Prorack K805 Manual de usuario
K805
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 1 x 1 x 1 x 1
x 1 x 1 x 1 x 1
x 2 x 2
Revision No: 3C 1
Fitting Kit K805
MAX kgs (lbs)
W/P WHD
Lexus
ES 250, 4dr Sedan 12-15 ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
ES 250, 4dr Sedan 16-+ ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
ES 300H, 4dr Sedan 12-15 NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
ES 300H, 4dr Sedan 12-15 AU 75 kgs (165 lbs) 75 kgs (165 lbs)
ES 300H, 4dr Sedan 12-15 ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
ES 300H, 4dr Sedan 13-15 US 75 kgs (165 lbs) 75 kgs (165 lbs)
ES 300H, 4dr Sedan 16-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs)
ES 300H, 4dr Sedan 16-+ NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
ES 300H, 4dr Sedan 16-+ ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
ES 350, 4dr Sedan 12-15 NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
ES 350, 4dr Sedan 12-15 AU 75 kgs (165 lbs) 75 kgs (165 lbs)
ES 350, 4dr Sedan 13-15 US 75 kgs (165 lbs) 75 kgs (165 lbs)
ES 350, 4dr Sedan 16-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs)
ES 350, 4dr Sedan 16-+ NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
2
Fitting Kit K805
X
A B C 1 2 3
ES 250, 4dr Sedan 12-15 (ZA) -340mm 360mm - 880mm 865mm -
-13 -3/8ths" 14 3/16ths" - 34 5/8ths" 34 1/16ths" -
ES 250, 4dr Sedan 16-+ (ZA) -340mm 360mm - 880mm 865mm -
-13 -3/8ths" 14 3/16ths" - 34 5/8ths" 34 1/16ths" -
ES 300H, 4dr Sedan 12-15 (NZ) -340mm 360mm - 880mm 865mm -
-13 -3/8ths" 14 3/16ths" - 34 5/8ths" 34 1/16ths" -
ES 300H, 4dr Sedan 12-15 (AU) -340mm 360mm - 880mm 865mm -
-13 -3/8ths" 14 3/16ths" - 34 5/8ths" 34 1/16ths" -
ES 300H, 4dr Sedan 12-15 (ZA) -340mm 360mm - 880mm 865mm -
-13 -3/8ths" 14 3/16ths" - 34 5/8ths" 34 1/16ths" -
ES 300H, 4dr Sedan 13-15 (US) -340mm 360mm - 880mm 865mm -
-13 -3/8ths" 14 3/16ths" - 34 5/8ths" 34 1/16ths" -
ES 300H, 4dr Sedan 16-+ (AU) -340mm 360mm - 880mm 865mm -
-13 -3/8ths" 14 3/16ths" - 34 5/8ths" 34 1/16ths" -
ES 300H, 4dr Sedan 16-+ (NZ) -340mm 360mm - 880mm 865mm -
-13 -3/8ths" 14 3/16ths" - 34 5/8ths" 34 1/16ths" -
ES 300H, 4dr Sedan 16-+ (ZA) -340mm 360mm - 880mm 865mm -
-13 -3/8ths" 14 3/16ths" - 34 5/8ths" 34 1/16ths" -
ES 350, 4dr Sedan 12-15 (NZ) -340mm 360mm - 880mm 865mm -
-13 -3/8ths" 14 3/16ths" - 34 5/8ths" 34 1/16ths" -
ES 350, 4dr Sedan 12-15 (AU) -340mm 360mm - 880mm 865mm -
-13 -3/8ths" 14 3/16ths" - 34 5/8ths" 34 1/16ths" -
ES 350, 4dr Sedan 13-15 (US) -340mm 360mm - 880mm 865mm -
-13 -3/8ths" 14 3/16ths" - 34 5/8ths" 34 1/16ths" -
ES 350, 4dr Sedan 16-+ (AU) -340mm 360mm - 880mm 865mm -
-13 -3/8ths" 14 3/16ths" - 34 5/8ths" 34 1/16ths" -
ES 350, 4dr Sedan 16-+ (NZ) -340mm 360mm - 880mm 865mm -
-13 -3/8ths" 14 3/16ths" - 34 5/8ths" 34 1/16ths" -
3
Fitting Kit EN
K805
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
NOTE: Clamp images in these instructions may
not be representative of the clamps in this kit
4
Fitting Kit EN
K805
●Use keys to remove covers.
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
5
Fitting Kit EN
K805
●Remove locking screw.
●Apply protective strip as shown.
Trim if required.
●It is important to put the clamps in the
correct position on the vehicle.
●Letters refer to the part numbers stamped
on clamps.
●Clamp Part Number:
A = A344
B = A345
C = A346
D = A347
6
Fitting Kit EN
K805
●Attach clamp to each leg. NOTE; clamps
may have labels showing their positions on
the vehicle (For example; "Front Right").
●Refit locking screw so that it goes through
the hole in the clamp. Do not begin to
tighten the locking screw.
●Refer to the underside of the pad for the
part number.
7
Fitting Kit EN
K805
●It is important to put the pads in the correct
position on the vehicle.
●Letters refer to the pad part numbers and
position.
●Pad Part Number:
A = 293A
B = 294A
C = 295A
D = 296A
●Place rubber pads (supplied with fitting kit)
on the vehicle roof. Pad may vary in shape
to that shown.
●Make sure the pad fits into the holes
underneath the foot.
8
Fitting Kit EN
K805
Fitment
●Clamps directly to edge of roof under the
doors
●Please check the front of this manual for
information relating specifically to your
vehicle.
●Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
●Adjust the legs on the crossbar so that they
are positioned equally from the ends of the
crossbar, and the clamps engage firmly on
the body work of the vehicle.
●Tighten adjusting screw to 2 Nm (1.5 ft lb)
hand tight.
9
Fitting Kit EN
K805
●Tighten locking screw on both legs evenly,
2.5 Nm (1.8 ft lb).
●Check crossbar is securely attached to the
vehicle.
●Use keys to fit and lock covers
10
Tabla de contenidos
Otros manuales de Accesorios para automóviles de Prorack
Prorack
Prorack K351 Manual de operación e instalación
Prorack
Prorack WHISPBAR S41 Manual de operación e instalación
Prorack
Prorack K673 Manual de usuario
Prorack
Prorack K320 Manual de usuario
Prorack
Prorack K070 Manual de usuario
Prorack
Prorack WHISPBAR S54 Manual de operación e instalación
Prorack
Prorack K446 Manual de usuario
Prorack
Prorack K1045 Manual de usuario
Prorack
Prorack K820 Manual de usuario
Prorack
Prorack K346 Manual de usuario
Prorack
Prorack K376 Manual de usuario
Prorack
Prorack K084 Manual de usuario
Prorack
Prorack K756 Manual de usuario
Prorack
Prorack K442 Manual de usuario
Prorack
Prorack K1008 Manual de usuario
Prorack
Prorack K618 Manual de usuario
Prorack
Prorack Q19 Manual de usuario
Prorack
Prorack K483 Manual de usuario
Prorack
Prorack K358 Manual de usuario
Prorack
Prorack K571 Guía de instalación
