Siemens HLIM Manual de usuario

Siemens Building Technologies

Fire Safety

P/N 315-033170-2

OPERATION The SIEMENS Model HLIM Loop Isolator Module solates short c rcu ts on F reF nder-

XLS analog loops. By plac ng dev ces between HLIMs dur ng nstallat on, a short n

the w r ng w th n that group s d sconnected from the rest of the loop. The rema nder

Figure 1

The HLIM-1 Loop Isolator Module

does not have a loop address and therefore does not requ re address programm ng

nor does t reduce the loop capac ty below 252 dev ces.

Remove all system power before installation, first the battery and then the AC.

INSTALLATION The HLIM s a polar ty nsens t ve module. Refer to F gure 1 for the locat on of the

two nput term nals and two output term nals. L ne 1 and L ne 2 can be e ther l ne of

the loop.

The HLIM may be used n two c rcu t conf gurat ons as follows:

Class B (See F gure 2) In Class B w r ng each HLIM solates a branch on the c rcu t. Note that

a short on the ma n branch causes the ent re loop to fa l. To prevent th s, mount the

HLIMs at the F reF nder-XLS enclosure and run each branch ndependently.

of the dev ces cont nue

to operate. The HLIM

operates n both Class A

and Class B c rcu ts.

A yellow LED flashes

when a dev ce detects a

short c rcu t. The HLIM

then solates that part of

the loop. When the short

s removed, the HLIM

automat cally restores

the loop to normal

operat on. The HLIM

FRONT BACK

FAULT

IN - LINE 1

IN - LINE 2

OUT - LINE 1

OUT - LINE 2

Loop Isolator Module

Installation Instructions

Model HLIM

Siemens Building Technologies

Fire Safety

P/N 315-033170-

Figure 2

HLIM Wiring Diagram - Class B Installation

Class A S ngle Loop (See F gure 3) In Class A w r ng the HLIMs are w red n ser es w th the loop w r ng.

Th s results n a s ngle cont nuous loop. If any group n the loop has a short, that

group s lost and a Class A c rcu t fa lure results. The F reF nder-XLS d splays commu-

n cat on errors for the dev ces and a Class A fa lure for the loop tself.

Figure 3

HLIM Wiring Diagram - Class A Installation Single Loop)

1. All wiring must comply with

national and local codes.

. In order to provide adequate

protection, it is recom-

mended that you do not

install more than 0 devices

on a single HLIM.

3. Minimum wire gauge is

18 AWG.

4. The total wire resistance

(both wires) between HLIMs

cannot exceed 0 ohms.

5. Do not install more than 15

HLIMs per DLC loop.

6. All circuits are supervised.

7. Refer to DLC Installation

Instructions, P/N 315-033090

for the list of compatible

devices.

8. All terminals are power

limited.

1. All wiring must comply with

national and local codes.

. In order to provide adequate

protection, it is recom-

mended that you do not

install more than 0 devices

on a single HLIM.

3. Minimum wire gauge is

18 AWG.

4. The total wire resistance

(both wires) between HLIMs

cannot exceed 0 ohms.

5. Do not install more than 15

HLIMs per DLC loop.

6. All circuits are supervised.

7. Refer to DLC Installation

Instructions, P/N 315-033090

for the list of compatible

devices.

8. All terminals are power

limited.

ANALOG LOOP

LINE 1

LINE 2

IN IN OUT OUTIN IN OUT OUTIN IN OUT OUT

TO ANALOG

LOOP RETURN

INSIDE ENCLOSURE

TO ANALOG

LOOP FEED

LINE 1

LINE 2

LINE 1

IN IN OUT OUT

IN IN OUT OUT IN IN OUT OUT

ININ

OUTOUT

ININ

OUTOUT

ININ

OUTOUT

Siemens Building Technologies

Fire Safety

P/N 315-033170-3

Figure 4

Mounting

Mechan cal Installat on (See F gure 4)

 Use a standard 3 1/2- nch deep, double gang electr cal sw tchbox or a 4- nch

square electr cal box that s 2 1/8 nches deep.

 Connect the f eld w r ng. Press the HLIM nto the box and fasten the

module plate to the box.

 Cover the module front plate w th the plate suppl ed and fasten w th screws

suppl ed.

ELECTRICAL RATINGS Input power: 24 VDC, 1mA max

SWITCHPLATE

4-INCHES SQUARE

(SUPPLIED)

SWITCHPLATE

(SUPPLIED)

4-INCHES SQUARE

4-INCH SQUARE BOX

2 1/8-INCHES DEEP

DOUBLE GANG BOX

3 1/2-INCHES DEEP

Siemens Building Technologies, Inc.

8 Fernwood Road

Florham Park, New Jersey 0793

Siemens Building Technologies, Ltd.

Kenview Boulevard

Brampton, Ontario L6T 5E4 P/N 315-033170-

Tabla de contenidos

Otros manuales de Unidad de control de Siemens

Siemens

Siemens SM 338 Manual de usuario

Siemens

Siemens LMV 5 Series Manual de usuario

Siemens

Siemens FDCI223 Manual de usuario

Siemens

Siemens SINUMERIK 840D Manual de usuario

Siemens

Siemens SIMATIC NET Manual de usuario

Siemens

Siemens Climatix POL822 Manual de usuario

Siemens

Siemens SIMADYN D SS52 Manual de usuario

Siemens

Siemens SIMATIC FM 453 Manual de usuario

Siemens

Siemens SIMOTION D4 Series Manual de usuario

Siemens

Siemens VAI61 Series Manual de usuario

Siemens

Siemens MICROMASTER 420 Manual de usuario

Siemens

Siemens SCALANCE S623 Manual de usuario

Siemens

Siemens 3RK1200-0C.03-0AA2 Manual de usuario

Siemens

Siemens SINUMERIK 840Di sl Manual de usuario

Siemens

Siemens Simatic S7-1500 Manual de usuario

Siemens

Siemens MM7000 Series Manual de usuario

Siemens

Siemens SMF6120 Manual de usuario

Siemens

Siemens Simatic S7-1500 Manual de usuario

Siemens

Siemens SIMATIC 6DL1131-6DF00-0PK0 Documento técnico

Siemens

Siemens 7SA513BB Series Instrucciones de funcionamiento e instalación

Siemens

Siemens FDK:521H1134 Manual de usuario

Siemens

Siemens SED2-LONI/F Manual de usuario

Siemens

Siemens SIMOCODE pro DM-F Local Manual de usuario

Siemens

Siemens CPU 412-5H Documento técnico

Manuales populares de Unidad de control de otras marcas

Festo

Festo Compact Performance CP-FB6-E Manual de lista de piezas

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manual de usuario

JS Automation

JS Automation MPC3034A Manual de usuario

JAUDT

JAUDT SW GII 6406 Series Guía rápida

Spektrum

Spektrum Air Module System Manual de usuario

BOC Edwards

BOC Edwards Q Series Manual de usuario

KHADAS

KHADAS BT Magic Manual de usuario

Etherma

Etherma eNEXHO-IL Manual de usuario

PMFoundations

PMFoundations Attenuverter Manual de usuario

GEA

GEA VARIVENT Manual de usuario

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manual de usuario

Altronix

Altronix LINQ8PD Instrucciones de montaje

Eaton

Eaton Powerware Series Manual de usuario

WAGO

WAGO 750-407/040-000 Manual de usuario

Sony

Sony CCU-590 Manual de usuario

Graco

Graco 25D614 Manual de usuario

Task Force Tips

Task Force Tips YE-RF-900 Manual de programación

Shini

Shini SPV-U Series Manual de usuario