Simply Shade AG45RLD-LS-3 Manual de usuario

welcoming • sophisticated • inspiring

PLEASE RETAIN YOUR RECEIPT. WARRANTY CLAIMS

WILL NOT BE RECOGNIZED WITHOUT A DATED RECEIPT.

ITEM# 804780/876120

MODEL# AG45RLD-LS-3/4

11 FT LED CANTILEVER UMBRELLA

Questions, problems, missing parts? Before returning to yourretailer, call ourcustomer

service departmentat 1-844-230-9904,8 a.m. – 8 p.m., EST, Monday - Friday, or visit

www.myshadesource.com for more information.

Purchase Date

English

PART DESCRIPTION QUANTITY

A Umbrella1

BSolar Panel 1

CRotating Hub

Metal Stand

AC Adapter

Pole Cap

Base Plug

Thank you for purchasing the SimplyShade 11-ft LED Cantilever Umbrella.

NOTE: The Solar Panel (B) contains two lithium batteries (2 x 2200mAh). Do not attempt

to open the solar panel when in use.

AC Adapter (F)

Input: 100V~240V AC, Output: 4.2V DC

D 1

Plastic Base Interior 2

PACKAGE CONTENTS

E1 Plastic Base Exterior 2

HARDWARE CONTENTS (not shown to actual size)

AA BB CC DD EE

Large Wrench

Qty: 1

Small Wrench

Qty: 1

Bolt

Qty: 6

Washer

Qty: 6

Crank Handle

Qty: 1

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install the

product.

WARNING

Assemble on asoft, clean, non-abrasive surface to avoid damage to the item. Item is heavy. Use care

when handling. May require two adults for safe assembly. Crank the umbrella to its closed position

during windy weather conditions.

This outdoor umbrella is designed and made for personal non-commercial use. It should not be used as a

toy or atool. Children under age of 16 should not be engaged in the assembly, removal or disassembly.

Children under the age of 10 should be supervised by a competent adult while using this furniture.

NOTE: This equipment has been tested and found to comply with the limits for aClass B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference

will not occur in aparticular installation. If this equipmentdoes cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

-- Reposition or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on acircuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician forhelp.

CAUTION

To prevent personal injury or damage,always take down the umbrella when not in use, during windy

conditions or in rain. Do not operate or attempt to charge the umbrella when water is present so as to

prevent damage to the electrical components.

PREPARATION

Before beginning the assembly of product, make sure all parts are present. Compare parts with

package contents list and hardware contents list. If any part is missing or damaged, do not attempt to

assemble, install or operate the product.

Estimated Assembly Time: 40 minutes

Tools Required for Assembly (included): Wrench

ASSEMBLY INSTRUCTIONS

2. Line up the holes in the Rotating Hub (C) on top of

the Metal Stand (D). Secure the Rotating Hub (C) to

the Metal Stand (D) with 4pcs Bolts (CC) and 4pcs

Washers (DD). Tighten with the Large Wrench (AA).

Hardware Used

Large Wrench

Bolt

x 1

x 4

Washer x 4

Base Plug x 4

E/E1

sand

water

1. Assemble the Metal Stand (D) by overlapping the

metal bars together on the ground in a cross pattern as

shown.

3. Remove each Base Plug (FF) by turning counter-

clockwise . Fill each section of Base (E/E1) with

50-lbs to 60-lbs of sand (not included), 220-lbs for all

four, pouring water into the base intermittently to help

pack the sand. Screw the Base Plug (FF) clockwise

back into place.

Ensure that the rubber gasket is present on the Base

Plug (FF) to prevent the Base (E/E1) from leaking.

When filling, leave a small void in the base to allow

room for the water to expand when it freezes in the

winter.

open

Each section requires a minimum of

50-lbs of sand. Water alone will not

support the weight of the cantilever.

ASSEMBLY INSTRUCTIONS

4. Assemble the Plastic Base (E/E1) by interlocking

the 4pcs together onto the Metal Stand (D).

You may need to reposition the pedal on the Rotating

Hub (C) in this step. To do this, press down on the

pedal and rotate either direction to reach desired

position.

5. To install the Solar Panel (B), remove the Pole

Cap (GG) on top of the pole by turning in a counter-

clockwise direction . Insert the tabs on the bottom

of the Solar Panel (B) into the slots on the top of the

pole and twist in a clockwise direction

approximately 1/4 turn until it is secure.

Save the Pole Cap (GG) for future use. To extend the

life of the Solar Panel (B), it is recommended to

remove the solar panel and replace the pole cap thru

the winter or during extended periods when the

umbrella is not in use.

6. Fit the Crank Handle (EE) over the crank

mechanism. Secure the Crank Handle (EE) onto the

crank mechanism using the Small Wrench (BB) to

tighten the setscrew.

x 1

Small Wrench

Crank Handle x 1

6BB

iii

ASSEMBLY INSTRUCTIONS

7. Line up the two holes in the bottom of the Umbrella

(A) pole with the Rotating Hub (C) and slide the

Umbrella (A) pole down over the Rotating Hub (C) .

Using the Large Wrench (AA), secure the Umbrella

(A) pole to the Rotating Hub (C) with 2pcs Bolts (CC)

and 2pcs Washers (DD) .

CAUTION: When cranking the umbrella open, if you feel

resistance and the canopy is not opening, do not force

the Crank Handle (EE). Gently spread the umbrella ribs

by hand and shake the fabric, then continue to crank

open.

OPERATING INSTRUCTIONS

x 1

x 2

Large Wrench

Bolt

Washer x 2

Storage Tie

8. With the umbrella in an upright position, unfasten the

Storage Tie from around the canopy. Gently spread the

umbrella ribs and fabric by hand to free up parts that

may have become wedged during shipping.

9. With the canopy fully opened, grip the lever on the

vertical slide handle and raise or lower the canopy to

desired angle. Release the slide handle to lock into

place. To close the umbrella, turn the Crank Handle

(EE) counter-clockwise .

To prevent undue stress on the cranking system, do not

attempt to crank open the umbrella from the lowest

position. Open the umbrella canopy by (1) gripping the

lever on the vertical slide handle, then slowly raise to a

convenient height. Release the slide handle to lock into

place. (2) Slowly turn the Crank Handle (EE) in a

clockwise direction until the canopy is fully opened.

WARNING: DO NOT open the umbrella in a counter-

clockwise direction. It will not stay open and may

close unexpectedly.

100V~240V AC

Light Switch

a) The Solar Panel (B) contains two lithium batteries

(2 x 2200mAh). Press the switch to the off position

during daylight to allow the solar panel to charge

the batteries. Charging time is dependent on the

amount of sunlight, however, 8 hours is

recommended.

b) The batteries can also be charged using the

100V~240V AC Adapter (F) by plugging it into the

umbrella pole as shown. Charging time is

approximately 5 - 6 hours.

c) If the batteries are dead, the lights will operate with

the AC Adapter (F) plugged in. The red light on the

AC Adapter (F) indicates power is present.

d) Keep the umbrella unplugged and the AC Adapter

(F) stored in a dry location when not in use.

OPERATING INSTRUCTIONS

10. To rotate the Umbrella (A) canopy horizontally,

place foot on the foot pedal of the Rotating Hub (C)

and hands on the umbrella pole. Depress the pedal

and rotate the umbrella in either direction to reach

desired position. Release foot pedal to lock into place.

WARNING: Always close the umbrella and secure the

canopy to the umbrella pole with Storage Tie when not

in use and during high winds or rain. Failure to do so

may result in personal injury and/or damage.

11. To operate the LED lights, press the rocker switch

located on the umbrella pole on or off.

NOTE:

ONE- YEAR LIMITED WARRANTY

Umbrella frames are warranted for a period of one (1) year.

Exceptions: Items used for commercial, contract or other non-residential purposes, display models,

items purchased as-is, or items damaged due to acts of nature, vandalism, misuse or improper

assembly are not covered. Discoloration or fading of the finish or fabrics as a result of exposure to

the elements, chemicals or spills are not covered. Tabletop glass breakage, corrosion or rusting of

hardware and damages to frames or welds caused by improper assembly, misuse or natural causes

are not covered.

Warranty to the original purchaser is non-transferable. All warranty claims require a dated sales

receipt. Any replacement of warranted items will be in the original style and color, or a similar style

and color if the original is unavailable or has been discontinued. We do not reimburse for

transportation or delivery costs, or compensate the individual or any outside party for assembling or

disassembling the product.

REPLACEMENT PARTS LIST

For replacement parts, call our customer service department at 1-844-230-9904, 8 a.m. - 8 p.m.,

EST, Monday - Friday, or visit www.myshadesource.com for more information.

DESCRIPTION PART#PART

AA 6#

BB Small Wrench

Large Wrench

2.5#

CC Bolt

Base Plug

Pole Cap

Solar Panel

A92

DD Washer

D10

Crank Handle NA

E-11-036

E-04-151

G-03-007

AC Adapter

FG-09-027

CARE AND MAINTENANCE

. Before using, clean the product completely with a soft, dry towel.

. Wash with a mild solution of soap and water; rinse dry completely. Do not use strong detergent or

abrasive cleaners.

. Store the product in a cool, dry location away from sunlight.

. Store the umbrella out of bad weather or high winds.

TROUBLESHOOTING

1. The solar panel may not be properly installed. Remove the solar panel and repeat Step 5,

ensuring that the fixed barrel connectors line up correctly.

2. The batteries may be dead. Press the switch to the OFF position. With the solar panel properly

installed, allow approximately 8 hours of sunlight on the solar panel or 6 hours with the AC adapter

plugged in to charge the batteries.

3. If the lights do not work after troubleshooting steps 1 and 2, please contact customer service to

further diagnose the problem.

PROBLEM POSSIBLE CAUSE

The umbrella

lights only work

when plugged in

Este manual sirve para los siguientes modelos

Tabla de contenidos

Manuales populares de Carpa de otras marcas

OZTENT

OZTENT JV SIGNATURE EDITION Manual de usuario

GigaTent

GigaTent Summer Chalet Mini Tent Manual de usuario

Coleman

Coleman 2000007827 Manual

ShelterLogic

ShelterLogic 107153 Manual de usuario

Outsunny

Outsunny 84C-230 Manual de usuario

Napier

Napier SPORTZ COVE 61 Series Manual de usuario

EuroTrail

EuroTrail ATLANTIS PRO Manual de usuario

Reimo

Reimo Marina Manual de usuario

TiiTENT

TiiTENT TB300 Manual de usuario

Coleman

Coleman 2000033134 Guía de instalación

Ozark Trail

Ozark Trail W784.1 Guía de inicio rápido

SlingFin

SlingFin CrossBow 2 Manual de usuario

Coleman

Coleman 9600-141 Manual de usuario

Palram

Palram Arizona 5000 Wave - WINGS Manual de usuario

COVERPRO

COVERPRO 56184 Instrucciones de montaje

Vango

Vango Zenith 100 Manual de usuario

Costway

Costway PATIOJOY OP70818 Manual de usuario

Clarke

Clarke PUC 88 Manual de usuario