Shure 588SA Manual de usuario
MODELS 588SA, 588SB, AND 588SBE UNISPHERE
B
UNIDIRECTIONAL DYNAMIC MICROPHONES
General:
The Model 588SA, 588SB, and 588SBE Microphones are unidirectional
dynamic microphones with a very effective filter that provides excellent protection
from wind and "pop" (explosive breath sounds). They feature a natural, life-like
reproduction of music and voice, and are ideal for use with good quality sound
systems and tape recorders.
These microphones are particulariy suitable for use in theatres, night clubs,
auditoriums, schools, churches, indoors or outdoors, and any place where omni-
directional microphones may not operate properly because of feedback problems.
These microphones will, in almost every instance, eliminate the annoying loudspeaker
"squeal" caused by feedback and can be used closer to loudspeakers than usual,
without feedback. This suppression of feedback, combined with their smooth sound,
makes these microphones ideal for use with orchestras, small combos, and vocalists.
The microphones feature
:
A
built-in wire-mesh screen with a special filter that provides protection from
wind "pop" (explosive breath sounds). This filter also enables singers and
speakers to perform close to the microphone.
A true cardioid pattern: symmetrical about axis and uniform at all frequencies.
This means that voice and music tonal quality remain the same, even if the
artist or speaker moues about while performing or speaking-and that feedback
and boominess are eliminated or effectively suppressed.
Cartridge shock mounted for quiet operation.
A
built-in "ON-OFF" switch with provision for locking switch in its "ON"
position.
Versatility-for use in the hand or on a stand--indoors or outdoors.
An
adjustable swivel adapter that enables you to aim the microphone where you
want it. Swivel, also, allows for quick removal for use as a hand microphone.
The Model 588SA is high impedance and may be used with any high gain
amplifier with an input of 100,000 ohms or more.
The Model 588SB and 588SBE are low impedance and designed for connection
to a 25 to 200 ohm line or input. This is recommended where long cable lengths
are required or where there are conditions of severe hum disturbance. To use the
Model 588SB or 588SBE with a high impedance amplifier, use a Shure Model A95A
or A95P Line Matching Transformer. The 588SB has 15 feet of cable, the 588SBE
has 30 feet.
Important:
Shure Microphone Cables are selected after exhaustive tests to insure
superior performance in microphones becausc of low capacities, superior shielding
properties and unusually long life under severe use.
Cables with plastic insulation should not be subjected to excessive soldering-iron
heat. Carefully clean and tin the conductors and the connections to which the con-
ductors are to be soldered. The soldering operation can then be done with a minimum
of heat, thereby avoiding any possibility of damage to the cable.
Guarantee:
Each microphone is guaranteed to be free from electrical and mechanical
defects for a period of one year frcm date of shipment from factory, provided all
instructions are complied with fully. In case of damage, return the microphone to the
factory for repairs. Our guarantee is voided if the microphone is subjected to accident
or abuse.
FIJKNISHED ACCESSORY
Swivel Adapter
............................................................................................................
A25B
OPTIONAL ACCESSORIES
............
Line Matching Transformer
......
A95A Vibration-Isolation Stand S39B
Line Matching Transformer
......
A95P Quick Disconnect Isolation Unit
....
A45
Desk Stands
..................
S38B or S33B Accessory Carrying Case
............
AC56
REPLACEMENT COMPONENTS
Swivel Adapter
............................
A25B Cable Assembly
90A1504
..........(
for Model 588SA)
Dynamic Cartridge
..................
99C355 C59
..................(
for Model 588SB)
C59E
..............(
for Model 588SBE)
(21
4
mm)
OVERALL
DIMENSIONS
FIGURE
A
ARCHITECT'S SPECIFICATIONS
The microphone shall be Shure Model 588SA (588SB, 588SBE) or equivalent.
The microphone shall be a moving-coil dynamic type microphone with a shaped
frequency range of 80 to 13,000
Hz.
This unit shall have a Cardioid polar charac-
teristic. The cancellation at the sides shall be approximately 6 db, and the cancel-
lation at the rear shall be 15 to 20 db.
Model 588SA-The microphone shall be high impedance for connection into a
high impedance input.
The microphone output shall be -59.0 db where 0 db
=
1
volt per microbar.
The microphone rating impedance shall be 40,000 ohms and the Gm (sensitivity)
at 1,000
Hz.
shall be within
i
3
db of --155.0 db referenced to EIA Standard
SE-105, August 1949.
Model 588SB, 588SBE-The microphone shall be low impedance for connection
into
a
25 to 200 ohm line.
The microphone output shall be -60.0 db where 0 db
=
1 milliwatt with 10
microbars.
The microphone rating impedance shall be 150 ohm and the Gm (sensitivity) at
1,000
Hz.
shall be within
i
3 db of -153.0 referenced to EIA Standard SE-105,
August 1949.
The Model 588SA (588SB, 588SBE) shall be provided with a swivel adapter
adjustable through 90" from vertical to horizontal. The microphone is equipped with
a built-in "ON-OFF" switch and a one conductor (588SA) or a two conductor
(588SB, 588SBE) shielded cable having Cannon XLR-3-11C connector on micro-
phone end. The microphone swivel adapter will mount on a stand having a %"-27
thread. The overall dimensions shall be 61%2" (164.3mm) in length and 2%"
(54.0 mm) in diameter.
XL-3-IP
rCANNoh
XL-3C
"'
@HL;i
LEMENT
SHILLD
CIBIE-PLUG
ASSEMBU
PUBlilVF
PRFSSURE
PRCOUCLS
POSITIVE
"OLTnGE
ON
PIN
'I.
ChRTRiOliE
PLUG
ELEMENT
BHiELD
I
;;
\
WE
I I
CODED
TERMNIZL
-
CISE
GROUND
ClBLE~PLUU
ASSEMBLY
POSITIVE
PRESSURE
PRODUCES
POSITIVE
YOLTaGE
ON
PIN
'2
MODEL 588SA MODEL 588SB AND 588SBE
INTERNAL CONNECTIONS
FIGURE
B
FREQUENCY
IN
HERTZ
FREQUENCY RESPONSE
FIGURE
C
Type
:
Frequency
Response
:
Polar Pattern
:
Impedance
:
OutputLevel
:
Switch
:
Shock Mount:
Cable
:
SPECIFICATIONS
Dynamic
80 to 13,000
Hz.
(cps) (See Figure
C)
Cardioid (Unidirectional) pattern-Effective rejection of sound
at rear of the microphone is uniform at all frequencies, while
front pickup characteristics are uniform about the axis. See
Figure
D.
Model 588SB and Model 588SBE
..............................
25 to 200 ohms
Model 588SA
..............................................................
High Impedance
1,000 Hz. (cps) response
Model 588SB and Model 588SBE
..............................
Low Impedance
Open circuit voltage
.............................
-
81.5 db
*
(.085mv)
Power Level
.............................................
-
60.0 db
**
EIA Microphone Rating
Gm (Sensitivity)
.................................
-153.0 db
***
Model 588SA
..............................................................
High Impedance
Open circuit voltage
..............................
-
59.0 db
*
(1.11mv)
EIA Microphone Rating
Gm
(Sensitivity)
.................................
-155.0 db
***
*
0 db
=
1 volt per microbar
**
0 db
z
1 Milliwatt with 10 microbars
***
0 db
=
EIA Standard SE-105, August 1949
Built-in "ON-OFF" switch with lockplate furnished. Microphone
is shipped with lockplate installed. To lock switch in "ON" position,
loosen screw on lockplate and turn lockplate 180." Tighten screw.
Internal vibration-isolation of rubber construction.
Highly durable cable with exceptionally effective hum shielding
and with Cannon XLR-9-11C connector on microphone end.
Model 588SB
............
15 foot, two-conductor shielded, rubber jacketed
Model 588SBE
.........
30 foot, two-conductor shielded, rubber jacketed
Model 588SA
...........
15 foot, one-conductor shielded, plastic jacketed
Case
:
Chrome plated die cast with chrome plated steel screens.
Dimensions: See Figure
A.
Net Weight: 12 ounces,
340
grams (less cable)
Copyright 1969, Shure Brothers Inc.
27A637
(1
1-69)
U.S. Patents, 3,132,713
and
3,240,883
Printed
in
U.S.A.
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Otros manuales de Micrófono de Shure
Shure
Shure SM33 Manual de instrucciones
Shure
Shure 520DX Manual de usuario
Shure
Shure Microflex MX405 Manual de usuario
Shure
Shure KSM137 Manual de usuario
Shure
Shure 750B Crystal Manual de usuario
Shure
Shure SV100 Manual de usuario
Shure
Shure Beta 53 Manual de usuario
Shure
Shure PE53 SPHER-0-DYNE Manual de usuario
Shure
Shure ROSWELLITE KSM313 Manual de usuario
Shure
Shure BETA 52A Manual de usuario
Shure
Shure TwinPlex TL47 Series Manual de usuario
Shure
Shure KSM9 Manual de usuario
Shure
Shure DL4 DuraPlex Manual de usuario
Shure
Shure Microflex MX400D Series Manual de usuario
Shure
Shure PGA STUDIO MICROPHONE KIT Manual de usuario
Shure
Shure VP89L Manual de usuario
Shure
Shure ROSWELLITE KSM353 Manual de usuario
Shure
Shure Microflex MX300 series Manual de usuario
Shure
Shure MV51 Manual de usuario
Shure
Shure Microflex MX391 Series Manual de usuario
