Soleus Air PSH-09-01 Manual de usuario

Portable Air Condioner

8,050 BTU • 9,300 BTU

Seasonally Adjusted Cooling Capacity (SACC)

Meets Department of Energy & California Energy Standards

OPERATING INSTRUCTIONS

V210702

Air conditioner must be upright for 24 hours prior to operating.

This ensures that the compressor will function as intended.

PSH-08-01

PSH-09-01

600538

Thank you for choosing a Soleus Air Portable Air Conditioner. This Owner’s Manual will provide

you with valuable information necessary for the proper care and maintenance of your new product.

Please take a few moments to thoroughly read the instructions and familiarize yourself with all the

operational aspects of your new Soleus Air Portable Air Conditioner.

For your own records, please attach a copy of your sales receipt to this manual. Also, write the

store name/location, date purchased, and serial number below:

Store Name: ____________________________________________________

Location: _____________________________________________________

Date Purchased: _________________________________________________

Serial Number (located on back of unit): ______________________________

Before installing and using your portable air conditioner, please read this owner’s manual carefully. Store this

manual in a safe place for future reference.

1) Always place the unit on a level surface.

2) Never use or store gasoline or other flammable vapor or liquid near this unit unless instructed by this manual.

3) Maintain at least 10 inches (25 cm) clearance space around this unit. Do not block or cover air inlet or outlet

grilles.

4) The unit must be connected to a correctly grounded power supply.

5) Do not start or stop the unit by inserting or pulling out the power plug.

6) Do not use an adapter plug or extension cord.

7) Do not use the unit directly by a bathtub, shower or swimming pool.

8) Do not insert anything into the air outlet. Do not obstruct air inlet or outlet grills unless instructed by this

manual.

9) Do not let children play near this unit.

10) Always inspect the cord for signs of damage before use. If the power cord is damaged, it must be replaced by

the manufacturer or a qualified service technician.

11) When cleaning the unit, always turn the unit off and unplug the power cord.

12) Do not mix old and new batteries in the remote control.

Do not mix Alkaline, Standard (Carbon - Zinc) or Rechargeable (Nickel - Cadmium) Batteries.

IMPORTANT INSTRUCTIONS

PURCHASE INFORMATION

Portable Air Conditioner (1)

Exhaust Hose (1)

Exhaust Hose Connector (1)

Window Kit Panel (3)

Window Kit Adapter (1)

Wing Nut (2)

Optional Drain Tube (1)

Remote Control (1)

AAA Battery (2)

Owner’s Manual (1)

 Noise level is measured at a distance of 3.28 ft away from the front of the unit, when the unit is in cool-

ing mode.

 Power consumption is measured when the fan runs at the highest speed setting.

 These specifications are for reference only. For actual data, please refer to the rating label on the back

of the unit.

 If the environment temperature is higher than the max operating temperature or lower than the mini-

mum operating temperature, the air conditioner may not work properly.

PACKAGE CONTENTS

Model Number PSH-08-01 PSH-09-01

Cooling Capacity (SACC) 8,050 BTU/Hr

Meets DOE & California

Energy Standards

9,300 BTU/Hr

Meets DOE & California

Energy Standards

Dehumidification 65 pts/Day 75 pts/Day

Cooling Power Usage 1140 Watts

10 Amps

1230 Watts

10.8 Amps

Air Flow (H/M/L) 235/212/177 CFM 235/212/177 CFM

Power Source 115 V / 60 HZ 115 V / 60 HZ

Noise Level dB(A) 52/50/49 52/50/49

Product Weight 68.3 lbs. 70.5 lbs.

Operating Temperature 61° - 88° F 61° - 88° F

Product Dimensions

(W x H x D) 18.9” x 30.7” x 15.4” 18.9” x 30.7” x 15.4”

Refrigerant R-410A R32

SPECIFICATIONS

This air conditioner is equipped with an LCDI (Leakage Current Detection and Interruption) power cord

and plug as required by US National Electric Code 440.65. This cord consists of a length of shielded flex-

ible cord with no termination on the load side and a LCDI attachment plug on the line side.

The LCDI power cord and plug will remove the supply source via electrical disconnect (circuit trip) if the

nominal current leakage between the cord shield and either load conductor exceeds a predetermined val-

ue. The cord will remain de-energized until the device has been manually reset. This is intended to reduce

the risk of a fire in the power cord or combustible materials nearby. The cord shields are not grounded

and they must be considered a shock hazard if exposed. The cord shield must not be connected to ground

or to any exposed metal.

The test and reset buttons on the LCDI Plug are used to check if the plug is functioning properly. To test:

1. Plug power cord into wall outlet, the LED light will turn on.

2. Press TEST Button, circuit should trip, cutting power to the air conditioner. When this occurs,

the LED light will turn off.

3. Press RESET button to restore power to the unit. Once power is restored, the LED light will

turn on again.

If test button is pressed and unit can still be turned on, current leakage has been detected. Do not use the

air conditioner or attempt to reset the LCDI Plug. Contact Customer Service for troubleshooting recom-

mendations.

Note: Your unit’s power cord may

differ from the one shown.

WARNING:

1. DO NOT press the TEST button while the air conditioner is operating.

2. The TEST and RESET buttons should not be used as “ON” and “OFF” switches.

3. The cord and plug are not intended to offer protection to externally connected loads or supply circuits.

4. The cord and plug are intended for indoor use only.

RESET

TEST

POWER CORD AND PLUG

1. Control Panel

2. Manual Control Louver & Air Outlet

3. Carry Handle

4. Casters

5. Air Filters

6. Continuous Drain Port

7. Air Discharge Opening

8. Air Intake Grilles

9. Condensation Drain Hole

10. Exhaust Hose

11. Exhaust Hose Connector

12. Window Kit Adapter

13. Window Kit Panels

14. Wing Nuts & Screw

15. Optional Drain Tube

16. Remote Control

17. Batteries

PRODUCT DIAGRAM MODEL# PSH-08-01/PSH-09-01

5/8

10 11 12

WINDOW VENTING KIT

ASSEMBLY & INSTALLATION

When the unit is operating in air conditioning mode, the unit draws in indoor air and exhausts hot air out of the room

to complete the air exchange. The Window Kit must be installed when operating the unit in air conditioning, dehu-

midification. When the unit is operating in Fan Mode, no outdoor air exchange takes place. The window kit and ex-

haust hose do not need to be installed when the unit is used as a fan.

The supplied window kit can be installed in sliding windows and sliding glass doors up to 5 ft. long

(approximate length). When installed, be sure to keep the exhaust hose as short and straight as possible for

maximum efficiency.

PARTS & ASSEMBLY

WINDOW KIT ASSEMBLY

1. Unscrew the Wing Nut from the base. Insert the Wing

Nut base into the small hole found on panel A

2. Screw the Wing Nut onto the Wing Nut Base until

slightly loose. (Will tighten in an upcoming step.)

3. Slide panel B inside panel A and over the

Wing Nut Base.

5. Tighten Wing Nut to secure both panels.

4. Panel A and B should now be connected.

PORTABLE AIR CONDITIONER

The window venting kit must be installed in order for the unit to work correctly. The window venting kit has been de-

signed to fit into most vertical and horizontal window openings and sliding glass doors up to 5 feet.. *The window kit

included with your purchase may vary slightly from what is shown below.

2. Twist the Exhaust Hose Connector

onto Exhaust Hose.

1. Open the window or door to adjust the length of the Window

Kit Panels to fit the opening. If necessary, mark the kit and cut

one end down to properly fit the opening.

3. Twist the Exhaust Hose Connector over the discharge opening

on the back of the unit and extend the Exhaust Hose. (Keep the

exhaust hose as short and straight as possible)

WINDOW KIT INSTALLATION

5. Attach the Window Kit Adapter to the opening in

the Window Panel. Then, attach the Screw to se-

cure the Window Kit Adapter to the Window Panel.

4. Twist the Window Kit Adapter onto the Exhaust Hose. (Keep

the exhaust hose as short and straight as possible)

Screw

OPERATING INSTRUCTIONS FOR CONTROL PANEL BUTTONS

1) Power On and Off - Press the POWER button once to manually turn the unit on. Press the

POWER button once more to turn the unit off.

2) Mode Selection - Press the MODE button repeatedly to cycle between the different modes:

Air Conditioner (Cool) mode, Fan-only mode, Dehumidifier (Dry) mode, and Auto mode. Each

press of the MODE button will light up a different indicator on the control panel. The exhaust

hose and window kit must be installed when the unit is in Air Conditioner, Dehumidifier mode,

Auto mode, and Sleep mode. When using the unit as a fan, the window kit is not required.

3) Mirage Display - Press the MIRAGE button to activate the Mirage Display on the front of the

unit. The Mirage Display conveniently shows the ambient temperature from across the room or

the temperature setting on the control panel.

4) Temperature - Select the desired temperature by pressing either the + or - button when using

the unit in Air Conditioner mode. The temperature indicator flashes to display the desired tem-

perature setting. After the temperature is set, the unit will display this temperature setting until

it is changed by the user. The temperature indicator display shows temperature in Fahrenheit.

While the unit is on, press the + and - buttons simultaneously to switch between Celsius and

Fahrenheit.

5) Fan Speed - Press FAN SPEED button to choose fan speed in Quiet, High or Low.

6) Timer - Press TIMER button to set the unit automatically turn ON or OFF. Use the + and - but-

tons to program the hour increment.

7) Turbo Cool - When Turbo Cool is activated, the unit will cool at 61°F on fan high for 10

minutes and then return to the original settings.

8) Bucket Full - When the unit cannot evaporate the collected moisture fast enough, the excess

water will collect in a backup water tank located inside the unit. The BUCKET FULL indicator

will light up.

Sleep Mode

Indicator

Quiet Mode

Indicator

Auto Mode

Indicator

Air Conditioner

Mode Indicator

Fan Mode

Indicator

Power

Indicator

Bucket Full

Indicator

Turbo Cool

Indicator

Timer

Indicator

Dehumidifier Mode

Indicator

CONTROL PANEL

Mirage Display

Indicator

Fan Speed

Indicators

LCD DISPLAY

POWER BUTTON

TIMER/TEMP DECREASE

CHILD LOCK BUTTON

SLEEP BUTTON

TIMER BUTTON

TURBO COOL BUTTON

°C/°F SWITCH BUTTON

FAN SPEED

MY TEMP BUTTON

REMOTE CONTROL

MODE BUTTON

MIRAGE DISPLAY BUTTON

Este manual sirve para los siguientes modelos

Otros manuales de Acondicionador de aire de Soleus Air

Soleus Air

Soleus Air KFR/KFS Series Manual de usuario

Soleus Air

Soleus Air KY4-100 Manual de usuario

Soleus Air

Soleus Air Soleus LX-100 LX-100 Manual de usuario

Soleus Air

Soleus Air PH4-13R-01 Manual de usuario

Soleus Air

Soleus Air PH3-09R Manual de usuario

Soleus Air

Soleus Air PSH-08-01 Manual de usuario

Soleus Air

Soleus Air WS2-06E-201 Manual de usuario

Soleus Air

Soleus Air GM-TTW-10HC Manual de usuario

Soleus Air

Soleus Air TTWM1-14H-01 Manual de usuario

Soleus Air

Soleus Air PH4-12R-01 Manual de usuario

Soleus Air

Soleus Air SG-WAC-18HCE Manual de usuario

Soleus Air

Soleus Air MA-9000AH Manual de usuario

Soleus Air

Soleus Air MAC-12K/10K Manual de usuario

Soleus Air

Soleus Air GB-WAC-06SE-C Manual de usuario

Soleus Air

Soleus Air 3046364 Manual de usuario

Soleus Air

Soleus Air KY-32H Manual de usuario

Soleus Air

Soleus Air SG-TTW-12HC Manual de usuario

Soleus Air

Soleus Air Soleus LX-100 LX-100 Manual de usuario

Soleus Air

Soleus Air KC-45H Hoja de especificaciones

Soleus Air

Soleus Air GM-PAC-10E2 Manual de usuario

Soleus Air

Soleus Air LX-140 Manual de usuario

Soleus Air

Soleus Air PE1-09R-30 Manual de usuario

Soleus Air

Soleus Air PE2-10R-32 Manual de usuario

Soleus Air

Soleus Air PE3-12R-03 Manual de usuario

Manuales populares de Acondicionador de aire de otras marcas

Spheros

Spheros CC 355 Manual de usuario

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE Manual de usuario

Panasonic

Panasonic CS-E12HKEW Manual de usuario

nedis

nedis ACMB1WT7 Manual de usuario

Samsung

Samsung AR KV Series Guía

Daikin

Daikin FCFV50A Manual de usuario

Fujitsu

Fujitsu Inverter ASBA30JFC Manual de usuario

Toshiba

Toshiba RAS-M10SMUV-E Manual de usuario

Daikin

Daikin FXLQ20MAVE Manual de usuario

Hitachi

Hitachi RAS-E24CAK Manual de usuario

CIAT

CIAT Magister 2 Series Guía

Bestron

Bestron AAC6000 Manual de usuario

Hisense

Hisense 7K Manual técnico

Frigidaire

Frigidaire FFRE0533S1E0 Manual de usuario

Samsung

Samsung AS09HM3N Manual de usuario

Frigidaire

Frigidaire CRA073PU11 Manual del propietario

McQuay

McQuay MCK020A Manual de usuario

Webasto

Webasto Frigo Top 25 DS Manual de usuario