Renesas ICS601-21 Manual de usuario

ICS601-21 Preliminary 1Revision 010405

Integrated Circuit Systems, Inc. l525 Race Street, San Jose, CA 95126 ltel (408) 297-1201 lwww.icst.com

ICS601-21 Demo Board Instructions

ICS601-21 Demo Board

The ICS601-21 demo board provides a way to quickly evaluate the performance of the ICS601-21 Low

Phase Noise Clock Multiplier.

Power

Connect either 3.3 volts across the VDD and GND header pins.

Frequency Selection

The output frequency can be changed by setting S0, S1 and S2 on SW1 according to the information in the

Multiplier Select Table on page 2 of the datasheet. Alternatively, shunts can be soldered to the appropriate

0604 device landings underneath SW1. Turning on a switch or stuffing a shunt will pull that particular input

low. Opening the switch or removing the shunt will allow the on-chip pull-up resistors to take the input high.

Input Options

The ICS601-21 Demo board supports either a thru hole or an SMT crystal or a single ended clock input.

Crystal Tuning

In order to achieve 0 PPM frequency synthesis, the ICS601-21 supports external tuning capacitors (C1 and

C2). For exact tuning when using a crystal, capacitors should be connected from pins X1 to ground and X2

to ground. The value of these capacitors is given by the following equation, where CLis the specified

crystal load capacitance in pF:

C1 and C2 (pF) = (CL - 5) x 2.

So, for a crystal with 16 pF load capacitance, use two 22 pF caps.

Output Termination

The 50 ohm resistors R3 and R5 as serve as termination resistors to ground. These values match the

PCB’s trace impedance. Component locations R2 and R4 are provided to allow for user experimentation.

This “on-board” termination allows the clock outputs to be measured directly with a high impedance

oscilloscope probe. To use “off-board” termination, remove R3 and R5, connect 50 ohm coax cables

between the clock connectors and the oscilloscope and terminate with 50 ohms in the oscilloscope.

Trace Impedance

The ICS601-21 board has controlled impedance traces of 50 ohms for all clock inputs and outputs.

Component Crystal Input 50 ohm Clock Input

CN1 open SMA connector

R1 open short

C2 open 50 ohm

Y1/Y2 stuff only one open

ICS601-21 Demo Board Instructions

ICS601-21 Preliminary 2Revision 010405

Integrated Circuit Systems, Inc. l525 Race Street, San Jose, CA 95126 ltel (408) 297-1201 lwww.icst.com

Demo Board Schematics

ICS601-21 Demo Board Instructions

ICS601-21 Preliminary 3Revision 010405

PCB Power Plane

PCB Ground Plane

PCB Top

PCB Bottom

Corporate Headquarters

TOYOSU FORESIA, 3-2-24 Toyosu,

Koto-ku, Tokyo 135-0061, Japan

www.renesas.com

Contact Information

For further information on a product, technology, the most

up-to-date version of a document, or your nearest sales

office, please visit:

www.renesas.com/contact/

Trademarks

Renesas and the Renesas logo are trademarks of Renesas

Electronics Corporation. All trademarks and registered

trademarks are the property of their respective owners.

IMPORTANT NOTICE AND DISCLAIMER

RENESAS ELECTRONICS CORPORATION AND ITS SUBSIDIARIES (“RENESAS”) PROVIDES TECHNICAL

SPECIFICATIONS AND RELIABILITY DATA (INCLUDING DATASHEETS), DESIGN RESOURCES (INCLUDING

REFERENCE DESIGNS), APPLICATION OR OTHER DESIGN ADVICE, WEB TOOLS, SAFETY INFORMATION, AND

OTHER RESOURCES “AS IS” AND WITH ALL FAULTS, AND DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED,

INCLUDING, WITHOUT LIMITATION, ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A

PARTICULAR PURPOSE, OR NON-INFRINGEMENT OF THIRD PARTY INTELLECTUAL PROPERTY RIGHTS.

These resources are intended for developers skilled in the art designing with Renesas products. You are solely responsible

for (1) selecting the appropriate products for your application, (2) designing, validating, and testing your application, and (3)

ensuring your application meets applicable standards, and any other safety, security, or other requirements. These

resources are subject to change without notice. Renesas grants you permission to use these resources only for

development of an application that uses Renesas products. Other reproduction or use of these resources is strictly

prohibited. No license is granted to any other Renesas intellectual property or to any third party intellectual property.

Renesas disclaims responsibility for, and you will fully indemnify Renesas and its representatives against, any claims,

damages, costs, losses, or liabilities arising out of your use of these resources. Renesas' products are provided only subject

to Renesas' Terms and Conditions of Sale or other applicable terms agreed to in writing. No use of any Renesas resources

expands or otherwise alters any applicable warranties or warranty disclaimers for these products.

(Rev.1.0 Mar 2020)

Tabla de contenidos

Otros manuales de Hardware de computadora de Renesas

Renesas

Renesas R8C/15 Instrucciones de operación

Renesas

Renesas RX72M Series Instrucciones de instalación y funcionamiento

Renesas

Renesas Renasas Single-Chip Microcomputer SH7086 Manual de usuario

Renesas

Renesas M34286T2-CPE Manual de usuario

Renesas

Renesas H8S/2111B Manual de usuario

Renesas

Renesas M30260T-48FPD Manual de usuario

Renesas

Renesas SuperH SH-4A Instrucciones de montaje

Renesas

Renesas DP-64S Manual de usuario

Renesas

Renesas FP-100A Manual de usuario

Renesas

Renesas Pmod RYZ012A1 Manual de usuario

Renesas

Renesas Converter Board R0E5212BACFG00 Manual de usuario

Renesas

Renesas Single-Chip Microcomputer M306NKT3 Manual de usuario

Renesas

Renesas H8/3802 Manual de usuario

Renesas

Renesas FemtoClock 2 Manual de usuario

Renesas

Renesas R8C/Tiny Series Instrucciones de montaje

Renesas

Renesas Emulation Pod M306H2T-RPD-E Manual de usuario

Renesas

Renesas Hitachi H8S/2194 Series Manual de usuario

Renesas

Renesas H8S series Manual de usuario

Renesas

Renesas R20UT3696EJ0120 Manual de usuario

Renesas

Renesas R0E5562GAPFK10 Manual de usuario

Renesas

Renesas M3T-FLX100-R Manual de usuario

Renesas

Renesas M3A-HS37 Manual de usuario

Renesas

Renesas RL78/I1D Instrucciones de instalación y funcionamiento

Renesas

Renesas M3T-F160-100NSD Manual de usuario

Manuales populares de Hardware de computadora de otras marcas

EMC2

EMC2 VNX Series Manual del propietario

Panasonic

Panasonic DV0PM20105 Manual de usuario

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manual de usuario

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manual de usuario

Raidon

Raidon iT2300 Manual de usuario

National Instruments

National Instruments PXI-8186 Manual de usuario

Hauppauge

Hauppauge WinTV-HVR-2250 Manual de usuario

Kontron

Kontron CP6002 Manual de usuario

Manhattan

Manhattan 702843 Manual de usuario

Aphex

Aphex 230 Manual de usuario

AMD

AMD Phenom II Manual operacional

Intel

Intel NUC 12 Pro Manual de usuario

dbx

dbx Zone Pro 1260 Manual de usuario

Galaxy

Galaxy GHDX2-2430S-24F4D Manual de usuario

Intel

Intel AXXRMFBU4 Manual de usuario

Kontron

Kontron DIMM-PC/MD Manual de usuario

ST X-NUCLEO-SAFEA1B Instrucciones de funcionamiento

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manual de usuario