SMC Networks TigerStack II SMC8926EM Manual de programación

MANAGEMENT GUIDE

SMC8926EM

SMC8950EM

TigerStack II 10/100/1000

24/48-Port Stackable Layer 3 Gigabit

Switch

20 Mason

Irvine, CA 92618

Phone: (949) 679-8000

TigerStack II 10/100/1000

Management Guide

From SMC's Tiger line of feature-rich workgroup LAN solutions

August 2009

Pub. # 149100000035A

E082009-MW-R01

Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate and

reliable. However, no responsibility is assumed by SMC for its use, nor for any

infringements of patents or other rights of third parties which may result from its use. No

license is granted by implication or otherwise under any patent or patent rights of SMC.

SMC reserves the right to change specifications at any time without notice.

SMC Networks, Inc.

20 Mason

Irvine, CA 92618

Trademarks:

SMC is a registered trademark; and EZ Switch, TigerStack and TigerSwitch are

trademarks of SMC Networks, Inc. Other product and company names are trademarks or

registered trademarks of their respective holders.

Warranty and Product Registration

To register SMC products and to review the detailed warranty statement, please refer to

the Support Section of the SMC Website at http://www.smc.com.

About This Guide

Purpose

This guide gives specific information on how to operate and use the management

functions of the switch.

Audience

The guide is intended for use by network administrators who are responsible for operating

and maintaining network equipment; consequently, it assumes a basic working

knowledge of general switch functions, the Internet Protocol (IP), and Simple Network

Management Protocol (SNMP).

Conventions

The following conventions are used throughout this guide to show information:

Note: Emphasizes important information or calls your attention to related features or

instructions.

Caution: Alerts you to a potential hazard that could cause loss of data, or damage the

system or equipment.

Warning: Alerts you to a potential hazard that could cause personal injury.

Related Publications

The following publication details the hardware features of the switch, including the

physical and performance-related characteristics, and how to install the switch:

The Installation Guide

Also, as part of the switch’s software, there is an online web-based help that describes all

management related features.

Revision History

This section summarizes the changes in each revision of this guide.

August 2009 Revision

This is the first release of this guide.

iii

Contents

Section I: Getting Started

Chapter 1: Introduction 1-1

Key Features 1-1

Description of Software Features 1-2

System Defaults 1-7

Chapter 2: Initial Configuration 2-1

Connecting to the Switch 2-1

Configuration Options 2-1

Required Connections 2-2

Remote Connections 2-3

Stack Operations 2-3

Selecting the Stack Master 2-3

Selecting the Backup Unit 2-4

Recovering from Stack Failure or Topology Change 2-4

Broken Link for Line and Wrap-around Topologies 2-4

Resilient IP Interface for Management Access 2-5

Resilient Configuration 2-5

Renumbering the Stack 2-5

Ensuring Consistent Code is Used Across the Stack 2-5

Basic Configuration 2-6

Console Connection 2-6

Setting Passwords 2-7

Setting an IP Address 2-7

Manual Configuration 2-8

Dynamic Configuration 2-11

Enabling SNMP Management Access 2-13

Community Strings (for SNMP version 1 and 2c clients) 2-13

Trap Receivers 2-14

Configuring Access for SNMP Version 3 Clients 2-15

Managing System Files 2-15

Saving Configuration Settings 2-16

Section II: Switch Management

Chapter 3: Configuring the Switch 3-1

Using the Web Interface 3-1

Navigating the Web Browser Interface 3-2

Home Page 3-2

Configuration Options 3-3

Panel Display 3-3

Contents

Main Menu 3-4

Chapter 4: Basic Management Tasks 4-1

Displaying System Information 4-1

Displaying Switch Hardware/Software Versions 4-3

Displaying Bridge Extension Capabilities 4-4

Setting the Switch’s IP Address (IP Version 4) 4-5

Manual Configuration 4-7

Using DHCP/BOOTP 4-8

Setting the Switch’s IP Address (IP Version 6) 4-9

Configuring an IPv6 Address 4-9

Configuring an IPv6 General Network Prefix 4-15

Configuring Neighbor Detection Protocol and Static Entries 4-17

Configuring Support for Jumbo Frames 4-21

Managing Firmware 4-21

Downloading System Software from a Server 4-22

Saving or Restoring Configuration Settings 4-24

Downloading Configuration Settings from a Server 4-25

Console Port Settings 4-26

Telnet Settings 4-28

Configuring Event Logging 4-30

System Log Configuration 4-30

Remote Log Configuration 4-31

Displaying Log Messages 4-33

Sending Simple Mail Transfer Protocol Alerts 4-33

Renumbering the Stack 4-35

Resetting the System 4-36

Setting the System Clock 4-36

Setting the Current Time 4-37

Configuring SNTP 4-37

Setting the Time Zone 4-39

Configuring Summer Time 4-40

Chapter 5: Simple Network Management Protocol 5-1

Enabling the SNMP Agent 5-2

Setting Community Access Strings 5-3

Specifying Trap Managers and Trap Types 5-4

Configuring SNMPv3 Management Access 5-7

Setting a Local Engine ID 5-7

Specifying a Remote Engine ID 5-8

Configuring SNMPv3 Users 5-9

Configuring Remote SNMPv3 Users 5-11

Configuring SNMPv3 Groups 5-13

Setting SNMPv3 Views 5-17

Contents

Chapter 6: User Authentication 6-1

Configuring User Accounts 6-1

Configuring Local/Remote Logon Authentication 6-2

Configuring HTTPS 6-5

Replacing the Default Secure-site Certificate 6-7

Configuring the Secure Shell 6-8

Generating the Host Key Pair 6-10

Importing User Public Keys 6-12

Configuring the SSH Server 6-14

Configuring Port Security 6-16

Configuring 802.1X Port Authentication 6-18

Displaying 802.1X Global Settings 6-19

Configuring 802.1X Global Settings 6-20

Configuring Port Settings for 802.1X 6-20

Displaying 802.1X Statistics 6-24

Filtering IP Addresses for Management Access 6-26

Chapter 7: Access Control Lists 7-1

Configuring Access Control Lists 7-1

Setting the ACL Name and Type 7-1

Configuring a Standard IPv4 ACL 7-2

Configuring an Extended IPv4 ACL 7-3

Configuring a MAC ACL 7-6

Configuring a Standard IPv6 ACL 7-7

Configuring an Extended IPv6 ACL 7-8

Binding a Port to an Access Control List 7-11

Chapter 8: Port Configuration 8-1

Displaying Connection Status 8-1

Configuring Interface Connections 8-3

Creating Trunk Groups 8-6

Statically Configuring a Trunk 8-7

Enabling LACP on Selected Ports 8-8

Configuring LACP Parameters 8-10

Displaying LACP Port Counters 8-13

Displaying LACP Settings and Status for the Local Side 8-14

Displaying LACP Settings and Status for the Remote Side 8-16

Setting Broadcast Storm Thresholds 8-17

Configuring Port Mirroring 8-19

Configuring Rate Limits 8-20

Showing Port Statistics 8-22

Chapter 9: Address Table Settings 9-1

Setting Static Addresses 9-1

Displaying the Address Table 9-2

Changing the Aging Time 9-4

Contents

Chapter 10: Spanning Tree Algorithm 10-1

Displaying Global Settings 10-3

Configuring Global Settings 10-6

Displaying Interface Settings 10-10

Configuring Interface Settings 10-13

Configuring Multiple Spanning Trees 10-16

Displaying Interface Settings for MSTP 10-19

Configuring Interface Settings for MSTP 10-20

Chapter 11: VLAN Configuration 11-1

IEEE 802.1Q VLANs 11-1

Enabling or Disabling GVRP (Global Setting) 11-4

Displaying Basic VLAN Information 11-4

Displaying Current VLANs 11-5

Creating VLANs 11-6

Adding Static Members to VLANs (VLAN Index) 11-7

Adding Static Members to VLANs (Port Index) 11-9

Configuring VLAN Behavior for Interfaces 11-10

Configuring IEEE 802.1Q Tunneling 11-12

Enabling QinQ Tunneling on the Switch 11-16

Adding an Interface to a QinQ Tunnel 11-17

Configuring Private VLANs 11-18

Enabling Private VLANs 11-19

Configuring Uplink and Downlink Ports 11-19

Configuring Protocol-Based VLANs 11-20

Configuring Protocol Groups 11-20

Mapping Protocols to VLANs 11-21

Chapter 12: Link Layer Discovery Protocol 12-1

Setting Basic LLDP Timing Attributes 12-1

Configuring LLDP Interface Attributes 12-3

Displaying LLDP Local Device Information 12-5

Displaying LLDP Remote Port Information 12-8

Displaying LLDP Remote Information Details 12-9

Displaying Device Statistics 12-11

Displaying Detailed Device Statistics 12-13

Chapter 13: Class of Service 13-1

Layer 2 Queue Settings 13-1

Setting the Default Priority for Interfaces 13-1

Mapping CoS Values to Egress Queues 13-3

Selecting the Queue Mode 13-5

Setting the Service Weight for Traffic Classes 13-6

Layer 3/4 Priority Settings 13-7

Mapping Layer 3/4 Priorities to CoS Values 13-7

Selecting IP Precedence/DSCP Priority 13-7

Otros manuales para TigerStack II SMC8926EM

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cambiar de SMC Networks

SMC Networks

SMC Networks ISE70-*-L2 series Manual de instalación

SMC Networks

SMC Networks GS1601 Instrucciones de funcionamiento y seguridad

SMC Networks

SMC Networks ISE70 Manual de usuario

SMC Networks

SMC Networks PF2D5 Series Manual de usuario

SMC Networks

SMC Networks 6152PL2 FICHE Manual de programación

SMC Networks

SMC Networks 9712F - FICHE TECHNIQUE Manual de usuario

SMC Networks

SMC Networks PFMC Series Manual de usuario

SMC Networks

SMC Networks 8624T - annexe 1 Manual de programación

SMC Networks

SMC Networks TigerCard SMC8724M Manual de usuario

SMC Networks

SMC Networks ZSE30A series Manual de usuario

SMC Networks

SMC Networks SMC6248M Manual de usuario

SMC Networks

SMC Networks SMC6152L2 Manual de usuario

SMC Networks

SMC Networks PF2M7 Series Manual de usuario

SMC Networks

SMC Networks ZSE40A Manual de usuario

SMC Networks

SMC Networks TigerStack SMC6924MT Manual de usuario

SMC Networks

SMC Networks EZ Net 16SW EZNET-16SW Manual de usuario

SMC Networks

SMC Networks ZSE30A series Manual de usuario

SMC Networks

SMC Networks TigerSwitch SMC8728L2 Manual de programación

SMC Networks

SMC Networks ZSE30A series Manual de usuario

SMC Networks

SMC Networks 6900FSC FICHE Manual de usuario

SMC Networks

SMC Networks Tiger Switch 10/100 SMC6704M Manual de usuario

SMC Networks

SMC Networks SMC8724ML3 Manual de usuario

SMC Networks

SMC Networks ISE35 Manual de usuario

SMC Networks

SMC Networks EZ Networking SMC-EZ108FDT Manual de usuario

Manuales populares de Cambiar de otras marcas

URC

URC Total Control MFS-8 Manual de usuario

Azbil

Azbil HPQ-D11 Manual de usuario

Sony

Sony DFS-900M Manual de usuario

SICK

SICK i17S Manual de usuario

F&F

F&F SZR-277 Manual de usuario

Shure

Shure UAMS/BK Manual de usuario

Dräger

Dräger X-zone Switch Off Manual de usuario

Asco

Asco Joucomatic 349 Series Manual de usuario

BT Mini Hub Manual de usuario

D-Link

D-Link DES-1226G Manual de usuario

Johnson Controls

Johnson Controls FS80-C Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manual de usuario

MicroNet

MicroNet SP1200A Manual de usuario

Ruijie

Ruijie RG-PF2920 Series Manual de instalación y funcionamiento

Altinex

Altinex DA1914SX Manual de usuario

MiLAN

MiLAN MIL-SM2401M Manual de usuario

RJM

RJM MASTERMIND PBC/6X Manual de usuario

Atlas

Atlas MMK-KVM8 Manual de usuario