Pro-Ject Audio Systems Record Box E Manual de usuario

INSTRUCTIONS FOR USE

Pro-Ject Record Box E

Dear music lover,

thank you for purchasing a Pro-Ject Audio Systems Record Box E.

In order to achieve maximum performance and reliability you should study these instructions for use carefully.

Warning of a hazard for the user, the unit or possible misuse.

Important notice.

Safety instructions

AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the

voltage in your area meets the voltage requirements printed on the power supply.

The power supply is used to disconnect the unit from the mains. Make sure that the power supply is easily

accessible at all times. Never handle the device, the power supply while your hands are wet or damp.

Avoid letting liquids enter the device or the power supply. Never place any item containing liquid,

such as a flower vase on or near the device. Never spill any liquid on the device or the power supply.

Never place any naked flame sources, such as lighted candles on or near the device. The product shall not

be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions.

Setting the cartridge mode

The phono amplifier can be used in either MM (for moving magnet and high-output MC cartridges) or MC (for

low-output MC cartridges) mode according to the construction principle of the pickup cartridge to be used.

Since most cartridges use the MM principle the phono amplifier is factory set to operate in this mode. To find

out which type your cartridge is please consult the literature accompanying your cartridge. If in doubt please

consult your dealer.

A switch at the back sets the correct level of amplification for the cartridge.

Before setting MM / MC mode the unit must be disconnected from the power supply and amplifier.

Connectors

Make all connections whilst the phono amplifier is disconnected from the power supply.

Take care to connect the left and right channels correctly. The right channel is usually marked red, the

left channel black or white.

Do not connect the phono amplifiers output to a phono input (sometimes labelled gram, disc or RIAA)

on the amplifier.

Never use any other power supply than the one supplied with the unit.

Connecting the record player

Connect the tonearm signal lead to the In of the phono amplifier. The earthing wire may be connected to the

screw terminal if you encounter hum problems when using the record player.

Connection to the amplifier

Connect the Out of the phono amplifier to a line input (such as AUX, CD, Tuner, Tape or Video) on your

amplifier.

Mains power connection

Connect the low voltage plug from the power supply to the Power 18V DC socket of the phono amplifier

before connecting the power supply to the mains.

Connecting to a Computer

Connect the USB-output of the unit to a free USB-socket on your computer and turn it on/make sure it is

powered on.

The “new hardware found assistant“will automatically detect the unit and announces it as a Microphone USB

audio codec. There is no need to install a driver manually.

After installation, one setting has to be done. For example - Windows 7®operating system:

Control Panel Sound Recording Microphone USB Audio CODEC Properties 

Advanced: Set to 2 channels, 16 bit, 48000 Hz (DVD Quality)

Please note: Connection should be made to an USB-socket of your computer directly. Connecting to

USB-hubs or switches can cause problems.

Recording Programme

In case you do not have a recording programme installed on your computer, you may download one free from

the Internet. Recording programmes may be found by searching Google or Yahoo.

In the menu of the recording programme, source or input may have to be set to Microphone USB audio codec.

Please be aware that downloads from the Internet are made entirely at your own risk. Under no

circumstances can we carry responsibility or provide support for third-party software products sourced

from the internet or for any damage or problems arising from the use thereof. All downloads should

be checked with an up-to-date anti-virus programme. License fees may be applicable.

Technical specifications Pro-Ject Record Box E

ATypical for low output MC cartridges, Btypical for MM or high output MC cartridges

Input capacitance/input impedance, MC: 100ohms/120pF A

Input capacitance/input impedance, MM: 47kohms/120pF B

Gain, MM /MC: 40dB / 60dB

Output voltage typically: 300mV/1kHz at 3mV/1kHz (MM) OR 0,3mV/1kHz (MC)

Max. output 9,5V (1kHz)

Noise floor, MM / MC: 94dB (A weighted) / 75dB (A weighted)

THD, MM / MC: <0,01% / <0,05%

RIAA-equalisation curve accuracy: 20Hz - 20kHz / max. 0,5dB

A/D converter: Burr Brown PCM2904 16-Bit Delta Sigma

Sampling rates: 32, 44,1 and 48kHz

USB output: 5 pin mini b connector (USB cable supplied)

USB signal: digital serial data protocol USB 1.1

Operating systems: Windows XP®, Windows Vista®, Windows 7®, Windows 8®, Mac OS

Input / Line output: 1 pair RCA/Cinch sockets / 1 pair RCA/Cinch sockets

Outboard power supply: 18V/500mA DC, suitable for your country's mains supply

Power consumption: 100mA DC

Dimensions W x H x D (D with sockets): 120 x 32 x 100 (115) mm

Weight: 250g without power supply

Potential incorrect use and fault conditions

No signal on one or both channels:

No connection between player and phono amplifier or amplifier. This could be due to a faulty plug,

broken wire or solder joint or simply loose plug/socket connection.

Strong hum:

No earth connection from cartridge or arm, or arm cable to phono amplifier, or earth loop.

Output too quiet or too loud, or distorted:

MM / MC mode incorrectly set - input overloading or insufficiently amplified.

Service

Should you encounter a problem which you are not able to alleviate or identify despite the above information,

please contact your dealer for further advice. Only if the problem cannot be resolved there, the unit should

be sent to the responsible distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions

for use. Modification or changes to any part of the product by unauthorized persons release the

manufacturer from any liability over and above the lawful rights of the customer.

Pro-Ject Audio Systems is a registered Trademark of H.

Lichtenegger.

This guide was produced by: Pro-Ject Audio Systems

The information was correct at the time of going to

press. The manufacturer reserves the right to make

changes to the technical specification without prior

notice as deemed necessary to uphold the ongoing

process of technical development.

Windows XP®, Windows Vista®, Windows 7®, Windows 8®are trademarks of the Microsoft group of companies.

Mac and Mac OS are trademarks of Apple Inc., registered in the U.S. and other countries.

Tabla de contenidos

Otros manuales de Amplificador de Pro-Ject Audio Systems

Pro-Ject Audio Systems

Pro-Ject Audio Systems AMP BOX DS Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Phono Box SE II Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Tube Box DS Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Tube Box II Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Box SE Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems MaiA Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Box S USB Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Box RS Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Tube Box SE II Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Amp Box Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Remote Box S2 Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Tube Box DS2 Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pre Box SE Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pre Box DS2 Analogue Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Box S USB Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Stereo Box Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Tube Box DS Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pre Box S Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems power box ds Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pre Box S2 Digital Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems BOX-DESIGN Stereo Box DS2 Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pre Box S2 Analogue Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Box Design Pre Box DS Manual de usuario

Pro-Ject Audio Systems

Pro-Ject Audio Systems Record Box USB Manual de usuario

Manuales populares de Amplificador de otras marcas

ASTRO

ASTRO HVO V40 P Manual de usuario

Marantz

Marantz SUPERSCOPE BLA-545 Instrucciones de montaje

NAD

NAD CI980 Manual de usuario

Technics

Technics SE-CH770 Manual de usuario

Harman Kardon

Harman Kardon HK6300 Manual de usuario

NAD

NAD T975 Manual de usuario

McIntosh

McIntosh MA6850 Manual de usuario

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Manual de usuario

Viatron

Viatron Autrix Manual de usuario

GME

GME GA9800 Manual de usuario

Atlas

Atlas CP700 Manual de usuario

Roland

Roland KC-1000 Manual de usuario

Pyle

Pyle PFMRA350BW Manual de usuario

Advantage

Advantage S-250 Manual de usuario

IRT Electronics

IRT Electronics DVA-3007 Manual de usuario

Dimavery

Dimavery BA-100 Series Manual de usuario

Sony

Sony XM-S400D Manual de usuario

Schertler

Schertler ROY X Manual de usuario