Robe PATT 2013 Manual de usuario

User instructions

PATT 2013

The PATT 2013 is a 750W tungsten softlight housed in a sleek spun aluminium body which maximises its

curves to look as good on stage as the performers it illuminates.

Safety and operating instructions

The manufacturer will not accept liability for any resulting damages caused by the non-observance of this

manual or any unauthorized modication to the device.

Please consider that damages caused by manual modications to the device are not subject to warranty.

During the operation the housing becomes very hot (up to 160°C). Allow the device to cool

approximately 40 minutes prior to manipulate with it.

Min. distance from ammable materials to all exterior surfaces of the luminaire is 0.5m

Make sure that the available voltage is not higher than stated on the device.

Make sure that the power cord is never crimped or damaged by sharp edges. Check the device and the power-

cord from time to time.

Always disconnect from the mains, when the device is not in use or before cleaning it.

This device falls under protection class I and therefore must be earthed.

The electric connection, repairs and servicing must be carried out by a qualied employee.

During the initial start-up some smoke or smell may arise. This is a normal process and does not necessarily

mean that the device is defective.

Do not touch the device’s housing bare hands during its operation (housing becomes hot)!

For replacement use lamp of the same type and rating only.

Disconnect the device from mains before re-lamping or any maintenance/cleaning operations. Allow to cool

cca 40 minutes.

CAUTION ! EYE DAMAGES !

Avoid looking directly into the light source

This device was designed for indoor use only.

This device is for professional use only. It is not for household use.

When choosing the installation spot, please make sure that the device is not exposed to extreme heat, moisture

or dust !

The device never must be covered with cloth or other materials during its operation.

The minimum distance between light output of the and the illuminated surface must be more than 3 meters.

Only operate the xture after having checked that the housing is rmly closed and all screws are tightly fas-

tened.

The maximum ambient temperature 45°C must never be exceeded.

Technical specications

Mains input: 115 V for HPL 750/115 V LAMP

120 V for HPL 750/120 V LAMP

230 V for HPL 750/230 V LAMP

240 V for HPL 750/240 V LAMP

Frequency: 50-60Hz

Max. power consumption: 750W

Lamp base: G 9,5 Special (with heat sink)

Life time: 1500 hrs

Cooling: convection

Max. Surface temperature: 160°C

Min. distance from ammable materials: 0.5 m

Min. distance to alight object: 3 m

Max. ambient operating temperature: 45°C

Weight: 7.2kg

Beam angle: 17°(@1/2 beam), 75° (@1/10 beam)

Mounting Points: Mounting horizontally or vertically via mounting yoke

(360° tilt range)

Rigging: M12 mounting for clamp or spigot.

Operation position any

Dimensions:

Version 1.0 November 6, 2015

Specications are subject to change without notice.

Beam distribution:

Installing the lamp

Unplug from mains before installing the lamp!

Allow the device to cool approximately 40 minutes prior to manipulate with it

1. Unscrew four securing screws (1) and remove the front sieve cover (2).

2. Unscrew two crews (3) which hold lamp base securing plate (4) and pull the lamp (5) up from

the lamp holder.

3. Holding the new lamp by its ceramics base, gently insert the lamp to the lamp socket.

Make sure that the lamp is installed tightly into the lamp socket.Do not install a lamp with a higher wattage

than stated in technical specications of the xture.

Do not touch the glass bulb bare hand during the installation!

4. Screw the lamp base securing plate (4) back.

5. Place the front sieve cover (2) and screw the four screws (1).

Optional accessories

Floor Stand for PATT 2013 (P/N 1098 0259)

Spigot for PATT 2013 (P/N 1098 0260)

Tabla de contenidos

Otros manuales de Equipo de iluminación de Robe

Robe

Robe PATT 2017 Manual de usuario

Robe

Robe Robin 600E Beam Manual de usuario

Robe

Robe Robin MMX Blade Manual de usuario

Robe

Robe Haze 400 FT Manual de usuario

Robe

Robe Color Mix 250 AT Series Manual de usuario

Robe

Robe DMX Control 512 Manual de usuario

Robe

Robe DigitalSpot 5000 DT Manual de usuario

Robe

Robe Robin 300 plasma spot Manual de usuario

Robe

Robe Robin 300E Spot Manual de usuario

Robe

Robe ROBIN 300X Manual de usuario

Robe

Robe Robin 600E Beam Manual de usuario

Robe

Robe Anolis ArcDot-US Manual de usuario

Robe

Robe Color Wash 575E AT Manual de usuario

Robe

Robe Colormix 240 AT Manual de usuario

Robe

Robe DigitalSpot 7100 DT Manual de usuario

Robe

Robe XT Series Manual de usuario

Robe

Robe Euphoria CB series Manual de usuario

Robe

Robe ANOLiS Eminere Remote UV 2 Manual de usuario

Robe

Robe COLORSPOT 170 AT Manual de usuario

Robe

Robe Stage Banner 10 AT Series Manual de usuario

Robe

Robe Esprite Fresnel Manual de usuario

Robe

Robe Color Sport 1200 Profile Manual de usuario

Robe

Robe ColorWash 250 AT Manual de usuario

Robe

Robe Anolis UVinere 2 Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario