Polycom MSR Series Manual de usuario
SOLUTION GUIDE | February 2018 | 3725-61579-002A
Polycom® MSR Series
Copyright© 2017, Polycom, Inc. All rights reserved. No part of this document may be reproduced,
translated into another language or format, or transmitted in any form or by any means, electronic or
mechanical, for any purpose, without the express written permission of Polycom, Inc.
6001 America Center Drive
San Jose, CA 95002
USA
Trademarks Polycom®, the Polycom logo and the names and marks associated with Polycom products
are trademarks and/or service marks of Polycom, Inc. and are registered and/or common law marks in the
United States and various other countries.
All other trademarks are property of their respective owners. No portion hereof may be reproduced or
transmitted in any form or by any means, for any purpose other than the recipient's personal use, without
the express written permission of Polycom.
End User License Agreement By installing, copying, or otherwise using this product, you acknowledge
that you have read, understand and agree to be bound by the terms and conditions of the End User
License Agreement for this product. The EULA for this product is available on the Polycom Support page
for the product.
Patent Information The accompanying product may be protected by one or more U.S. and foreign
patents and/or pending patent applications held by Polycom, Inc.
Open Source Software Used in this Product This product may contain open source software. You may
receive the open source software from Polycom up to three (3) years after the distribution date of the
applicable product or software at a charge not greater than the cost to Polycom of shipping or distributing
the software to you. To receive software information, as well as the open source software code used in
this product, contact Polycom by email at
Disclaimer While Polycom uses reasonable efforts to include accurate and up-to-date information in this
document, Polycom makes no warranties or representations as to its accuracy. Polycom assumes no
liability or responsibility for any typographical or other errors or omissions in the content of this document.
Limitation of Liability Polycom and/or its respective suppliers make no representations about the
suitability of the information contained in this document for any purpose. Information is provided "as is"
without warranty of any kind and is subject to change without notice. The entire risk arising out of its use
remains with the recipient. In no event shall Polycom and/or its respective suppliers be liable for any
direct, consequential, incidental, special, punitive or other damages whatsoever (including without
limitation, damages for loss of business profits, business interruption, or loss of business information),
even if Polycom has been advised of the possibility of such damages.
Customer Feedback We are striving to improve our documentation quality and we appreciate your
feedback. Email your opinions and comments to mailto:[email protected].
Polycom Support Visit the Polycom Support Center for End User License Agreements, software
downloads, product documents, product licenses, troubleshooting tips, service requests, and more.
Contents
Introduction to Polycom MSR Series............................................................... 3
Setting Up Polycom MSR Series.......................................................................4
MSR100 Bundle.................................................................................................................. 4
Set Up the MSR100 Bundle..................................................................................... 4
MSR200 Bundle.................................................................................................................. 5
Set Up the MSR200 Bundle..................................................................................... 5
Verify the Trio System Software Version..................................................................5
Update the Base Profile for the Trio System............................................................ 6
MSR300 Bundle.................................................................................................................. 6
Set Up the MSR300 Bundle..................................................................................... 6
Update the Base Profile for the Trio System............................................................ 7
Verify the Trio System Software Version..................................................................7
Update the Polycom EagleEye IV USB Camera System Software..........................8
Set the Camera Home Position................................................................................8
Move to the Camera Home Position........................................................................ 8
Waking the Polycom EagleEye IV USB Camera System.........................................8
MSR400 Bundle.................................................................................................................. 9
Set Up the MSR400 Bundle..................................................................................... 9
Update the CX5100 System Software Automatically through Control Panel......... 10
Update the CX5100 System Software through USB Drive.....................................10
MSR500 Bundle................................................................................................................ 11
Set Up the MSR500 Bundle with a Single Display................................................. 11
Set Up the MSR500 Bundle with Dual Displays.....................................................11
Update the Base Profile for the Trio System.......................................................... 12
Verify the Trio System Software Version................................................................12
Update the Polycom EagleEye IV USB Camera System Software........................13
Set the Camera Home Position..............................................................................13
Move to the Camera Home Position...................................................................... 13
Waking the Polycom EagleEye IV USB Camera System.......................................13
Upgrading System Software through Windows Update.................................................... 14
Windows Updates on MSR.................................................................................... 14
Troubleshooting............................................................................................... 15
Video Does Not Play......................................................................................................... 15
MSR Dock Does Not Detect the CX5100 System.............................................................15
Polycom, Inc. 1
Introduction to Polycom MSR Series
Polycom MSR Series delivers a familiar Microsoft Skype for Business experience in small to large
meeting rooms. Polycom MSR Series offers a complete solution that can scale from small huddle rooms
to larger conference rooms. Polycom audio and video peripherals are certified with Skype Room Systems
and support certified Skype Room System docks.
Your infrastructure will likely fall into one of the following configurations:
▪ Skype for Business Online (Office 365) with Exchange Online
▪ Skype for Business Server 2015 on-premises with Exchange Online or Exchange 2013 SP1 on-
premises/Exchange 2016 on-premises
The Polycom MSR Dock does not support Lync Server 2013 or earlier versions. The Polycom MSR Dock
supports 1080p resolution only.
Polycom, Inc. 3
Setting Up Polycom MSR Series
Topics:
▪MSR100 Bundle
▪MSR200 Bundle
▪MSR300 Bundle
▪MSR400 Bundle
▪MSR500 Bundle
▪Upgrading System Software through Windows Update
MSR100 Bundle
The MSR100 bundle includes the Polycom MSR Dock with Microsoft Surface Pro, the Polycom VoxBox,
and Logitech c930e webcam.
Set Up the MSR100 Bundle
Follow the steps below to set up the MSR100 bundle.
Procedure
1. Connect the Logitech c930e webcam USB cable to a USB port on the Polycom MSR Dock.
2. Connect the security USB cable to the Polycom VoxBox using the supplied hardware.
3. Connect a lock, if needed.
4. Connect the other end of the USB cable to the Polycom MSR Dock.
Polycom, Inc. 4
MSR200 Bundle
The MSR200 bundle includes the Polycom MSR Dock with Microsoft Surface Pro, Polycom Trio 8500,
and Logitech c930e webcam.
Note: The Trio 8500 system is supported with software versions 5.5.2 and higher. For more information
on Microsoft Skype Room Systems, refer to Microsoft Technet site.
Set Up the MSR200 Bundle
Follow the steps below to set up the MSR200 bundle.
Note: The Polycom Trio 8500 system must meet the Minimum Setup requirements. For more
information on setting up the Trio 8500 system, refer to the Polycom Support site.
Procedure
1. Connect the power adapter or PoE cable to the Polycom Trio 8500 system.
2. Connect the Micro USB cable to the Micro-B USB port on the Polycom Trio 8500 system.
3. Connect the other end of the USB cable to a USB port on the Polycom MSR Dock.
4. Connect the Logitech c930e webcam USB cable to a USB port on the Polycom MSR Dock.
Verify the Trio System Software Version
You can view the Trio system software version using the local interface, web browser or the Control Panel
application.
Procedure
1. Do one of the following:
Setting Up Polycom MSR Series
Polycom, Inc. 5
▪ On the Trio system, go to Settings > Status > System Information. Enter the IP address of
the Trio system in a web browser and enter the Admin password (the default password is
456).
The software version displays in the Home screen under UC Software Version.
▪ In the Control Panel application software, enter the administrator password and click
System Status.
Update the Base Profile for the Trio System
You can use the Trio system as an audio speakerphone by setting the Base Profile to Skype USB
Optimized.
Polycom recommends connecting the Trio system to the network while updating the base profile.
Procedure
1. Connect a USB cable from the Trio system to the MSR Dock.
2. Do one of the following:
▪ In the Trio system web interface, go to Simple Setup > Base Profile, and select Skype
USB Optimized from the list and click Save.
▪ On the Trio system, go to Setup > Advanced > Administrative Settings > Network
Configurations > Base Profile and select Skype USB Optimized.
MSR300 Bundle
The MSR300 bundle includes the Polycom MSR Dock with Microsoft Surface Pro, Polycom Trio 8800,
and Polycom EagleEye IV USB camera.
Note: The Trio 8800 system is supported with software versions 5.5.3 and higher. The Polycom
EagleEye IV USB camera is supported with software versions 1.1 and higher. For more
information on Microsoft Skype Room Systems, refer to Microsoft Technet site.
Set Up the MSR300 Bundle
Follow the steps below to set up the MSR300 bundle.
Procedure
1. Connect the power adapter or PoE cable to the Polycom Trio 8800 system.
2. Connect the Micro-B USB cable to the Micro-B USB port on the Polycom Trio 8800 system.
3. Connect the other end of the USB cable to a USB port on the Polycom MSR Dock.
4. Connect the USB Type B cable to the USB Type B port on the Polycom EagleEye IV USB camera.
5. Connect the other end of the USB cable to a USB port on the Polycom MSR Dock.
6. Connect the power cable to the Polycom EagleEye IV USB camera.
Setting Up Polycom MSR Series
Polycom, Inc. 6
Update the Base Profile for the Trio System
You can use the Trio system as an audio speakerphone by setting the Base Profile to Skype USB
Optimized.
Polycom recommends connecting the Trio system to the network while updating the base profile.
Procedure
1. Connect a USB cable from the Trio system to the MSR Dock.
2. Do one of the following:
▪ In the Trio system web interface, go to Simple Setup > Base Profile, and select Skype
USB Optimized from the list and click Save.
▪ On the Trio system, go to Setup > Advanced > Administrative Settings > Network
Configurations > Base Profile and select Skype USB Optimized.
Verify the Trio System Software Version
You can view the Trio system software version using the local interface, web browser or the Control Panel
application.
Procedure
1. Do one of the following:
▪ On the Trio system, go to Settings > Status > System Information. Enter the IP address of
the Trio system in a web browser and enter the Admin password (the default password is
456).
The software version displays in the Home screen under UC Software Version.
▪ In the Control Panel application software, enter the administrator password and click
System Status.
Setting Up Polycom MSR Series
Polycom, Inc. 7
Update the Polycom EagleEye IV USB Camera System Software
You can use a USB drive to update the camera system software version. The Polycom EagleEye IV USB
camera system version 1.0.0.388 or later supports Windows Update.
Ensure the following before updating the camera system software:
▪ Use a USB drive with at least 64 MB of available space.
▪ Make sure the file system is in FAT32 format.
Note: Do not remove the USB drive during the software update process.
Procedure
1. Download the latest software image of the camera system from the MSR Series page on the
Polycom support site.
2. Copy the Polycom EagleEye IV USB camera image (polycom-MSRCam-x.x.x-xxx.tar.gz)
into the USB root directory.
3. Plug in the Polycom EagleEye IV USB camera power cable to power on and allow the camera
system to fully boot up.
4. Plug the USB drive into the Polycom EagleEye IV USB camera system.
The Polycom EagleEye IV USB camera system starts the image update and the LED blinks
amber. The Polycom EagleEye IV USB camera system automatically reboots when the image
update is complete. The camera tilts up and then down during the reboot.
5. Remove the USB drive.
Set the Camera Home Position
You may want to set a camera Home position to use as a default.
Procedure
1. Press and hold the Select button for 5 seconds until the LED light blinks green.
Move to the Camera Home Position
You may want to move to a previously set camera Home position.
Procedure
1. To move to camera Home position, press the Select button.
Waking the Polycom EagleEye IV USB Camera System
You can wake the Polycom EagleEye IV USB camera system in the following ways:
▪ Press any button on the remote control.
▪ Send the video content.
▪ Place a call.
Setting Up Polycom MSR Series
Polycom, Inc. 8
Este manual sirve para los siguientes modelos
5
Tabla de contenidos
Otros manuales de Sistema de conferencias de Polycom
Polycom
Polycom ViewStation SP128 Manual de usuario
Polycom
Polycom HDX 4000 Series Manual de usuario
Polycom
Polycom VSX 7000e Series Manual de usuario
Polycom
Polycom MGC-25 Manual de usuario
Polycom
Polycom G7500 Manual de usuario
Polycom
Polycom RMX 2000 Instrucciones de instalación
Polycom
Polycom MGC+50 ReadiConvene Manual de usuario
Polycom
Polycom PathNavigator Manual de usuario
Polycom
Polycom QSX 3725-22370-001/B Manual de servicio
Polycom
Polycom 3000 Manual de usuario
Polycom
Polycom RealPresence Group Series Instrucciones de montaje
Polycom
Polycom VSX Series Manual de servicio
Polycom
Polycom RealPresence EduCart 500 Instrucciones de uso
Polycom
Polycom picturetel 900 series Manual de usuario
Polycom
Polycom VSX 7000 Instrucciones de montaje
Polycom
Polycom ViewStation vsx7000 Manual de usuario
Polycom
Polycom RMX 2000 Manual de servicio
Polycom
Polycom RealPresence Trio 8500 Manual de usuario
Polycom
Polycom RealPresence Group Series Manual de usuario
Polycom
Polycom ViewStation EX4000, FX4000, VS4000 Manual de usuario
Manuales populares de Sistema de conferencias de otras marcas
Kramer
Kramer VIA GO Manual de usuario
AVT
AVT MAGIC AC1 Go Manual de usuario
ProSoft Technology
ProSoft Technology AN-X4-AB-DHRIO Manual de usuario
Sony
Sony PCS-I150 Manual de usuario
Middle Atlantic Products
Middle Atlantic Products VTC Series Manual de usuario
Prentke Romich Company
Prentke Romich Company Vanguard Plus Guía
