ENGLISH
EASY-PAD
ISEASY-PADA5EU_12_14
9
Delete all User Codes, Restore Default Settings
Access the programming mode, then:
Press “*” and “8” (theindicator will flash green), and press “8” twice, (a sequence of short beeps will be
heard, ending in a continuous beep, and the indicator will turn green), indicating that all user codes have
been deleted successfully;
Press “*” and “8” (the indicator will flash green), and press “9” twice, (a continuous beep will be heard and
the indicator will turn green), indicating that the default settings have been restored successfully.
Press “#” to exit the setting menu.
If inappropriate data is entered, 2 beeps will sound. The device will automatically return to the previous
settings if nothing happens for 30 seconds while the beeps are heard. If you are not in the setting mode
and enter an incomplete number, the device will automatically return to the previous settings if nothing
happens for 5 seconds while the beeps are heard.
When the relay ZONE 1 is activated, the door indicator will light up green.
When the relay ZONE 2 is activated, the door indicator will light up red.
If you forget the admin code, press and hold “#”, then turn the device on. A beep will sound, indicating
that the default admin codes have been restored successfully.
Digit length is 2->default admin code is 12,
Digit length is 3->default admin code is 123,
Digit length is 4->default admin code is 1234,
Digit length is 5->default admin code is 12345,
Digit length is 6->default admin code is 123456 (up to 6).
Edit the Administrator Code
Access the programming mode, then:
Press “*” and “3”: the indicator will flash green, then enter a new administrator code twice (the length of
the new admin code must be the same as the previous code) and a beep will be heard, indicating that the
change was performed successfully.
Press “#” to exit the setting menu.
The Pickproof Alarm
The built-in buzzer will send a continuous beep if the photo-resistant sensor is directly exposed to light.
The buzzer will automatically turn off within 60 seconds if no light is detected or if the admin code is
entered.
Turn on/off the Pickproof Alarm
Access the programming mode, then:
Press “*” and “6” (the indicator will flash green), then press “0” and “1”. A long beep will be heard whilst
the indicator turns green; indicating that the pickproof alarm is being turned off.
Press “*” and “6” (the indicator will flash green), then press “0” and “2”. A long beep will be heard whilst
the indicator turns green, indicating that the pickproof alarm is being turned on.
Press “#” to exit the setting menu.
Turn on/off the Door Bell
Access the programming mode:
