Sealey WC06 Manual de usuario

INSTRUCTIONS FOR

MOTORCYCLE WHEEL CHOCK

MODEL NO’S: WC06, WC07, WC08

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,

and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR

PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

1. SAFETY

WARNING! The warnings, cautions and instructions referred to in this manual cannot cover all possible conditions and situations that may

occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied by the

operator. It is the operators responsibility to secure the load. Check with vehicle manufacturer’s Manual before installing.

9Make sure the wheel of the equipment being mounted or dismounted is aligned with the chock.

9Inspect chock before each use. Check fasteners for tightness, replace any worn or damaged parts.

8DO NOT attempt to use a chock that is damaged in any way.

8DO NOT modify the chock in any way.

9Proper care and maintenance of the chock is critical to safety.

9Proper use of this product is critical to safety. Improper use may result in personal or property damage which is not covered by the

warranty.

2. i INTRODUCTION

Wheel chock supports the wheel of the motorcycle when in transit or storage. Made from black powder coated heavy-duty tubular steel with pre-

drilled holes and fixings which allow chock to be fixed to any suitable surface. A range of three sizes is available covering maximum tyre widths of

95mm, 140mm, and 165mm.

3. SPECIFICATION

Model Number Maximum Tyre Width

WC06 95mm

WC07 140mm

WC08 165mm

4. CONTENTS

Part Description Quantity Part Description Quantity

A Wheel Chock 1 E 1/4” x 5/8” Screws 2

B Spacer Mounting Plates 2 F 2” Screws 4

C Slotted Mounting Plates 2 G Washers 4

D Steel Threaded Studs 2 H Locking Nuts 4

WC06, WC07, WC08 | Issue 1 30/11/17

Original Language Version

Refer to

instruction

manual

Wear protective

gloves

5. ASSEMBLY

5.1. From the underside of the wheel chock place the Steel Threaded Studs (D) into the front holes. Secure in position from the top surface

 usingthe1/4”x5/8”screws(E),seeg.1.

5.1.1. Identifythephysicallocationforthexingsontheintendedmountingsurfaceandcheckforanyobstructions.Drilltherequiredholes

using a 1/4” drill.

5.1.2. SpacerMountingPlate(A)islaiddirectlyonthetopofthexingsurfaceandalignedwithxingholes,seeg.2.

5.1.3. PlaceSlottedMountingPlate(C)ontopofSpacerMountingPlate(A)andsecurewiththe2”screws(F)xedfromtheundersideusing

Washers (G) and Locking Nuts (H).

WARNING: Ensure that the round hole in the Slotted Mounting Plate (C) is nearest to the direction of loading of the wheel into the

 chock.Thiswillensurethatthechockissecuredwhenpushedforward.Ifadditionalxingisrequiredtoensuresafeoperationthere

 aretwofurtherpossiblexingholesateitherendoftheWheelChock.

Original Language Version

fig.1fig.2

WC06, WC07, WC08 | Issue 1 30/11/17

ENVIRONMENT PROTECTION

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to

a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely

unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids

according to local regulations.

Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior

notice.

Important: No Liability is accepted for incorrect use of this product.

Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.

Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR

01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Accesorios para motocicletas de Sealey

Sealey

Sealey PWH615 Manual de usuario

Sealey

Sealey SMC3 Manual de usuario

Sealey

Sealey MS065 Manual de usuario

Sealey

Sealey MS062.V2 Manual de usuario

Sealey

Sealey PWH617 Manual de usuario

Sealey

Sealey VS1830.V2 Manual de usuario

Sealey

Sealey Siegen Tools S01001.V3 Manual de usuario

Sealey

Sealey MS018.V2 Manual de usuario

Sealey

Sealey LINK MONKEY Manual de usuario

Sealey

Sealey MS080.V2 Manual de usuario

Sealey

Sealey MS052.V2 Manual de usuario

Sealey

Sealey MS0630 Manual de usuario

Sealey

Sealey FPS6.V3 Manual de usuario

Sealey

Sealey MS062 Manual de usuario

Sealey

Sealey WORKSAFE SSP78.V2 Manual de usuario

Sealey

Sealey TDMCRW Manual de usuario

Sealey

Sealey VS779.V3 Manual de usuario

Sealey

Sealey PWH699R Manual de usuario

Sealey

Sealey SWH199 Manual de usuario

Sealey

Sealey FPS6 Manual de usuario

Sealey

Sealey MC401 Manual de usuario

Sealey

Sealey TDMCHB Manual de usuario

Sealey

Sealey MS065.V2 Manual de usuario

Sealey

Sealey mc454 Manual de usuario

Manuales populares de Accesorios para motocicletas de otras marcas

SRC

SRC B-TRK502-01-01-SL Manual de usuario

3M Speedglas 9100 MP Manual de usuario

hepco & becker

hepco & becker 6307520 00 01 Manual de usuario

HOMCOM

HOMCOM AA0-077 Manual de usuario

hepco & becker

hepco & becker 6307558 00 01 Manual de usuario

Wunderkind Custom

Wunderkind Custom 106503-F15 Guía del usuario

Dräger

Dräger HPS 3500 Manual de usuario

M-WAVE

M-WAVE SKI Manual de usuario

Kuryakyn

Kuryakyn 6212 Manual de usuario

hepco & becker

hepco & becker 6507504 00 01 Manual de usuario

Tool it

Tool it PROMAX LCD 9.13G Manual de usuario

Custom Dynamics

Custom Dynamics TruWrapz Manual de usuario

Roof

Roof RO200 CARBON Manual de usuario

Kabuto

Kabuto Japan IBUKI Manual de usuario

PUIG

PUIG 5051 Manual de usuario

rizoma

rizoma ZTH050 Manual de usuario

Joubert

Joubert 10001711 Manual de usuario

Sperian

Sperian Optrel p420 Manual de usuario