Polygroup TG76M2X88L03 Manual de usuario

Christmas Tree

Model: TG76M2X88L03

Sku # 1003 143 820

Pre-AssemblyPre-Assembly

Package Contents

Part Description Quantity

A Tree top 1

B Tree center, Sticker 2 1

C Tree center, Sticker 1 1

D Tree stand 1

E Remote Controller 1

Safety Information

IMPORTANT SAFETY

INSTRUCTIONS

a. READ AND FOLLOW ALL

SAFETY INSTRUCTIONS.

When using electrical products, basic precautions should

always be followed, including the following:

b. Do not use seasonal products outdoors unless marked

suitable for indoor and outdoor use. When products areused

in outdoor applications, connect the product to a Ground

Fault Circuit Interrupting (GFCI) outlet. If one is not provided,

contact a qualified electrician for properinstallation.

c. This seasonal product is not intended for permanent

installation or use.

d. Do not mount or place the product near gas or electric

heaters, fireplaces, candles, or other similar sources of heat.

e. Do not secure the wiring of the product with staples or nails,

or place on sharp hooks or nails.

f. Do not let lamps rest on the supply cord or on any wire.

g. Unplug the product when leaving the house, when retiring

for the night, or if left unattended.

h. This is an electric product and not a toy! To avoid risk of fire,

burns, personal injury and electric shock it should not be

played with or placed where small children can reach it.

i. Do not use this product for other than its intended use.

j. Do not hang ornaments or other objects from cord, wire, or

light string.

k. Do not close doors or windows on the product or extension

cords, as this may damage the wire insulation.

l. Do not cover the product with cloth, paper, or any material

that is not a part of the product when in use.

m. Read and follow all instructions that are on the product or

provided with the product.

n. Risk of fire. This product does not contain lamp shunts, which

allow the product to operate if one lamp burns out. Lamps

are non-replaceable..

o. To reduce the risk of fire or electric shock, do not attempt

to replace lamps or modify string.

SAVE THESE INSTRUCTIONS.

Assembly

Step 1. Before you start to assemble your tree, choose an

appropriate location near a wall outlet.

Step 2. Assemble the tree stand and place on a level surface.

(See Fig. A)

Insert Section 1 into the tree stand.

Section 1

Tree top

Section 2

Remove tree stand and tree sections

from box.

Set Up

*Electrical Rating For The Tree

(For Indoor Use Only)

Input: 120V, 60Hz, 0.35A Max.

Output: 29V 0.69A

Tree top

Section 2

Section 1

Do Not Tamper

Internal Parts

Open the

protective

cover

Do Not Tamper

Internal Parts

Open the

protective

cover

Control Box

Step 3. Each tree section is numbered with a Sticker. Please

identify all sections before assembling.

Step 4. Assemble the tree from bottom to the top. Start with the

bottom section and remove the protective cap before

inserting into the assembled stand. Make sure the pole is

firmly inserted and secured into the stand.

Fig. B - Tree and Light Assembly

Fig. A - Tree Stand Assembly

Unfold the legs and lay the stand in a flat area.Then slide the locking

disc downward and snap into place.

Insert

Adapter Into

Wall Outlet

Foot Pedal

on/off Switch

Christmas Tree

Model: TG76M2X88L03

Sku #1003 143 820

Deploy and shape the Section 1.

Remove the protective cap of Section

1 and add Section 2.

Deploy the Section 2 like Step 3.

Remove the protective cap of Section

2 and add Tree top.

Step 5. Allow branches to fall into place or gently pull up and out.

When adjusting branches, be sure that all wires pressing

the foot switch button are free of branch hinges.

Step 6. plug the adapter into the wall outlet. Tread the button on

Foot Pedal Switch then push power button on Remote

Controller or control box. Your entire tree should now be

lit. Select Color Selection Buttons or Modes Options on

Remote Controller to change light show effects.

Step 7. A button on the Control Box can manually operate the

light modes and color selections.

Step 8. Begin to shape the branches and tips, working from the

bottom to the top. Start with tips farthest from the pole

and fan out one to the right, one to the left, and one at

the center of the main stem. (See Fig. C)

Step 9. After shaping the entire tree following the previous step,

slightly upsweep all branch tips for a uniform look. Shift

branches to fill any gaps.Your Christmas tree is now

complete and ready to be decorated.

Top view Side view

Fig. C

Unplug extension cord from the wall outlet first and then remove

all ornaments and decorations.

Detach Tree top,and place in box

for storage.

Detach Section 2 and put it into

the box.

Fold the lower layer of Section 2 like

Step 2.

Cover the protective cap of Section 1

then fold same as Section 2.

Detach Section 1 from tree stand and

pack it into the box.

Fix the Remote Controller back onto

power cord.

Cover the protective cap of the

Section 2.

Storage Instructions

Christmas Tree

Model: TG76M2X88L03

Sku # 1002469164

Color Selection

Buttons

Power (ON/OFF)

Modes

Options

1. Press button to turn the lights ON/OFF.

2. Press color selection button for your preferred color.

3. Cycling Press button to get different light modes:

• flash

• strobe

• fade

• smooth

1. Loose the screws and detach the back cover.

2. Push the battery, and take it out alone with the arrow direction.

3. Install another new CR2025 battery.

4. Install the back cover and screws to front cover. Make sure the

screws are all tightly fastened.

5. Test the function, and see if it works.

NOTE: Air-dry Remote Controller if it gets wet.

Screw

Battery

CR2025

Front

Cover

Back

Cover

Operation Instruction Of Remote

Controller

Battery Replacement Of Remote

Controller

CAUTION:Use only power adaptor that was provided

with this product. Using a different power adaptor will damage

the lights and cause fire and electrical shock hazard.

TroubleshootingTroubleshooting

Problem Solution

The tree does

not light

Ensure that all tree sections are

plugged into each other and that the

tree is plugged into the wall. If your

tree came with a foot pedal, step on

the On/Off button.

Trouble Shooting Tips

For Pre-lit Trees, If The Tree Does Not Illuminate

1. Please check to make sure that all plugs are properly connected

and power cord is plugged into the wall outlet. (If the tree

comes with a foot pedal, try stepping on the on/off button).

2. Turning the poles gently to make sure thepole to pole-to-pole

connection is in place.

3. Check for loose connection between light string plugs and

extension cords.

4. Manually operate the button on Control box to eliminate

Remote Controller issues.

Loose Hinge Pin

1. Extra hinge pins are included for repairing the hinges. Place

the branch into the slot of the

bracket.

2. Insert a new hinge pin through

the hole and secure using the

retainer washer. (See Fig. D) Fig.D

WARNING:

SMALL PARTS, KEEP AWAY FROM CHILDREN.

2. Do not expose light set to moisture.

3. Remove batteries when not used for an extended period of

time, or when depleted.

4. Dispose of used batteries properly by following directions on

batteries.

5. Use only (CR2025) batteries for the remote controller.

6. Clean the battery contacts prior to battery installation.

7. DO NOT DISPOSE OF BATTERIES IN FIRE. BATTERIES MAY EXPLODE

OR LEAK.

Warning:

Este manual sirve para los siguientes modelos

Otros manuales de Pino artificial de Polygroup

Polygroup

Polygroup TV90M4G26C02 Manual de usuario

Polygroup

Polygroup TGC0M4907C02 Manual de usuario

Polygroup

Polygroup TGA0M3ABSC01 Manual de usuario

Polygroup

Polygroup GROW & STOW Guía del usuario

Polygroup

Polygroup TG70M3AW4C00 Manual de usuario

Polygroup

Polygroup TG76M6010X00 Manual de usuario

Polygroup

Polygroup TG46M6159C00 Manual de usuario

Polygroup

Polygroup TGC0P4766L01 Manual de usuario

Polygroup

Polygroup TV66M2U56C00 Manual de usuario

Polygroup

Polygroup TG76M4244L09 Manual de usuario

Polygroup

Polygroup TG76P4223L21 Manual de usuario

Polygroup

Polygroup TG90M2S85C06 Manual de usuario

Polygroup

Polygroup TG76P2657D30 Manual de usuario

Polygroup

Polygroup TG7600NVQC32 Manual de usuario

Polygroup

Polygroup TG70M3AHPP00 Manual de usuario

Polygroup

Polygroup Home Heritage TV50M2D31L00 Manual de usuario

Polygroup

Polygroup TG90M3APIL00 Manual de usuario

Polygroup

Polygroup TG76M5224C00 Manual de usuario

Polygroup

Polygroup TG76M3AW3M00 Manual de usuario

Polygroup

Polygroup TG46M2251D00 Manual de usuario

Polygroup

Polygroup NOMA ADVANCED 151-8410-6 Manual de usuario

Polygroup

Polygroup TG90M4D80C01 Manual de usuario

Polygroup

Polygroup TGC0P3499C16 Manual de usuario

Polygroup

Polygroup TG66FY012D00 Manual de usuario

Manuales populares de Pino artificial de otras marcas

Trim a Home

Trim a Home TY-S6-250L Manual de usuario

Sears

Sears Donner & Blitzen M44814 Manual de usuario

BETHLEHEM LIGHTING

BETHLEHEM LIGHTING 6.5’ Tinsel Tree Manual de usuario

Home Accents Holiday

Home Accents Holiday TG76P3D93L08 Manual de usuario

Costway

Costway CM23595US Manual de usuario

Home Accents Holiday

Home Accents Holiday TG76P4C15D03 Manual de usuario

Holiday Living

Holiday Living TV40EH339C01 Manual de usuario

CASARIA

CASARIA DBGB001 Manual de usuario

Alpine

Alpine CRD100L-WT Manual de usuario

Home Accents Holiday

Home Accents Holiday TG76M3W89C00 Manual de usuario

CASARIA

CASARIA 104006 Manual de usuario

Alpine

Alpine CRD111S-GN Manual de usuario

Home Accents Holiday

Home Accents Holiday 1001540584 Manual de usuario

Home Accents Holiday

Home Accents Holiday TG90P3F28D00 Manual de usuario

Williams-Sonoma

Williams-Sonoma TG46P4368L01 Manual de usuario

Trim a Home

Trim a Home 7.5 ft. Berkshire Fir Tree Manual de usuario

Home Accents Holiday

Home Accents Holiday 1004363936 Manual de usuario

Polytree

Polytree TG66EH148C17 Manual de usuario