point POPANW400 Manual de usuario
POPANW400/ POPANW600 /
POPANW800/ POPANW800B/
POPANW1000/POPANW1000B
User Manual
POLISW800/POLISW1000
User Manual
Thank you for purchasing your new POINT SERIES Panel Heater. These
operating instructions will help you use it properly and safely. We
recommend that you spend some time reading this instruction manual
in order that vou fully understand all the operational features it oers.
Read all the safety instructions carefully before use and keep this
instruction manual for future reference.
Kiitos, kun valitsit uuden POINT-paneelilämmittimen. Nämä
käyttöohjeet opastavat sinua käyttämään laitetta oikein ja
turvallisesti. Suosittelemme, että käytät hieman aikaa tämän
käyttöoppaan lukemiseen, jotta ymmärrät täysin, millaisia toimintoja
laitteessa on. Lue kaikki turvallisuusohjeet huolellisesti ennen laitteen
käyttöä ja säilytä käyttöopas myöhempää tarvetta varten.
POINT SERIES panelovn
POINT-SERIENS Panelvarmer
Panelvärmare i POINT-SERIEN
Instruction Manual - English
Bruksanvisning - Norsk
Brugervejledning - Dansk
Bruksanvisning - Svenska
page
side
side
side
4 - 22
3
23 - 41
42 - 60
61 - 79
80 - 98
4
SAFETY INSTRUCTIONS
Warning: In order to avoid overheating, do not
cover the heater.
Do not use the appliance in areas where flammable
liquids are stored or where flammable fumes may be
present.
This appliance can be used by children 8 years and
older and persons with reduced physical, sensory or
mental capabilities or lack of experience and
knowledge if they are supervised or instructed on the
safe use of the appliance and understand the risks
involved.
Children younger than 3 years should be kept away
unless continuously supervised.
Children aged from 3 to 8 years are allowed only to
switch on/o the appliance provided that it has been
placed or installed in its intended normal operating
position and they are supervised or instructed on the
safe use of the appliance and understand the risks
involved. Children aged from 3 to 8 years are not to
plug in, regulate and clean the appliance or perform
user maintenance.
Children should be supervised to ensure that they do
not play with the appliance.
Do not use this appliance if it has been dropped.
If the mains cable is damaged, it must be replaced by
the manufacturer or its service agent or similarly
qualified person in order to avoid a hazard.
1.
2.
3.
4.
5.
6.
7.
8.
Do not use the appliance if there are visible signs of
damage.
Ensure that your power supply voltage matches
the appliance’s rating label.
Use the appliance on a horizontal and stable surface,
or fix it to the wall, as applicable.
WARNING: Do not use this heater in small rooms
when they are occupied by persons not capable of
leaving the room on their own, unless constant
supervision is provided.
WARNING: To reduce the risk of fire, keep textiles,
curtains, or any other flammable material a minimum
distance of 1 m from the air outlet.
WARNING: this appliance should be installed so that
the bottom of the heater is at least 50 mm above the
floor.
Statement: The appliance is not to be placed
immediately below a socket-outlet.
Always turn o and unplug the appliance when not in
use.
Always unplug the appliance and ensure the
appliance is completely cold before moving, cleaning,
or storing it.
When using this appliance – plug directly into the
wall socket and not via extension cables or other
adaptors as this may cause an overload.
CAUTION — Some parts of this appliance can become
very hot and cause burns. Particular attention has to
be given where children and vulnerable people are
present.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
5
6
PRODUCT OVERVIEW
1.Body
2.Switch
3.Control panel
4.Wall bracket
5.Wall-mounting kits
Description
Screw 4
4Plastic plug
Drawing QTY
123 4
INSTALLATION
185mm 130mmA
B
Min.50mm Min.50mm
Min.50mm Min.50mm
Min.568mm
81mm
Min.175mm
Min.150mm
160mm
368mm Min.150mm
368mm
Model no. Watt A B
POPANW400 150mm 465mm
210mm 525mm
330mm 645mm
420mm
400W
600W
800W
1000W 735mm
POPANW600
POPANW800/POPANW800B
POPANW1000/POPANW1000B
5
7
Fig.1
Fig.2
Model no. Watt A B
POLISW800 490mm 1035mm
670mm 1215mm
800W
1000WPOLISW1000
160mm
A
Fig.3
Min.50mm Min.50mm
250mm Min.150mm
Min.50mm
B
Min.50mm
81mm
250mm
Min.450mm
Min.150mm
Min.140mm
70mm
185mm A265mm
8
To hang the heater on the wall:
Use
CONTROL PANEL
Choose a suitable installation location for the heater. Follow the
minimum distances in all directions (Fig 1). Disassemble the wall bracket
by loosening the screw (not screw o, only loosen) and sliding the metal
pieces out of the hole. Take out the bracket by pulling it down.
Verify that the bracket is perfectly horizontal with a spirit level and mark
the location of holes on the wall. Drill holes in the wall for the pegs with a
suitable drill bit. Insert the pegs into the holes, then screw the wall
mount bracket securely onto the wall (Fig 2).
Place the heater against the bracket. Fix the heater on the 2 downwards
hooks. Pull the heater upwards whilst keeping it in the 2 lower hooks. Fix
the heater on the 2 upwards hooks. Pull the heater down. Slide the 2
metal pieces on top into the hole, and fasten the screws to lock the wall
mount bracket (Fig 3).
1.
2.
3.
Touch icon
/
Function
set the temperature, from 5°C to 35°C, increase/decrease by 1°C
each step.
shift modes (Manual, P1, P2, P3, P4, OF) or confirm.
enter setting menu or to cancel.
9
OPERATION
The first time you plug in, press the on/o switch, the appliance will
show 19°C at manual mode as factory default setting.
Pressing the button will switch the device on or o
If the button is in the down position, the device is on (1).
If the button is in the up position, the device is o (0).
1.
When the temperature of the environment is below the set temperature,
the heater will start to heat the room, otherwise, no.
The heating indicator icon will light on only when the product is heating up.
Temperature adjustment:
Press “+” or “–” to set temperature. Min. setting is 5°C, Max. is 35°C.
Pressing and holding “+” or “–” makes the adjustment faster.
In the event of a power failure, the heater will resume to work under the
same mode and set temperature after the power is resumed.
Short press OK to shift among the following modes: manual ( ), P1, P2,
P3, P4, OF. (After flashing 5 seconds, the display will show set
temperature.)
Manual: the display will show , press “+” or “-” to select the
temperature manually.
P1-P4 mode: the default programs are as below. Among them, P1 to P3
are fixed pre-set programs while P4 is a free weekly personalized
program.
OF mode: the display show OF. During this mode, the appliance doesn’t
heat up but clock settings are maintained.
2.
3.
Power
switch
Time setting
10
Short press or keep pressing the “+” / “-” icon to change the set tempera-
ture. Short press “+” / “-” to adjust the temperature, 1°C each step, the
temperature range is from 5 to 35°C. Keep “+” / “-” pressed to increase/-
decrease the temperature quickly.
Setting menu
Short press “M” icon to enter or exit the setting menu.
The setting menu can be used to show the function list of the appliance:
td: time setting
Pr: P4 (free weekly personalized program)
C: temperature calibration
LI: adjustment of screen brightness
AS: adaptive start function
Press “+” or “-” to select from td (time setting), Pr (P4 free weekly
personalized program), C (temperature calibration), LI (adjustment of screen
brightness).
The selected icon will flash.
Press “M” to select “td”, and short press “OK” to enter time setting interface.
Press “+” / “-” to set the day of week (choose from d1 to d7). Then press “OK”
to save and enter hour setting.
Press “+” / “-” to set the hour (choose from 0 to 23). Then press “OK” to save
and enter minute setting.
Press “+” / “-” to set the minute (choose from 00 to 59). Then press “OK” to
save and go back to the previous working mode and temperature.
You cannot make any other adjustments before setting the day/time.
4.
5.
Weekly
modes
Time and
program
setting
P1 (5-2)
P2 (6-1)
P3 (7-0)
P4 (0-7)
Saturday-Sunday
Sunday
Monday-Sunday
Monday-Friday
Monday-Saturday
Event 2 heating cycles4 heating cycles
Time
period
Factory
setting
Comfort ComfortEco Eco Comfort Eco
21°C 17°C 21°C 17°C 21°C 17°C
Time 6:00-9:00 16:00-23:009:00-16:00 23:00-6:00 7:00-23:00 23:00-7:00
Monday-Sunday
Otros manuales para POPANW400
1
Este manual sirve para los siguientes modelos
7
Tabla de contenidos
Idiomas:
Otros manuales de Calentador de point
Manuales populares de Calentador de otras marcas
Empire Heating Systems
Empire Heating Systems WCC65 Manual de usuario
Wetekom
Wetekom 92 86 43 Manual de usuario
Desa
Desa SPC170-F Manual de usuario
Watlow
Watlow Watrod Electric Tubular Heaters Manual de usuario
Haverland
Haverland ECO-DRY GPS Series Manual de lista de piezas
Stelpro
Stelpro ASILVC2060 Series Manual de usuario