Racelogic Performance Box Touch V2 Manual de instrucciones

02 Installing your Performance Box Touch V2 in the Vehicle

Installation

The battery is connected to Performance Box Touch with a Richter mounting system on the rear of the unit. Insert

the prongs from the back of the battery into the rear of the Performance Box Touch unit and push upwards to

secure.

Richter mounting system on the back of

Performance Box Touch

Richter mounting system on the rear of battery

(RLACS290)

Connectors

You can find more detailed connector information on the PIN OUTS page.

https://en.racelogic.support//Product_Info/Performance_Meters/Performance_Box_Touch/Performance_Box_Touch_V2/

User_Guide_%E2%80%93_Performance_Box_Touch_V2/02_Installing_your_Performance_Box_Touch_V2_in_the_Vehicle

Left Side

Right Side

Mounting

Performance Box Touch comes supplied with a Suction Cup Windscreen Mount (ACS318MOUNT) so you can

mount it on the vehicle's windscreen. It attaches to the Richter mounting system on the back of the unit, or at the

back of the Battery if this is connected to the unit.

https://en.racelogic.support//Product_Info/Performance_Meters/Performance_Box_Touch/Performance_Box_Touch_V2/

User_Guide_%E2%80%93_Performance_Box_Touch_V2/02_Installing_your_Performance_Box_Touch_V2_in_the_Vehicle

Richter mounting system on the rear of Performance

Box Touch

Richter Mounting system on Suction Cup

Windscreen Mount (RLACS331)

Insert the prongs from the mount into the back of the unit or the battery and push upwards to secure. Attach the

suction cup to a suitable location on your windscreen and adjust as necessary.

https://en.racelogic.support//Product_Info/Performance_Meters/Performance_Box_Touch/Performance_Box_Touch_V2/

User_Guide_%E2%80%93_Performance_Box_Touch_V2/02_Installing_your_Performance_Box_Touch_V2_in_the_Vehicle

Satellite Reception

Performance Box Touch has an internal patch antenna.

This means that, in many circumstances, the unit does

not require an external antenna if it has a clear view of

the sky without any interference (e.g. roof bars,

athermic windscreen, windscreen wipers). However, if

you are struggling to maintain a stable satellite lock

(indicated by a flashing red satellite icon), you can use

an external antenna (RLACS284).

IMPORTANT

The first time you use the unit, it may take 10 to 15 minutes to acquire satellites fully. After this, it will usually

only take 1 to 2 minutes to acquire satellites.

External Antenna (If Required)

The placement of the GNSS antenna is crucial to the quality of the data recorded by Performance Box Touch. Any

metal close to a GNSS antenna can unpredictably disturb the signal due to interference from reflections of weak

GNSS signals.

For best results, use the antenna in the centre of a metal roof at least 5 cm away from any roof bars or radio

antennas. Do not mount the antenna close to the edge of the roof as reflections from the ground may interfere with

the signals. Avoid the edges as reflections from the A-pillars will cause problems.

Mount the antenna as high up as possible and keep it above any roll bars. Pieces of metal close to and above an

antenna will badly disrupt the GNSS signal.

If the vehicle you are using does not have a metal roof, you need to place the GNSS antenna on a flat piece of

metal at least 10 cm in diameter. If this is not possible, you can use copper or aluminium foil to create a shaped

ground plane underneath the antenna. For example, on a fibreglass roof, mount the antenna on top of the

roof, and place some adhesive-backed metal foil underneath, on the inside of the roof.

https://en.racelogic.support//Product_Info/Performance_Meters/Performance_Box_Touch/Performance_Box_Touch_V2/

User_Guide_%E2%80%93_Performance_Box_Touch_V2/02_Installing_your_Performance_Box_Touch_V2_in_the_Vehicle

Acquiring Satellite Lock

Tall buildings or trees can block GNSS signals, causing a reduction in the number and quality of satellites being

tracked. The reduced number of satellites can lead to inaccurate position measurements and a noisy velocity signal.

GNSS works best in open areas. Avoid tree-lined roads.

GPS Coldstart

If Performance Box Touch is struggling to acquire a satellite lock, you may need to perform a GPS coldstart. This

may be necessary when the unit hasn’t been used for several days or has moved location significantly since it was

last used.

To perform a coldstart, press the COLDSTART button in the Diagnostics Settings menu.

Media, iframe, embed and

object tags are not

supported inside of a PDF.

https://en.racelogic.support//Product_Info/Performance_Meters/Performance_Box_Touch/Performance_Box_Touch_V2/

User_Guide_%E2%80%93_Performance_Box_Touch_V2/02_Installing_your_Performance_Box_Touch_V2_in_the_Vehicle

When you press the button, the unit will make an audible sound and you will see a ‘PLEASE WAIT’ message

counting down from 3. Until the satellite lock has been acquired, the number of satellites will be displayed as '00' and

the GPS status will show ‘SEARCHING FOR SATELLITES’. It will take approximately 25 to 30 seconds for the unit

to reacquire the satellite lock.

https://en.racelogic.support//Product_Info/Performance_Meters/Performance_Box_Touch/Performance_Box_Touch_V2/

User_Guide_%E2%80%93_Performance_Box_Touch_V2/02_Installing_your_Performance_Box_Touch_V2_in_the_Vehicle

Otros manuales para Performance Box Touch V2

Tabla de contenidos

Otros manuales de Registrador de datos de Racelogic

Racelogic

Racelogic VBOX Touch Manual de usuario

Racelogic

Racelogic VBOX IISX Manual de usuario

Racelogic

Racelogic VBOX Touch Manual de usuario

Racelogic

Racelogic VBOX Touch V2 Manual de usuario

Racelogic

Racelogic VBOX Micro RLVBMIC01 Manual de usuario

Racelogic

Racelogic PerformanceBox Manual de usuario

Racelogic

Racelogic VBOX Micro Manual de usuario

Racelogic

Racelogic VBOX 3iV2 Manual de usuario

Racelogic

Racelogic VBOX Mini Manual de usuario

Racelogic

Racelogic VBTOUCHR-V1 Manual de usuario

Racelogic

Racelogic PROLITE Manual de usuario

Racelogic

Racelogic VBOX LapTimer Manual de usuario

Racelogic

Racelogic VBOX LapTimer Manual de usuario

Racelogic

Racelogic VB20SL Manual de usuario

Racelogic

Racelogic VBOX HD Lite Manual de usuario

Racelogic

Racelogic VBOX Touch Manual de usuario

Racelogic

Racelogic VBOX Touch Manual de usuario

Racelogic

Racelogic Performance Box Touch V1 Manual de usuario

Racelogic

Racelogic VBOX Touch Manual de usuario

Racelogic

Racelogic Performance Box Touch V1 Manual de usuario

Racelogic

Racelogic VBOX Touch Motorsport V2 Manual de usuario

Racelogic

Racelogic VBOX II Manual de usuario

Racelogic

Racelogic Performance Box Touch V2 Manual de usuario

Racelogic

Racelogic VBOX II Manual de usuario

Manuales populares de Registrador de datos de otras marcas

TESTO

TESTO 176 Manual de usuario

HT Italia

HT Italia XL421 Manual de usuario

HBM

HBM SOMAT XR CX22B-R Manual de usuario

Agtrix

Agtrix 380i Manual de usuario

Hobo

Hobo H8 Pro Manual de usuario

Beijing ART Tech

Beijing ART Tech PCI2320 Manual de usuario

Athena

Athena GET SL1 Manual de usuario

Motec Systems

Motec Systems C185 Manual de usuario

Beijing ART Tech

Beijing ART Tech USB2832 Manual de usuario

Rotronic

Rotronic HygroLog HL20 Manual de usuario

MRC

MRC DW-6092 Manual de usuario

Edu-Logger

Edu-Logger 900-240 Manual de usuario

Elma

Elma DT173 Manual de usuario

MadgeTech

MadgeTech PRTemp140 Hoja de especificaciones

Comet

Comet U0121M Manual de usuario

pico Technology

pico Technology PT-104 Manual de usuario

Soil Instruments

Soil Instruments GTecLink Manual de usuario

APLICOM

APLICOM A11 Manual de usuario