Security Camera King HDCV-ELE2MB28 Manual de usuario

2MP HDCVI Covert Camera

HDCV-ELE2MB28

Table of Contents

1General Introduction .......................................................................................................................1

1.1 Overview.............................................................................................................................1

1.2 Features..............................................................................................................................1

2Device Structure..............................................................................................................................2

2.1 Dimension ..........................................................................................................................2

2.2 Cable Port ..........................................................................................................................4

3Installation.........................................................................................................................................6

3.4 Installation for model D .................................................................................................10

3.4.1 Installation for Model D1 (with clamping jaw) ...................................................10

4Menu ................................................................................................................................................12

4.1 HCVR Settings ................................................................................................................12

4.2 Menu Operation ..............................................................................................................12

Appendix ⅠMaintenance .....................................................................................................................14

Welcome

Thank you for purchasing our HDCVI camera!

This user’s manual is designed to be a reference tool for your system.

Please read the following safeguard and warnings carefully before you use this series product!

Please keep this user’s manual well for future reference!

Important Safeguards and Warnings

1．Electrical safety

All installation and operation here should conform to your local electrical safety codes.

The power shall conform to the requirement in the SELV (Safety Extra Low Voltage) and the

Limited power source is rated DC 12V or AC24V in the IEC60950-1. (Power supply requirement is

subject to the device label).

Please install easy-to-use device for power off before installing wiring, which is for emergent power

off when necessary.

Please check if the power supply meets the requirements of working voltage of the camera before

operating the device (The material and length of the power supply cable will influence terminal

voltage value).

Please prevent the line cord from being trampled or pressed, especially the plug, power socket and

the junction from the device.

2．Environment

Please don’t aim the device at strong light (such as lighting, sunlight and so on) to focus.

Please transport, use and store the device within the range of allowed humidity and temperature.

Please do not allow water and other liquid falling into the camera in case that the internal

components are damaged.

Please keep the sound ventilation in case of heat accumulation.

Heavy stress, violent vibration or water splash are not allowed during transportation, storage and

installation.

Please pack the device with standard factory packaging or material with same quality when

transporting the device.

It is recommended to use the device together with lightning protection device to enhance lightning

protection effect.

It is recommended to GND the device to enhance device reliability.

It is advised to use qualified video transmission cable to improve video quality. It is recommended

to use 75-3 coaxial cable or higher standard.

Warning

Please use the standard accessories provided by manufacturer and make sure the device is

installed and fixed by professional engineers.

Please prevent the device surface from the radiation of laser beam when using laser beam device.

Please do not provide two or more power supply modes for the device, otherwise it may cause

damage to the device.

Statement

Please refer to the actual product for more details; the manual is just for reference.

The manual will be regularly upgraded according to the product update; the upgraded content will

be added in the manual without prior announcement.

Please contact the customer service for the latest procedure and supplementary documentation.

The company is not liable for any loss caused by the operation which is not followed by the manual.

Please refer to the company’s final explanation if there is any doubt or dispute.

1General Introduction

1.1 Overview

This series HDCVI camera conforms to the HDCVI standard. It supports video signal high-

speed long distance transmission without any delay. It can be controlled by the HCVR

conforming to the HDCVI.

1.2 Features

Adopt high performance CMOS image sensor, megapixel definition.

Support coaxial transmission of HD video, audio and control signal.

For 720P series, it supports RG59 coaxial transmission without any loss, the distance is

over 800m, for 1080P series, it supports RG59 coaxial transmission without any loss, the

distance is over 500m.

High speed, long distance real-time transmission.

Support HD/SD video output. (some devices only support HD video output)

Support OSD menu adjusting parameters.

Support auto exposure, AWB, auto electronic gain.

Support true WDR function, the range can reach 120dB (only supported by WDR models)

Support DC 12V power supply.

Pinhole cameras can be applied to covert places such as ATM; mobile cameras can be

applied to places such as bus, school bus and subway etc.

2Device Structure

2.1 Dimension

Refer to Figure 2-6 for the dimension. The unit is mm.

Figure 2-6

2.2 Cable Port

Note

The following figures are for reference only, which are only used to know the function of

cable port.

Different devices may have different cables, please refer to the actual device for more

details.

Please refer to Figure 2-9 for DC 12V power input port.

Figure 2-9

Please refer to Figure 2-10 for video output port.

Figure 2-10

Please refer to Figure 2-11 for audio input port.

Figure 2-11

Please refer to Figure 2-12for HD/SD switch control cable.

Figure 2-12

Note

When the two cables become short circuit, then it can realize from HD video output to SD

video output. On the contrary, it will switch back to HD video output when the two cables

become open circuit.

HD/SD switch control cable is only supported by some models.

Please refer to Figure 2-13 for the mobile aviation port.

Figure 2-13

3Installation

Attention:

Please install the device in time after it is taken apart, which is to avoid the camera

module being exposed to damp environment for too long.

Before the installation, please make sure the installation surface is thick enough to sustain

at least 3X weight of the camera.

For the installation mode of side outlet, make sure the direction of side outlet is in

accordance with that of the installation position map when sticking the installation position

map. Besides, pull the cable through the pedestal cable slot before locking the screw.

Please do not remove the electrostatic adsorption film (if yes) on the surface of

transparent cover before installation and debugging is completed, which is to avoid

damage during installation.

The installation figures below are for reference only.

3.4 Installation for model D

3.4.1 Installation

Figure 3-6

Step 1

Pull the camera ③through the installation board ①according to the cable direction, and then

fix it on the installation board via clamping jaw ②.

Step 2

Paste some glass sealant on the back of the joint between camera and installation board,

which is to fix it more firmly.

Step 3

Connect the device cable to the back-end HCVR device.

For mobile model: Connect aviation head cable to the back-end HCVR device.

For general model: Connect the camera BNC cable to the back-end HCVR device, and

connect the power port to power.

So far, the device installation and cable connection have been completed, you can check

monitoring image via back-end encoding device.

4Menu

4.1 HCVR Settings

This HDCVI camera series can adjust OSD menu via coaxial control. After connected the

camera to the HDCVI series HCVR, from Main Menu->Setting->System->PTZ, you need to

select the channel number for access and set control mode as HDCVI and the protocol as HD-

CVI. Click “Save”button to save current setup. See Figure 4-1.

Figure 4-1

4.2 Menu Operation

Click the right mouse button and select “PTZ Control”, then you will see the “PTZ Setup”menu,

which is as shown in Figure 4-2 and Figure 4-3.

Figure 4-2

Figure 4-3

See Table 4-1 for the details of button functions.

Button

Function

Open menu

、

Select menu item

、

Select menu value

Table 4-1

If there is “ ”, click the “Enter”button in “Menu Operation”interface to go to the 2nd menu.

Click “Return” button to go back to the previous menu interface.

Please use a UTC controller or enter the OSD menu for switchover between HD and SD video

output.

Appendix ⅠMaintenance

Caution

Please maintain the device according to the following instructions in order to ensure the image

effect and long-term stable operation of the device.

Maintenance for lens and mirror surface

The lens and mirror surface are covered with antireflection coating, so it may produce

hazardous substance and lead to performance reduction or scratch, dimness etc. when it is

stained with dust, grease, fingerprint and so on, please refer to the following methods to deal

with once dirt is found:

Stained with dirt

Use oil-free soft brush or hair dries to remove it gently.

Stained with grease or fingerprint

Use soft cloth to wipe the water drop or oil gently to make it dry, then use oil-free cotton cloth

or paper soaked with alcohol or detergent to wipe from the lens center to outward. It is ok to

change the cloth and wipe several times if it is not clean enough.

Camera Body Maintenance

Use a soft dry cloth to clean the camera body when it is dirty, in case the dirt is hard to remove,

use a clean dry cloth soaked with mild detergent and wipe gently, make it dry later. Don’t use

volatile solvent like alcohol, benzene, thinner and etc. or strong detergent with abrasiveness,

otherwise it will damage the surface coating or reduce the working performance of the device.

Note

This manual is for reference only. Slight difference may be found in the user

interface.

All the designs and software here are subject to change without prior written

notice.

All trademarks and registered trademarks mentioned are the properties of their

respective owners.

If there is any uncertainty or controversy, please refer to the final explanation of

us.

Please visit our website or contact your local service engineer for more

information.

Tabla de contenidos

Otros manuales de Cámara de seguridad de Security Camera King

Security Camera King

Security Camera King TVIPTZ-TP2IR18XME Manual de usuario

Security Camera King

Security Camera King CVIOD-EL2MPIR50 Manual de usuario

Security Camera King

Security Camera King HDBC-LX1080 Manual de usuario

Security Camera King

Security Camera King IPPTZ-EL1MPIR250L20X Manual de usuario

Security Camera King

Security Camera King CVIOB-ELV22MPIR100LZ2712-D2 Manual de usuario

Security Camera King

Security Camera King TVIOB-PR2EXIR Manual de usuario

Security Camera King

Security Camera King CVIPTZ-EL2L12X-F Manual de usuario

Security Camera King

Security Camera King IPOB-EL2IRE Manual de usuario

Security Camera King

Security Camera King IPVD-EL3MPIR100 Manual de usuario

Security Camera King

Security Camera King TVIOD-PR2EXIR Manual de instalación y operación

Security Camera King

Security Camera King CVIPTZ-EL1MPL20X Manual de usuario

Security Camera King

Security Camera King TVIVD-PR5EXIR28 Manual de usuario

Security Camera King

Security Camera King EL2MPIR250L30X Manual de usuario

Security Camera King

Security Camera King DS-2CD63C5G0-IVS Manual de usuario

Security Camera King

Security Camera King CVIOB-EL4IRZD Manual de usuario

Security Camera King

Security Camera King HDIR7907VF Manual de usuario

Security Camera King

Security Camera King IPPTZ-EL2MPL12X-Mini-F Manual de usuario

Security Camera King

Security Camera King OD-CM600IR50-B Series Manual de usuario

Security Camera King

Security Camera King TVIOB-PR2EXIRZ Manual de usuario

Security Camera King

Security Camera King IPOD-EL2IRE Manual de usuario

Security Camera King

Security Camera King IPOB-ELS2IR12XA-EP Manual de usuario

Security Camera King

Security Camera King IPVD-EL3MPIR Series Manual de usuario

Security Camera King

Security Camera King IPOD-EL1MPIR50-E Manual de usuario

Security Camera King

Security Camera King IPOB-EL1MPIR50-E Manual de usuario

Manuales populares de Cámara de seguridad de otras marcas

Okina USA

Okina USA SIR36-870VF650LP Manual de usuario

Divio

Divio NDR155PA Manual de usuario

Canon

Canon VB-C500D Manual de usuario

Easy Access

Easy Access EasyGuard Manual de usuario

Vivotek

Vivotek FD9389-EHV-v2 Manual de usuario

TUYA

TUYA COSMO W2 Manual de usuario

Eusso

Eusso UNC7500-IR Guía de configuración

urmet domus

urmet domus 1096/204 Manual de usuario

VC VC20 series Manual de usuario

Axis

Axis Q1614 Manual de usuario

ieGeek

ieGeek DD201 Manual de usuario

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manual de usuario

Vicon

Vicon V662-D-1 Instrucciones de funcionamiento

Grundig

Grundig GCH-K0274P Manual de usuario

Lorex

Lorex VANTAGE LBC7032 Manual de usuario

4xem

4xem WPT Manual de usuario

Samsung

Samsung SCV-3082 Manual de usuario

Vitek

Vitek VTC-C544 Manual de usuario