PRODUCT.

The CLASS 1 LASER PRODUCT label is located

on the top of the drive.

Bei diesem CD-ROM-Laufwerk CDU625 handelt

es sich um ein Laser-Produkt der Klasse 1. Ein

entsprechenderAufkleber mit der Beschriftung

LASER KLASSE 1 PRODUKT befindet sich auf

der Oberseite des Geräts.

CLASS 1

LASER PRODUCT

LASER KLASSE 1

PRODUKT

LUOKAN 1 LASERLAITE

KLASS 1 LASER APPARAT

Diese Ausrüstung erfüllt die Europäischen EMC-Bestimmungen für die Verwendung in

folgender/folgenden Umgebung(en):

• Wohngegenden

• Gewerbegebiete

• Leichtindustriegebiete

(Diese Ausrüstung erfüllt die Bestimmungen der Norm EN55022, Klasse B.)

Trademarks

• MS-DOS is a registered trademark of Microsoft Corporation.

• IBM PC, PC/XT, and PC/AT are registered trademarks of International Business

Machines Corporation.

• HP Vectra is a registered trademark of the Hewlett-Packard Company.

• Molex is a registered trademark of Molex, Inc.

• AMP is a registered trademark of AMP, Inc.

• 3M is a registered trademark of the Minnesota Mining and Manufacturing Company.

• JAE is a registered trademark of JapanAviation Electronics Industry, Ltd.

Contents

Introduction 6

Features.............................................................................................. 6

Software Requirement ........................................................................ 7

Example of System Setup .................................................................. 7

Location and Function of Parts and Controls 8

Front Panel ......................................................................................... 8

Rear Panel .......................................................................................... 9

Precautions 10

Installing the Drive inYour Computer 11

Preparation ....................................................................................... 11

Setting the Jumpers.......................................................................... 11

Opening the Computer ..................................................................... 13

Preparing a Space for the Drive ....................................................... 14

Mounting the Drive ........................................................................... 15

Connecting the Drive ........................................................................ 15

Mounting the Host Adapter ............................................................... 18

Reassembling the Computer ............................................................ 19

Installing the Software Driver 20

Operating the Drive 21

Starting the Drive.............................................................................. 21

Ejecting the Disc ............................................................................... 23

How to Use the Disc Locks............................................................... 24

Specifications 26

6Introduction

Introduction

Features

The CDU625 is an internal CD-ROM (Compact Disc Read-Only

Memory) drive unit designed for use with an IBM PC, HP Vectra, or

compatible computer. It can read as much as 540 Mbytes of digital

data stored in a single CD-ROM disc.

The CDU625 has the following features:

General

• 5 1/4 inch half-height drive form factor.

• Embedded SCSI bus interface (SCSI-2).

• 256-kbyte buffer memory on the SCSI controller.

• Audio CD like drawer loading of a disc without using a caddy.

• Power loading and power eject of a disc. The disc can also be

ejected manually.

• Housed in an airtight frame casing.

• Equipped with a parity on/off switch.

Supported disc format

• Reads data in CD-ROM, CD-ROM XA, CD-I and CD-I Ready

standard format discs, and from CD EXTRA disc.

• Reads data in CD-BRIDGE format including PHOTO-CD.

• Reads standard CD-Digital Audio encoded discs.

Performance

• Supports standard, quadruple, and 12 - 24×speed operations with

real time error correction.

• Fast access time ensuring reliable high-speed data access.

Audio

• Outputs 16-bit digital audio data over the SCSI interface.

• Equipped with audio line output and headphones jack for audio

CD playback.

Note:

The CDU625 is not equipped with an ADPCM audio circuitry

required to support CD-ROM XA and CD-I compatible audio

modes. In addition, the unit does not support the CD-I graphic

decoding function; it has to be provided by the system.

Software Requirement

To access data on CD-ROM discs, the appropriate device driver and

MSCDEX (supplied with the host adapter) must be installed in your

computer. See the manual that comes with the host adapter for

details.

The application software you need for using the data on a CD-ROM

disc depends on the type and format of the target data. See the

manual supplied with your CD-ROM disc for instructions.

Example of System Setup

To use the CDU625, at least the following components are

necessary.

• Computer (IBM PC, PC/XT, PC/AT, HP Vectra, or equivalent)

• Host adapter

• Floppy disk drive

• Interface cable (50 pin flat cable)

• Software (Device driver, Utilities)

The following is an example of system setup.

Introduction

Software

Host computer

Floppy disk

drive Host adapter

ID No.7ID No.3

CDU625

Audio cable

Location and Function of Parts and Controls

Front Panel

3456

1Discdrawer

Accepts a CD-ROM disc on its tray.

2Headphonesjack

Accepts a stereo headphones set. Analog audio signals are

output.

3Volumecontr ol

Controls the volume level of sound output from the headphones

jack 2.

4Busyindicator

This amber indicator lights or flashes to indicate one of the

following unit conditions.

• Steady lit: TOC (table of contents) read, seek data read, or

audio playback in progress.

• Flashing: Drawer in motion.

5Emergencyejecthole

Used to open the disc drawer manually when neither the Eject

button 6nor a software command works. Insert a pointed

object, such as a paper clip, into this hole and push (approx. 40

mm stroke).

6Ejectbutton

Opens and closes the disc drawer.

Location and Function of Parts and Controls

Rear Panel

1342

1AUDIOOUTconnector

Outputs analog audio signals.

2SCSIbussettingjumperblock

Specifies various SCSI bus settings. See page 12 for details.

3interfaceCONNECT OR(SCSIb us)

Connect to a SCSI host adapter using a connecting cable.

4DCINPUT(power-in)connector

Connect to the power supply of the host computer.

Location and Function of Parts and Controls

Pin 1

Precautions

■Installation

• Avoid placing the drive in a location subject to:

– high humidity

– high temperature

– excessive dust

– mechanical vibration

– direct sunlight

• The drive can be used in either a horizontal or vertical position.

• Do not force the power cable. It is keyed to protect the drive.

■Operation

• Do not move the drive when it is in use. Doing so may cause data

error and damage the optical pick-up.

• Avoid exposing the drive to sudden changes in temperature as

condensation may form on the lens inside the drive. Should the

surrounding temperature suddenly rise while the drive is turned

on, stop using the drive and leave the power on at least one hour

before operating it or turning it off. Operating the drive

immediately after a sudden increase in temperature may result in a

malfunction.

■Transportation

• Close the disc drawer before moving the drive.

• Keep the original packing materials. When you need to ship the

drive to another location, repacking it in its original container will

help you transport it safely.

Precautions

Otros manuales para CDU625

Tabla de contenidos

Otros manuales de Unidad de CD/CDR de Sony

Manuales populares de Unidad de CD/CDR de otras marcas

Philips

Philips CDD3610 Manual de usuario

QPS

QPS Que!Fire Manual de usuario

LG GCC-4241N Manual de usuario

Plextor

Plextor 12X-3 Guía

Samsung

Samsung SN-324B Manual de usuario

Teac

Teac CD-211E Manual de usuario

SmartDisk

SmartDisk Firewire CD-R/W Manual de usuario

Axis

Axis CD-ROM SERVER Manual de usuario

LG CRD-8322B Manual de usuario

Memorex

Memorex 32023234 - 52x32x52x External USB2.0 CD... Instrucciones de instalación

Yamaha

Yamaha CD Recordable/Rewritable Drive CRW3200 Manual de usuario

Panasonic

Panasonic KX-LD742 Manual de usuario

Pioneer

Pioneer BDR-S13U-X Manual de usuario

Panasonic

Panasonic LK-MC606BP Manual de usuario

Panasonic

Panasonic CF-VCW Series Manual de usuario

LG CRD-8320B Manual de usuario

Conner

Conner CFP2107 Series Manual de usuario

Plextor

Plextor 12-20C Guía