Prorack K412 Manual de usuario
K412
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 4 x 2 x 2 x 4
x 4 x 1
Revision No: 7D 1
Fitting Kit K412
MAX kgs (lbs)
W/P WHD
Citroen
C4 Grand Picasso, 5dr MPV 07-13 ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
C4 Picasso, 5dr MPV 07-+ ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
C4 Picasso, 5dr MPV 07-12 EU 75 kgs (165 lbs) 75 kgs (165 lbs)
C4, 3dr Hatch 04-10 EU 75 kgs (165 lbs) 75 kgs (165 lbs)
C4, 3dr Hatch 06-09 CN 75 kgs (165 lbs) 75 kgs (165 lbs)
C4, 5dr Hatch 04-10 AU 75 kgs (165 lbs) 75 kgs (165 lbs)
C4, 5dr Hatch 04-10 EU 75 kgs (165 lbs) 75 kgs (165 lbs)
C4, 5dr Hatch 04-10 NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
C4, 5dr Hatch 05-10 ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
C4, 5dr Hatch 06-09 CN 75 kgs (165 lbs) 75 kgs (165 lbs)
Ford
Focus, 3dr Hatch 08-11 NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
Focus, 3dr Hatch 08-11 AU 75 kgs (165 lbs) 75 kgs (165 lbs)
Focus, 3dr Hatch 08-11 EU 75 kgs (165 lbs) 75 kgs (165 lbs)
Focus, 3dr Hatch 08-11 ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
2
Fitting Kit K412
X
A B C 1 2 3
C4 Grand Picasso, 5dr MPV 07-13 (ZA) 240mm 470mm - 838mm 881mm -
9 7/16ths" 18 1/2ths" - 33" 34 11/16ths" -
C4 Picasso, 5dr MPV 07-+ (ZA) -240mm 470mm - 938mm 881mm -
-9 -7/16ths" 18 1/2ths" - 36 15/16ths" 34 11/16ths" -
C4 Picasso, 5dr MPV 07-12 (EU) -240mm 470mm - 938mm 881mm -
-9 -7/16ths" 18 1/2ths" - 36 15/16ths" 34 11/16ths" -
C4, 3dr Hatch 04-10 (EU) -300mm 400mm - 824mm 756mm -
-11 -13/16ths" 15 3/4ths" - 32 7/16ths" 29 3/4ths" -
C4, 3dr Hatch 06-09 (CN) -300mm 400mm - 824mm 756mm -
-11 -13/16ths" 15 3/4ths" - 32 7/16ths" 29 3/4ths" -
C4, 5dr Hatch 04-10 (AU) -300mm 400mm - 824mm 756mm -
-11 -13/16ths" 15 3/4ths" - 32 7/16ths" 29 3/4ths" -
C4, 5dr Hatch 04-10 (EU) -300mm 400mm - 824mm 756mm -
-11 -13/16ths" 15 3/4ths" - 32 7/16ths" 29 3/4ths" -
C4, 5dr Hatch 04-10 (NZ) -300mm 400mm - 824mm 756mm -
-11 -13/16ths" 15 3/4ths" - 32 7/16ths" 29 3/4ths" -
C4, 5dr Hatch 05-10 (ZA) -300mm 400mm - 824mm 756mm -
-11 -13/16ths" 15 3/4ths" - 32 7/16ths" 29 3/4ths" -
C4, 5dr Hatch 06-09 (CN) -300mm 400mm - 824mm 756mm -
-11 -13/16ths" 15 3/4ths" - 32 7/16ths" 29 3/4ths" -
Focus, 3dr Hatch 08-11 (NZ) -410mm 280mm - 875mm 850mm -
-16 -1/8ths" 11" - 34 7/16ths" 33 7/16ths" -
Focus, 3dr Hatch 08-11 (AU) -410mm 280mm - 875mm 850mm -
-16 -1/8ths" 11" - 34 7/16ths" 33 7/16ths" -
Focus, 3dr Hatch 08-11 (EU) -410mm 280mm - 875mm 850mm -
-16 -1/8ths" 11" - 34 7/16ths" 33 7/16ths" -
Focus, 3dr Hatch 08-11 (ZA) -410mm 280mm - 875mm 850mm -
-16 -1/8ths" 11" - 34 7/16ths" 33 7/16ths" -
3
Fitting Kit EN
K412
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
●Use keys to remove covers.
4
Fitting Kit EN
K412
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
●Adjust crossbar in or out to suit vehicle.
Refer to the crossbar instructions for
crossbar adjustment.
●Attaches to factory-fitted mounting points
●Please check the front of this manual for
information relating specifically to your
vehicle.
5
Fitting Kit EN
K412
●Tighten adjusting screw to 5 Nm (3.7 ft lb)
hand tight.
●Remove plastic clamp block by gripping bar
leg with fingers and push firmly with
thumbs until clamp block drops out behind
leg.
●Select plastic internal block (from fitting kit)
and insert into foot.
●Repeat for all legs.
6
Fitting Kit EN
K412
Fitment
●Open or remove fixed-point covers.
●Select grubscrews and screw into the
vehicle's fixed points.
●Do not over tighten.
●Repeat for all four positions.
●Refer to the underside of the pad for the
part number.
7
Fitting Kit EN
K412
●Letters refer to the pad part numbers and
position.
●Pad Part Number:
A = 11-04-224
B = 11-04-225
●Ensure the fixed-point covers sit vertically
in the recess in the pads.
●NOTE: Citroen C4 Picasso only
●This product has two different bar
lengths.The longer bar should be used on
the front of the vehicle and the shorter bar
used on the rear.
8
Fitting Kit EN
K412
●Place crossbars on pads ensuring the pads
fit into the holes underneath the foot and
the grubscrew passes through the hole in
the foot.
●Repeat for all four positions.
●Tighten the plastic knob. The side with the
nut showing should be facing up.
●Ensure the plastic knob is in the position
shown when fully tightened.
●Repeat for all legs.
9
Fitting Kit EN
K412
●Check crossbar is securely attached to the
vehicle.
●Use keys to fit and lock covers
CAUTION: Recheck all fasteners immediately after
a load is applied to the crossbars.
Regularly check screws are tight.
10
Tabla de contenidos
Otros manuales de Accesorios para automóviles de Prorack
Prorack
Prorack K178 Manual de usuario
Prorack
Prorack K536 Manual de usuario
Prorack
Prorack K589 Manual de usuario
Prorack
Prorack K781 Manual de usuario
Prorack
Prorack K389 Manual de usuario
Prorack
Prorack K379 Manual de usuario
Prorack
Prorack K569 Manual de usuario
Prorack
Prorack K983 Manual de usuario
Prorack
Prorack K398 Manual de usuario
Prorack
Prorack K127 Manual de usuario
Prorack
Prorack K762 Manual de usuario
Prorack
Prorack K375 Manual de usuario
Prorack
Prorack K062 Manual de usuario
Prorack
Prorack K823 Manual de usuario
Prorack
Prorack K857 Manual de operación e instalación
Prorack
Prorack K343 Manual de usuario
Prorack
Prorack K337 Manual de usuario
Prorack
Prorack K007 Manual de usuario
Prorack
Prorack K425 Manual de usuario
Prorack
Prorack PR3302 Manual de usuario
