SDC ZY7500 Series Manual de usuario

SECURITY DOOR CONTROLS

801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 • Fax: (805) 494-8861

www.sdcsecurity.com • E-mail: [email protected]

P:\INSTALLATION INST\Electrified Lockset\INST-ZY7500 REV A 11-17 Page 1

Any suggestions or comments to this instruction or

product are welcome. Please contact us through

our website or email eng[email protected]

A. Door Preparation:

1. Measure desired height from finished floor, mark a horizontal line on door and door edge.

2. Align template on edge of door with applicable horizontal at height line. Check the chart for drilling trim

holes on template and mark only holes for lock function being installed.

3. Mortise door edge according to measurements on

installation template and drill proper holes for trim.

4. Recess for face plate, the dimension is:

L 8-1/32" x W 1-5/16" x D 7/32".

Height line

of lever

or knob

7/32"

INSTALLATION INSTRUCTIONS

ZY7500 SERIES MORTISE LOCK

of cylinder

of lockcase

of lever

or knob

Vertical centerline

Installation

template

Lof

door edge

P:\INSTALLATION INST\Electrified Lockset\INST-ZY7500 REV A 11-17 Page 2

B. Install Lockcase

Make sure the lock hand matches the door hand, use the following diagram to determine the hand of door.

Left Hand

LHRB

Left Hand

Reverse Bevel

INSIDE OF DOOR

OUTSIDE OF DOOR

Right Hand

RHRB

Right Hand

Reverse Bevel

INSIDE OF DOOR

OUTSIDE OF DOOR

1. Change latchbolt handing

If the hand of the latchbolt doesn’t match the door hand, remove the fixing screw and pull the latchbolt out from

lock case. Turn the latchbolt 180 ° to change the handling. Position latchbolt back, into case and fasten it.

Instructions for changing lock hand:

Remove screw

Pull out and turn

2. Change hand of lock

For RH and RHRB, the catch screw will be on the lock case side. For LH and LHRB, the catch screw will be on the

lock cover side.

P:\INSTALLATION INST\Electrified Lockset\INST-ZY7500 REV A 11-17 Page 3

3. Connect wires as shown on the lock cover diagram.

4. Insert lockcase into mortise cut-out and fasten screws to door.

1. Insert spindles as shown

D. Install Lever trim

1. Place the reversible spring cage onto the ferrules with arrow pointing in direction of lever rotation.

2. Install outside trim with mounting posts through door and position lever onto the spindle.

3. Install inside spring cage onto the spindle with the arrow pointing in the direction of inside lever rotation.

4. Install inside mounting plate onto spindle. Tighten with provided screw.

5. Cap inside rose over mounting plate.

C. Install Spindles

B. Install Lockcase (Continued)

Reversible spring cage

Ferrule

Mounting post

Into Mounting post

P:\INSTALLATION INST\Electrified Lockset\INST-ZY7500 REV A 11-17 Page 4

1. Screw cylinder into threaded hole of lock case.

2. Tighten the setting screw against cylinder(s) by turning clockwise as shown.

3. Install face plate onto lock case front and fasten with supplied screws.

E. Install Cylinder and Armor Face Plate

USE THIS CAM.

D. Install Lever trim (continued)

6. Screw inside lever into position and tighten lever collar with supplied spanner wrench.

spanner wrench.

Spanner wrench

Tabla de contenidos

Otros manuales de Cerradura de puerta de SDC

SDC

SDC Z7835 Series Manual de usuario

SDC

SDC Z7600 Series Manual de usuario

SDC

SDC 180 Series Manual de usuario

SDC

SDC E72 EntryCheck Manual de usuario

SDC

SDC Excel E1200 Series Manual de usuario

SDC

SDC Z7800 Series Manual de usuario

SDC

SDC FS23M Series Manual de usuario

SDC

SDC SK-82 Manual de usuario

SDC

SDC Z7500 Series Manual de usuario

SDC

SDC HiTower R7500 Manual de usuario

SDC

SDC PRO Series Manual de usuario

SDC

SDC EntryCheck E75 Series Manual de usuario

SDC

SDC E75 Series Manual de usuario

SDC

SDC Z7200 Manual de usuario

SDC

SDC 30-4 Manual de usuario

SDC

SDC PD2090A Manual de usuario

SDC

SDC E72K-A CIVIC SERIES Manual de instalación

SDC

SDC 1511S Manual de instrucciones

SDC

SDC 30-4-12 Manual de usuario

SDC

SDC S6100 Series Manual de usuario

SDC

SDC S6200 Series Manual de usuario

SDC

SDC Z7700 Series Manual de usuario

SDC

SDC ZA7200 Series Manual de usuario

SDC

SDC E70PS Series Manual del propietario

Manuales populares de Cerradura de puerta de otras marcas

Assa Abloy

Assa Abloy effeff 827A-IP Manual de usuario

We.lock

We.lock SECBNEBL51 Manual de usuario

Iseo

Iseo MA1A Manual de usuario

ID Lock

ID Lock 150 Manual de usuario

Lockly

Lockly ACCESS TOUCH PRO Manual de usuario

iLoq

iLoq G50S Manual de usuario

ilco

ilco 452 Manual de usuario

Samsung

Samsung shs-h705 Manual de usuario

TRU-BOLT

TRU-BOLT 08102017 Manual de usuario

CDVI

CDVI 500-LADJ Manual de usuario

Igloohome

Igloohome Deadbolt 2S Metal Grey Instrucciones de instalación y mantenimiento

eSSL

eSSL FL-300 Manual de usuario

JAKO

JAKO JKBTNX4 Manual de usuario

Dorma

Dorma MUNDUS PREMIUM GK 50 Guía del usuario

SCOOP

SCOOP Pullbloc 4.1 FS Panik Manual de usuario

Yale

Yale MORTISE 8800 SERIES Manual de usuario

Siegenia

Siegenia KFV AS3500 Manual de usuario

Saflok

Saflok Quantum ädesē RFID Manual de usuario