Rain Bird ESP-LXD Instrucciones de funcionamiento

ESP-LXD Controller

Programming Guide

Symbols

 NOTE:Symbolisintendedtoalertthe user to importantoperating,

functionality or maintenance or installation instructions.

 WARNING: Symbol is intended to alert the user to the presence

of electricity within the controller which may constitute a risk of

electronic shock or other hazard.

 CAUTION: Symbol is intended to alert the user to important

instructions or conditions that could seriously aect irrigation

eectivity or controller operation.

 DIAL: Symbol indicates that the user is required to turn the dial

on the controller to the appropriate setting in order to follow

subsequent instructions as described in that section.

 REPEAT: Symbol indicates that a repetition of previous steps

or actions may be required in order to continue or complete the

controller programming process.

Storing the Programming Guide

Return the Programming Guide to a permanent, safe location when

you’re nished working with it. We recommend hanging it on the hook

inside the controller cabinet door as shown below.

For technical assistance contact Rain Bird at 1-800-247-3782

Visit us on the web at www.rainbird.com

ESP-LXD Controller

How To Use The Programming Guide

Program Information Fold-out Sheet

A

Open booklet to back page.

B

Open program information fold-out sheet.

D

Flip booklet over to enter or review common system and program

data (on the fold-out sheet above) corresponding to data for the

individual stations (on programming pages below).

C

Close booklet so that

fold-out sheet is oriented

above the programming

pages.

2ESP-LXD Controller

Apply Decoder Address Labels

Before you begin programming, apply your eld decoder barcode

labels to the appropriate elds on the Programming Guide.

A

Carefully peel the station, master valve, ow or weather sensor

sensor decoder barcode label o of the decoder.

B

Apply the decoder address labels in the appropriate elds on the

Programming Guide.

 Repeat this process to apply additional barcode labels to the

programming chart.

 NOTE: An optional Programming Backup Cartridge (PBC) is

available for the ESP-LXD controller, which allows you to create

and Restore multiple Backups of irrigation programs. With a PBC

cartridge installed, you can also set up Field Decoder addresses

by using a barcode scanning pen to read the removable barcode

labels attached to Rain Bird’s eld decoders. See Section E of the

ESP-LXD Controller Installation, Programming and Operation

Guide for more details. Or see page 26 of this Programming Guide

for more details on setting up a barcode scanning pen.

Fill Out Programming Guide

Before you begin programming, ll out the Programming Guide.

Sample Programming information is shown on the following

pages.

C

Enter information about your system hardware and settings in the

appropriate elds on the Programming Guide.

ESP-LXD Controller

Sample Programming Guide

Information (1)

A

Enter custom Program Names for your

programs in these elds.

B

Enter Days To Water for each program:

 For Custom cycle, check the

specic days of the week to

include for irrigation.

 For Cyclical schedule, enter the

cycle period. For example, a “3”

DayCycle indicates irrigation will

occur every third day.

 For Odd/Even day watering, check

Odd, Even, or Odd 31.

C

Enter Watering Start Time(s). You may

enter up to eight start times for each

program, but only one start time is

needed for a program to run. Circle

either “am” or “pm”.

D

Enter the Seasonal Adjust by Month

percentages (if you are using them).

E

Check “ON” in the Monthly Seasonal

Adjust row for each program that will

use the monthly percentages.

F

Enter the Seasonal Adjust by Program

percentage (if you are using it). The

Seasonal Adjust for sample Program

A is set to 80%, and the Monthly

Seasonal Adjust box is left unchecked.

G

Enter the Station Delay for each

program (if desired). In the sample,

Program A has a one-minute delay

between valves. When valve 1 ends,

the controller waits one minute before

starting valve 2. There will also be a

one-minute delay between valve 2

and valve 3, etc. A station delay setting

applies to all programs.

H

Enter the Maximum Number of

SimulStations allowed per program.

In the sample, Program A is allowed to

run a maximum number of 4 programs

simultaneously.

I

Enter the Water Window Start and End

Time(s) for each program (if you’re

using them). Circle either “am” or “pm”.

Turf Shrub

10:00 11:45 1:00

2:15

4:30

5:30

X X X

100

1 min

10:00

6:00

XXX

1 2

4ESP-LXD Controller

Sample Programming Guide

Information (2)

A

Apply Master Valve (MV) Decoder

Address Labels in these elds.

B

Enter Description of the MV.

C

Check if the MV is normally open (NO)

or normally closed (NC).

D

Check if the MV is allowed to open

during the MV Manual Water Window.

E

Apply Flow Sensor Decoder Address

Labels in these elds.

F

Enter Description of the ow sensor.

G

Enter the Type of ow sensor.

H

Species which Master Valve (MV) the

sensor is connected to.

I

Apply Weather Sensor Decoder

Address Labels in these elds.

J

Enter Description of the weather

sensor

K

Enter the Type of weather sensor.

L

Check which Action the sensor

performs (prevent or pause).

M

Enter the Master Valve (MV) Manual

Water Window Open and Close

Time(s). Circle either “am” or “pm”.

N

Enter the Maximum Flow Rate.

O

Enter Days of the Week for the water

window to be active.

P

Check Pipe Size Units of measurement

that you’re using; inches or metric.

Q

Enter the Flow Units that you’re using;

GPM or other.

R

List of Rain Bird decoder models.

S

Enter the Maximum Flow Rate for each

Flow Zone in these elds.

T

List of Rain Bird valve types.

U

Enter the System Valve Types that your

system uses.

V

List of Rain Bird ow sensors.

7:00

4:00

120 X X X

120

Pump

Meter

Pump

Meter

WR2-RC

WR2-RFC

FS400P

FS200P

Rain

Freeze

n o p q r

ESP-LXD Controller

Sample Programming Guide

Information (3, 4)

A

Apply Station Decoder Address labels

in these elds.

B

Enter description of the Valve Type.

C

Enter Description of the decoder

model.

D

Check which Master Valve (MV) the

station uses.

E

Enter the Station Flow Rate

F

Check if the station obeys a Local

Sensor.

G

Check if the station obeys a Weather

Sensor.

H

Check the FloZone source.

I

Enter description of the Station.

J

Check the station’s Priority here.

K

Enter the Station Cycle Time (if you’re

using Cycle+SoakTM).

L

Enter the Station Soak Time (if you’re

using Cycle+SoakTM).

M

Enter Station Run Time(s) for each

program (A, B, C and D).

V2 X

FD101

FD102

X X X

Entry-Sprays

Entry-Color Beds

5 min 30 min 10 min

5 min

a b c d e f g h

i j k l m

Station

Number

Station

Station Decoder

Address Label

Valve

Type

Decoder

Model

Station

Uses MV

Station

Flow Rate

Obey

Local

Sensor

Obey

Weather

Sensor

FloZone

Source

12345 123 12345

Station

#Description Priority

N = Non Irrigation

Station

Cycle Time

Station

Soak Time

Program A

Station Run Time

Program B

Station Run Time

Program C

Station Run Time

Program D

Station Run Time

Station

Number

Station

Station Decoder

Address Label

Valve

Type

Decoder

Model

Station

Uses MV

Station

Flow Rate

Obey

Local

Sensor

Obey

Weather

Sensor

FloZone

Source

Station

#Description Priority

N = Non Irrigation

Station

Cycle Time

Station

Soak Time

Program A

Station Run Time

Program B

Station Run Time

Program C

Station Run Time

Program D

Station Run Time

Station

Number

Station

Station Decoder

Address Label

Valve

Type

Decoder

Model

Station

Uses MV

Station

Flow Rate

Obey

Local

Sensor

Obey

Weather

Sensor

FloZone

Source

Station

#Description Priority

N = Non Irrigation

Station

Cycle Time

Station

Soak Time

Program A

Station Run Time

Program B

Station Run Time

Program C

Station Run Time

Program D

Station Run Time

Station

Number

Station

Station Decoder

Address Label

Valve

Type

Decoder

Model

Station

Uses MV

Station

Flow Rate

Obey

Local

Sensor

Obey

Weather

Sensor

FloZone

Source

Station

#Description Priority

N = Non Irrigation

Station

Cycle Time

Station

Soak Time

Program A

Station Run Time

Program B

Station Run Time

Program C

Station Run Time

Program D

Station Run Time

H M L N

Station

Number

Station

Station Decoder

Address Label

Valve

Type

Decoder

Model

Station

Uses MV

Station

Flow Rate

Obey

Local

Sensor

Obey

Weather

Sensor

FloZone

Source

12345 123 12345

Station

#Description Priority

N = Non Irrigation

Station

Cycle Time

Station

Soak Time

Program A

Station Run Time

Program B

Station Run Time

Program C

Station Run Time

Program D

Station Run Time

Station

Number

Station

Station Decoder

Address Label

Valve

Type

Decoder

Model

Station

Uses MV

Station

Flow Rate

Obey

Local

Sensor

Obey

Weather

Sensor

FloZone

Source

Station

#Description Priority

N = Non Irrigation

Station

Cycle Time

Station

Soak Time

Program A

Station Run Time

Program B

Station Run Time

Program C

Station Run Time

Program D

Station Run Time

Otros manuales para ESP-LXD

Tabla de contenidos

Otros manuales de Controladores de Rain Bird

Rain Bird

Rain Bird ST8I-INTL Manual de instrucciones

Rain Bird

Rain Bird ESP Guía de instalación

Rain Bird

Rain Bird PRS-DIAL Instrucciones de funcionamiento

Rain Bird

Rain Bird LXME2 Manual de usuario

Rain Bird

Rain Bird ESP-ME3 Manual de usuario

Rain Bird

Rain Bird ESP-LX Manual de usuario

Rain Bird

Rain Bird ESP-TM2 Manual de usuario

Rain Bird

Rain Bird ESP-ME3 Manual de usuario

Rain Bird

Rain Bird ESP-4Si Manual de usuario

Rain Bird

Rain Bird ESP-RZ Manual de usuario

Rain Bird

Rain Bird ESP-Me Series Manual de usuario

Rain Bird

Rain Bird ESP-RZ Manual de servicio

Rain Bird

Rain Bird ESP-LXIVM Manual de usuario

Rain Bird

Rain Bird IQNCCEN Manual de usuario

Rain Bird

Rain Bird CRC-8A Manual de usuario

Rain Bird

Rain Bird Image Series Manual de usuario

Rain Bird

Rain Bird ESP-LXIVM Series Guía de instalación

Rain Bird

Rain Bird RC-4C Manual de usuario

Rain Bird

Rain Bird ESP-RZXe Manual de usuario

Rain Bird

Rain Bird PAR+ES Manual de usuario

Rain Bird

Rain Bird E-6C Manual de usuario

Rain Bird

Rain Bird ESP-LX Plus Series Guía

Rain Bird

Rain Bird ESP-4 Instrucciones de montaje

Rain Bird

Rain Bird WPX Manual de usuario

Manuales populares de Controladores de otras marcas

Digiplex

Digiplex DGP-848 Instrucciones de funcionamiento

YASKAWA

YASKAWA SGM series Manual de usuario

Sinope

Sinope Calypso RM3500ZB Manual de usuario

Isimet

Isimet DLA Series Style 2 Manual de instalación

LSIS

LSIS sv-ip5a Manual de usuario

Rockwell Automation

Rockwell Automation 1769-L31 Manual de usuario

Airflow

Airflow Uno hab Manual de usuario

ABB

ABB ACS580-01 drives Manual de usuario

Panasonic

Panasonic GM1 Series Manual de usuario

Emerson

Emerson SW93 Manual de usuario

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manual de usuario

Panasonic

Panasonic FP? Positioning Unit RTEX Manual de usuario

Samson

Samson Type 5824 Manual de servicio

Alpha IP

Alpha IP MIOB 21001 Manual de usuario

Siemens

Siemens OpenAir GMA 1 Series Manual de usuario

Surecom

Surecom SR-629 Manual de usuario

Fishman

Fishman TriplePlay Manual de usuario

Regulus

Regulus SRS1 T Manual de usuario